(Table 1) K and Ar content, and age determination of ODP Holes 126-792E and 126-793B

Results of conventional K-Ar dating on five samples from two sites from the Izu-Bonin forearc are presented. Two samples recovered from a volcanic edifice and overlying sediments drilled on the western side of the forearc basin (Site 792) indicate a basement age of 34 Ma. This is consistent with early Oligocene biostratigraphic ages from the overlying sediments. Three samples from the basement of Hole 793B at the center of the basin are not analytically distinguishable, with a best age of 27.1 +/- 0.6 Ma. This is slightly younger than the 30-33 Ma biostratigraphic and magnetostratigraphic estimates from the overlying sediments, suggesting that alteration processes have lowered the apparent K-Ar ages. These ages suggest that syn-rift volcanism occurred in a forearc location during the middle Oligocene.

(Table 1) Color, Fe-C-S chemistry and carbonate content from ODP Sites 172-1062 and 172-1063

Reflectance spectra collected during ODP Leg 172 were used in concert with solid phase iron chemistry, carbonate content, and organic carbon content measurements to evaluate the agents responsible for setting the color in sediments. Factor analysis has proved a valuable and rapid technique to detect the local and regional primary factors that influence sediment color. On the western North Atlantic drifts, sediment color is the result of primary mineralogy as well as diagenetic changes. Sediment lightness is controlled by the carbonate content while the hue is primarily due to the presence of hematite and Fe2+/Fe3+ changes in clay minerals. Hematite, most likely derived from the Permo-Carboniferous red beds of the Canadian Maritimes, is differentially preserved at various sites due to differences in reductive diagenesis and dilution by other sedimentary components. Various intensities for diagenesis result from changes in organic carbon content, sedimentation rates, and H2S production via anaerobic methane oxidation. Iron monosulfides occur extensively at all high sedimentation sites especially in glacial periods suggesting increased high terrigenous flux and/or increased reactive iron flux in glacials.

(Table 1) Sulfur isotopes and sulfur content at DSDP Leg 64 Holes

Hydrothermal pyrite samples from Holes 477, 477A, and 478 have sulfur isotope values ranging from about 10 to 11 per mil. Samples with negative sulfur isotope values generally have low sulfide sulfur contents and reflect mixed bacterial and hydrothermal sulfur sources. At higher sulfur contents, the hydrothermal component predominates, producing positive isotope values. Hydrothermal sulfide derives from reduction of seawater sulfate and may contain a significant basaltic component. Hydrothermal anhydrite is restricted to a narrow zone beneath a dolerite sill at Site 477 and, because of partial sulfate reduction in the circulating waters, has isotopic values (23.5-25 per mil), heavier than seawater.