(Table 1) Sulfur isotopes, total sulfur, and degree of oxidation of basalt samples from DSDP Hole 69-504B and 70-504B

About 150 basalt samples from Hole 504B, near the Costa Rica Rift were analyzed for sulfur content and sulfur-isotope composition. The basement in Hole 504B can be divided into an upper part, which has oxidative alteration (274.5-550 m below sea floor), and a lower part, which has nonoxidative alteration (550-835 m below sea floor) (the interval from 540 to 585 meters actually is transitional). This division is reflected in both the sulfur content and the sulfurisotope composition. Oxidative alteration of basalts by sea water at low temperatures has resulted in a depletion in sulfur in the upper part of the hole (mostly less than 600 ppm S) as compared to fresh sulfur-saturated oceanic tholeiites (900-1200 ppm S). High amounts of sulfur in the lower part of the hole are a result of precipitation of secondary pyrite under non-oxidative or weakly oxidative conditions from solutions which dissolved igneous sulfides. The average sulfur-isotope composition of the primary igneous sulfides is d34S = -0.01 per mil, which is close to the assumed mantle sulfur composition (d34S = 0 per mil. Pyrite and sulfate sulfur extracted together in a separate preparation step (as "pyrite-sulfate" sulfur) indicate addition of sea-water sulfate to the upper part of the basalts. The d34S of secondary pyrite isolated by hand-picking varies between -8.0 and +5.8 per mil; the "pyrite-sulfate" sulfur (d34S = -4.8 to +10.5 per mil), as well as that of the isolated pyrite, may have originated in the precipitation of pyrite from solutions containing sulfur from the dissolution of igneous sulfides, but addition of sulfur transported by hydrothermal solutions cannot be excluded.

(Table T2) Sulfur isotopes of pore water from ODP Leg 201 sites

Fifty-seven interstitial water samples from six sites (Ocean Drilling Program Sites 1225-1229 and 1231) in the eastern equatorial Pacific Ocean and the Peru margin were analyzed for the stable sulfur isotopic composition (34S/32S) of dissolved sulfate along with major and minor ions. With the exception of Site 1231, sulfate from the interstitial fluids (d34S values as much as 89 per mil vs. the SF6-based Vienna-Canyon Diablo troilite standard) is found at depth to be enriched in 34S with respect to modern seawater sulfate (d34S = ~21 per mil), indicating that microbial sulfate reduction (MSR) took place to different extents at all investigated sites. Deeper sediments at Sites 1228 and 1229 are additionally influenced by diffusion of a sulfate-rich brine that has already undergone sulfate reduction. The intensity of MSR depends on the availability of substrate (organic matter), sedimentation conditions, and the active bacterial community structure. Formation of isotopically heavy diagenetic barite at the sulfate-methane transition zone is expected at Sites 1227 (one front), 1229 (two fronts), and probably Site 1228. At Site 1231, the constant sulfur isotopic composition of sulfate and concentrations of minor pore water ions indicate that suboxic (essentially iron and manganese oxide based) diagenesis dominates and no net MSR occurs.

(Table 1) Sulfur isotopes and sulfur content at DSDP Leg 64 Holes

Hydrothermal pyrite samples from Holes 477, 477A, and 478 have sulfur isotope values ranging from about 10 to 11 per mil. Samples with negative sulfur isotope values generally have low sulfide sulfur contents and reflect mixed bacterial and hydrothermal sulfur sources. At higher sulfur contents, the hydrothermal component predominates, producing positive isotope values. Hydrothermal sulfide derives from reduction of seawater sulfate and may contain a significant basaltic component. Hydrothermal anhydrite is restricted to a narrow zone beneath a dolerite sill at Site 477 and, because of partial sulfate reduction in the circulating waters, has isotopic values (23.5-25 per mil), heavier than seawater.

(Table 1) Sulfur isotopes, total sulfur, and degree of oxidation of basalt samples from DSDP Holes 69-504B and 70-504B

Whole-rock basalt samples from the upper half of Deep Sea Drilling Project Hole 504B have oxygen-isotope compositions typical of mid-ocean-ridge basalts which have experienced a moderate degree of low-temperature alteration by sea water. By contrast, d18O values in the lower half of the hole correspond to basalts which have experienced almost no detectable oxygen-isotope alteration. These observations suggest that the overall water/rock ratio was lower in the lower half of the drilled crust. A correlation between d18O values and 87Sr/86Sr ratios suggests that the water/rock ratio, rather than temperature variation, was the main factor determining basalt d18O values. Hydrogen-isotope data appear to be consistent with a low water/rock ratio in the lower part of the crust.

