Some hydrophysical and hydrochemical parameters of the upper part of the hydrogen sulfide zone in the Black Sea, September 11-22, 1994

Features of spatial variability of hydrogen sulfide in the northeastern part of the Black Sea are estimated. Some technical aspects of H2S concentration determination in the anoxic zone are discussed: in its upper part at H2S concentration <30 µmol/l, the photometric method is recommended, while for deeper layers the iodometric method should be used. With linearity of vertical distribution of hydrogen sulfide and ammonium taken into account their vertical gradients are estimated as 0.49+/-0.04 µmol/m and 0.19+/-0.06 µmol/m respectively. It is shown that the upper boundary of the H2S layer corresponds to the isopycnal surface with Sigma_t = 16.19+/-0.05 arbitrary units. Special attention is paid to relationship of hydrogen sulfide distribution with hydrophysical features in the region under study, in particular in the coastal zone. It is shown that hydrodynamic conditions control spatial distribution of hydrogen sulfide. On the basis of isopycnal treatment of the H2S field existence of a coastal convergence zone is proved, and peculiarities are recognized of vertical circulation in the main Black Sea gyre and coastal anticyclonic eddies; here hydrogen sulfide serves as a tracer of hydrophysical mixing processes.

Biostratigraphic significance of the calcareous nannofossil genus Reticulofenestra in the Upper Pliocene of the North Atlantic

We demonstrate size fluctuations of the calcareous nannofossil genus Reticulofenestra in Upper Pliocene sediments from the North Atlantic Ocean and clarify a characteristic evolutionary trend of this genus. Four bioevents, which are based on abrupt decreases in maximum size and on changes of morphologic features of Reticulofenestra specimens, are detected in the sediments. They are the disappearance of R. minutula var. A, the termination of Acme Zone II of R. minutula var. C, the disappearance of R. minutula var. B, and the termination of Acme Zone I of R. minutula var. C, in ascending order. These are nearly synchronous and traceable events.

Temperature and d18O measurements from different ODP Sites at the shelf and upper slope of the Peru Margin

The first experimentally determined temperature dependent oxygen-18 fractionation factor between dolomite and water at low temperatures [Vasconcelos et al. 1995 doi:10.1130/G20992.1] allows now the precise calculation of temperatures during early diagenetic dolomite precipitation. We use d18O values of early diagenetic dolomite beds sampled during ODP Legs 112 and 201 on the Peru continental margin (Sites 1227, 1228 and 1229) [Meister et al. 2007, doi:10.1111/j.1365-3091.2007.00870.x] to calculate paleo-porewater temperatures at the time of dolomite precipitation. We assumed unaltered seawater d18O values in the porewater, which is supported by d18O values of the modern porewater presented in this study. The dolomite layers in the Pleistocene part of the sedimentary columns showed oxygen isotope temperatures up to 5 °C lower than today. Since Sites 1228 and 1229 are located at 150 and 250 m below sealevel, respectively, their paleo-porewater temperatures would be influenced by considerably colder surface water during glacial sealevel lowstands. Thus, Pleistocene dolomite layers in the Peru Continental margin probably formed during glacial times. This finding is consistent with a model for dolomite precipitation in the Peru Margin recently discussed by Meister et al. [Meister et al. 2007, doi:10.1111/j.1365-3091.2007.00870.x], where dolomite forms episodically at the sulphate methane interface. It was shown that the sulphate methane interface migrates upwards and downwards within the sedimentary column, but dolomite layers may only form when the sulphate-methane interface stays at a fixed depth for a sufficient amount of time. We hypothesize that the sulphate-methane interface persists within TOC-rich interglacial sediments, while this zone is buried by TOC-poor sedimentation during glacial times. Thus, the presented oxygen isotope data provide additional information on the timing of early diagenetic dolomite formation and a possible link between episodicity in dolomite formation and sealevel variations. A similar link between early diagenesis and oceanography may also explain spacing of dolomite layers in a Milankovitch type pattern observed in the geological record, such as in the Miocene Monterey Formation.

Oxygen isotope concentrations of minerals from the upper kilometer of the ocean crust, DSDP Hole 504B

DSDP Hole 504B is the deepest basement hole in the oceanic crust, penetrating through a 571.5 m pillow section, a 209 m lithologic transition zone, and 295 m into a sheeted dike complex. An oxygen isotopic profile through the upper crust at Site 504 is similar to that in many ophiolite complexes, where the extrusive section is enriched in 18O relative to unaltered basalts, and the dike section is variably depleted and enriched. Basalts in the pillow section at Site 504 have delta 18O values generally ranging from +6.1 to +8.5? SMOW (mean= +7.0?), although minor zeolite-rich samples range up to 12.7?. Rocks depleted in 18O appear abruptly at 624 m sub-basement in the lithologic transition from 100% pillows to 100% dikes, coinciding with the appearance of greenschist facies minerals in the rocks. Whole-rock values range to as low as +3.6?, but the mean values for the lithologic transition zone and dike section are +5.8 and +5.4?, respectively. Oxygen and carbon isotopic data for secondary vein minerals combined with the whole rock data provide evidence for the former presence of two distinct circulation systems separated by a relatively sharp boundary at the top of the lithologic transition zone. The pillow section reacted with seawater at low temperatures (near 0°C up to a maximum of around 150°C) and relatively high water/rock mass ratios (10-100); water/rock ratios were greater and conditions were more oxidizing during submarine weathering of the uppermost 320 m than deeper in the pillow section. The transition zone and dikes were altered at much higher temperatures (up to about 350°C) and generally low water/rock mass ratios (~1), and hydrothermal fluids probably contained mantle-derived CO2. Mixing of axial hydrothermal fluids upwelling through the dike section with cooler seawater circulating in the overlying pillow section resulted in a steep temperature gradient (~2.5°C/m) across a 70 m interval at the top of the lithologic transition zone. Progressive reaction during axial hydrothermal metamorphism and later off-axis alteration led to the formation of albite- and Ca-zeolite-rich alteration halos around fractures. This enhanced the effects of cooling and 18O enrichment of fluids, resulting in local increases in delta 18O of rocks which had been previously depleted in 18O during prior axial metamorphism.