Geochemistry on ferromanganese crusts and nodules from Green Bay, Lake Michigan

The differential solubility of ferromanganese oxides can lead to stratigraphic separation of iron and manganese. Results of chemical analysis of a sequence of ferromanganese nodules overlying iron-rich crusts in northern Green Bay show that selec¬tive ion transport is important in concentrating manganese and associated trace elements near the oxygenated water-sediment interface. Manganese carbonate, which cements ferromanganese nodules, occurs in dark-gray silty sands that are located adjacent to the organic-rich muds of southern Green Bay. These muds contain an average of approximately 3.5 ppm (6x10-5M) interstitial Mn with 2.8 meq/l carbonate alkalinity. Thermodynamic calculation shows that interstitial water approaches equilibrium with MnCO3 in the upper 10 cm of sediment. This carbonate has a composition (Mn73Ca22Fe5)CO3 and has been identified as rhodochrosite.

Isotope analysis, age calculation and calcite concentration from IODP Hole 310-M0005D

We present uranium-thoriumchronology for a 102 mcore through a Pleistocene reef at Tahiti (French Polynesia) sampled during IODP Expedition 310 "Tahiti Sea Level". We employ total and partial dissolution procedures on the older coral samples to investigate the diagenetic overprint of the uranium-thoriumsystem. Although alteration of the U-Th system cannot be robustly corrected, diagenetic trends in the U-Th data, combined with sea level and subsidence constraints for the growth of the corals enables the age of critical samples to be constrained to marine isotope stage 9. We use the ages of the corals, together with d18O based sea-level histories, to provide maximum constraints on possible paleo water-depths. These depth constraints are then compared to independent depth estimates based on algal and foraminiferal assemblages, microbioerosion patterns, and sedimentary facies, confirming the accuracy of these paleo water-depth estimates. We also use the fact that corals could not have grown above sea level to place amaximumconstraint on the subsidence rate of Tahiti to be 0.39 m ka**-1,with the most likely rate being close to the existing minimum estimate of 0.25m ka**-1.

Boron isotopes, pH and pCO2 calculation for one Fiji coral specimen Porites (1898-1998), 2012

delta11B results and deduced pH, pCO2 and omega values obtained for a tropical coral specimen Porites collected in 1998 at Yasawa (16°48'S- 177°27'E) on the western side of the Fiji archipelago, location in the north western part of the Pacific Warm Pool. Such Porites specimen grew during the XXth century (1898-1998). Boron isotopes results allowed the reconstruction of surface ocean acidification in the vincinity of Fiji Islands with strong interdecadal influence of the ENSO at regional scale. pHT calculation parameters (Hönisch et al., 2007): a=0 PER MIL; alpha=0.9804; delta11B=39.5 PER MIL; salinity=35.02; pKB from Dickson (1990). pCO2 and omega calculation parameters: TA= 2350 µM; Ca= 10.2 mM; Dickson et al.(2007); Mucci 1983.

CIPWFULL: A FORTRAN Program for Calculation of Comprehensive CIPW Norms of Igneous Rocks

CIPWFULL is a user-friendly, stand-alone FORTRAN software program that is designed to calculate the comprehensive CIPW normative mineral composition of igneous rocks and strictly adheres to the original formulation of the CIPW protocol. This faithful adherence alleviates inaccuracies in normative mineral calculations by programs commonly used by petrologists. Additionally, several of the most important petrological and mineralogical parameters of igneous rocks are calculated by the program. Along with all the regular major oxide elements, all the significant minor elements whose contents can potentially effect the CIPW normative mineral composition are included. CIPWFULL also calculates oxidation ratios for igneous rock samples that have only one oxidation state of iron reported in the specimen analysis. It also provides an option for normalization of analyses to unity on a hydrous-free basis in order to facilitate comparison of norms among rock groups. Other capabilities of the program cater for rare situations, like the presence of cancrinite or exclusion from the norm calculation of rare rocks like carbonatite. Several mineralogical, petrological and discriminatory parameters and indexes are additionally calculated by the CIPWFULL program. The CIPWFULL program is very efficient and flexible and allows for a user-defined free-format input of all the chemical species, and it permits feeding of minor elements as parts per million or oxide percentages. Results of calculations are printed in a formatted ASCII text file and may be optionally casted into a space-delimited text files that are ready to be imported to general spreadsheet programs. CIPWFULL is DOS-based and is implemented on WINDOWS and mainframe platforms.

Sea surafe temperture calculation for the Arabian Sea

Sea surface temperature (SST) and seawater d18O (d18Ow) were reconstructed in a suite of sediment cores from throughout the Arabian Sea for four distinct time intervals (0 ka, 8 ka, 15 ka, and 20 ka) with the aim of understanding the history of the Indian Monsoon and the climate of the Arabian Sea region. This was accomplished through the use of paired Mg/Ca and d18O measurements of the planktonic foraminifer Globigerinoides ruber. By analyzing basin-wide changes and changes in cross-basinal gradients, we assess both monsoonal and regional-scale climate changes. SST was colder than present for the majority of sites within all three paleotime slices. Furthermore, both the Indian Monsoon and the regional Arabian Sea mean climate have varied substantially over the past 20 kyr. The 20 ka and 15 ka time slices exhibit average negative temperature anomalies of 2.5°-3.5°C attributable, in part, to the influences of glacial atmospheric CO2 concentrations and large continental ice sheets. The elimination of the cross-basinal SST gradient during these two time slices likely reflects a decrease in summer monsoon and an increase in winter monsoon strength. Changes in d18Ow that are smaller than the d18O signal due to global ice volume reflect decreased evaporation and increased winter monsoon mixing. SSTs throughout the Arabian Sea were still cooler than present by an average of 1.4°C in the 8 ka time slice. These cool SSTs, along with lower d18Ow throughout the basin, are attributed to stronger than modern summer and winter monsoons and increased runoff and precipitation. The results of this study underscore the importance of taking a spatial approach to the reconstruction of processes such as monsoon upwelling.

Climate reconstructions from the Tibet Plateau (PKDB286426)

Fluid inclusions of protogenous halite, which were collected from two boreholes in the Charhan Salt Lake in the north part of the Qinghai-Xizang Plateau, werea nalyzed for their hydrogen and oxygen isotopes and for their Na, Mg etc. ions.On these grounds, the evolution of lake environment in this region during the last 50 000 years are discussed in this paper. The emphasis is to discuss the time range of extremely arid and cold climate at the last Glacial stage and the geological event of playa associated with such a climate.The guanidine hydrochloride method was used for measurement of hydrogen and oxygen stable isotopes. The measurement of Na, Mg etc. ions were achieved by determination of crystallization temperature of hydrohalite under microscope and then by calculation of chemical compositions of inclusion fluid using a thermodynamic model.The results obtained show that protogenous halite in the Charhan Lake area was formed in three different environment conditions: (1) In fluid inclusions of halite formed in the early period (50 000-30 000 a B. P. ), dD averages -14.9 per mil, d(18)O averages 8.37 per mil, and Mg(2+)ranges from 0.42 to 1.59 mol/L. Their plotting points fall on the right top part of the evaporation line of the present Charhan Lake area, indicating that the Lake water at that time had a higher concentration of brine, and the climate was hot and dry. (2) In fluid inclusions of halite formed in the middle period (30 000-15 000 a B. P.), SD average -66.0 per mil, d(18)O averages 1.00 pr mil, and Mg(2+) 1 mol/L. Their plotting points fall on the left low part of the evaporation line, indicating that the lake water at that time had a concentration of brine lower than that in the early period, and the environment was cold and dry. (3) In fluid inclusions of halite formed in the late period (15 000-present), dD averages 30.8 per mil, d(18)O averages 5.85 per mil, and Mg(2+) M 1 mol/L. Their plotting fall on the evaporation line, indicating that the climate environment at that time was warm and dry, almost the same as the present.The temperature variation of the last 50 000 years in the Charhan Lake area was calculated using the conversion equation proposed by Lorious et al. The time range of the Great ice age of the Last Glacial Stage is about 21 000-15 000 a B.P., which basically coincides with the time of a worldwide low sea level. The temperature in that period was below 0°C and 6-7°C lower than now. Because of lower temperatures, water supply to the lake area decreased rapidly and the concentration of lake water increased sharply. Therefore the Mg(2+) concentration in inclusion fluid reaches or closes to 2mol/L and the Mg/Na ratio varies within a very wide range. These show that the Charhan Lake at that time entered its playa stage. The Charhan Salt Lake is a typical one in the north part of the Qinghai-Xizang Plateau. It can be supposed that the extremely arid and cold climate of the Great Ice Age made most lakes in the north part of the Qinghai-Xizang Plateau enter their playa stage. This event is of importance for formation of salt resources.

Boron isotopes, trace elements and pH calculation for Norwegian deep sea coral specimen Madrepora o. (1968-2007), 2012

d11B and trace results obtained for a deep sea coral specimen Madrepora oculata collected from the Norwegian Sea (67°N, 9°E, 340 m) during the RV Polarstern ARK/II/Ia cruise (2007). Such coral specimen grew during the last four decades (1968-2007) and geochemical results highligh a seawater pH decrease with an order of magnitude in good agreement with an ocean acidification rate today known. This pH record is strongly impacted by inter-decadal change of ocean dynamic (NAO) and productivity. pHT calculation parameters (Hönisch et al., 2007): a=5; a=0.9804, d11B=39.5 PER MIL, Li/Mg temperature, salinity=35.1, pKB from Dickson (1990).

Ba distribution in surface sediments of the Southern Ocean

We present excess Ba (Baxs) data (i.e., total Ba corrected for lithogenic Ba) for surface sediments from a north-south transect between the Polar Front Zone and the northern Weddell Gyre in the Atlantic sector and between the Polar Front Zone and the Antarctic continent in the Indian sector. Focus is on two different processes that affect excess Ba accumulation in the sediments: sediment redistribution and excess Ba dissolution. The effect of these processes needs to be corrected for in order to convert accumulation rate into vertical rain rate, the flux component that can be linked to export production. In the Southern Ocean a major process affecting Ba accumulation rate is sediment focusing, which is corrected for using excess 230Th. This correction, however, may not always be straightforward because of boundary scavenging effects. A further major process affecting excess Ba accumulation is barite dissolution during exposure at the sediment-water column interface. Export production estimates derived from excess 230Th and barite dissolution corrected Baxs accumulation rates (i.e., excess Ba vertical rain rates) are of the same magnitude but generally larger than export production estimates based on water column proxies (234Th-deficit in the upper water column; particulate excess Ba enrichment in the mesopelagic water column). We believe export production values based on excess Ba vertical rain rate might be overestimated due to inaccurate assessment of the Baxs preservation rate. Barite dissolution has, in general, been taken into account by relating it to exposure time before burial depending on the rate of sediment accumulation. However, the observed decrease of excess Ba content with increasing water column depth (or increasing hydrostatic pressure) illustrates the dependence of barite preservation on degree of saturation in the deep water column in accordance with available thermodynamic data. Therefore correction for barite dissolution would not be appropriate by considering only exposure time of the barite to some uniformly undersaturated deep water but requires also that regional differences in degree of undersatuation be taken into account.