Oxygen and sulfur isotopes of peridotite and gabbro from the Mid-Atlantic Ridge

Whole rock sulfur and oxygen isotope compositions of altered peridotites and gabbros from near the 15°20'N Fracture Zone on the Mid-Atlantic Ridge were analyzed to investigate hydrothermal alteration processes and test for a subsurface biosphere in oceanic basement. Three processes are identified. (1) High-temperature hydrothermal alteration (~250-350°C) at Sites 1268 and 1271 is characterized by 18O depletion (2.6-4.4 per mil), elevated sulfide-S, and high delta34S (up to ~2 wt% and 4.4-10.8 per mil). Fluids were derived from high-temperature (>350°C) reaction of seawater with gabbro at depth. These cores contain gabbroic rocks, suggesting that associated heat may influence serpentinization. (2) Low-temperature (<150°C) serpentinization at Sites 1272 and 1274 is characterized by elevated delta18O (up to 8.1 per mil), high sulfide-S (up to ~3000 ppm), and negative delta34S (to -32.1 per mil) that reflect microbial reduction of seawater sulfate. These holes penetrate faults at depth, suggesting links between faulting and temperatures of serpentinization. (3) Late low-temperature oxidation of sulfide minerals caused loss of sulfur from rocks close to the seafloor. Sulfate at all sites contains a component of oxidized sulfide minerals. Low delta34S of sulfate may result from kinetic isotope fractionation during oxidation or may indicate readily oxidized low-delta34S sulfide derived from microbial sulfate reduction. Results show that peridotite alteration may be commonly affected by fluids +/- heat derived from mafic intrusions and that microbial sulfate reduction is widespread in mantle exposed at the seafloor.

(Table 1) Sulfur isotopes and description of anhydrite in DSDP Holes 70-504B and 83-504B

Anhydrite occurs in veins in hydrothermally altered basalts recovered from Hole 504B during Leg 83 of the Deep Sea Drilling Project. Sulfur isotopic data indicate that the anhydrites formed from fluids with sulfur isotopic compositions similar to seawater sulfate. Anhydrite probably formed as a pulse of relatively unreacted seawater was heated when it entered a relatively hot hydrothermal system containing evolved fluids. Reheating and continued evolution of the system followed anhydrite deposition. Preservation of anhydrite in Hole 504B was probably favored by the high temperatures and by the low permeability that resulted from the sealing of cracks with secondary minerals. Evidence also indicates that anhydrite was partly replaced by laumontite and prehnite at relatively high temperatures, and possibly by calcite at lower temperatures.

Chemical composition and stable sulfur isotope record of Black Sea sediments

The main terminal processes of organic matter mineralization in anoxic Black Sea sediments underlying the sulfidic water column are sulfate reduction in the upper 2-4 m and methanogenesis below the sulfate zone. The modern marine deposits comprise a ca. 1-m-deep layer of coccolith ooze and underlying sapropel, below which sea water ions penetrate deep down into the limnic Pleistocene deposits from >9000 years BP. Sulfate reduction rates have a subsurface maximum at the SO4[2-]-CH4 transition where H2S reaches maximum concentration. Because of an excess of reactive iron in the deep limnic deposits, most of the methane-derived H2S is drawn downward to a sulfidization front where it reacts with Fe(III) and with Fe2+ diffusing up from below. The H2S-Fe2+ transition is marked by a black band of amorphous iron sulfide above which distinct horizons of greigite and pyrite formation occur. The pore water gradients respond dynamically to environmental changes in the Black Sea with relatively short time constants of ca. 500 yr for SO4[2-] and 10 yr for H2S, whereas the FeS in the black band has taken ca. 3000 yr to accumulate. The dual diffusion interfaces of SO4[2-]-CH4 and H2S-Fe2+ cause the trapping of isotopically heavy iron sulfide with delta34S = +15 to +33 per mil at the sulfidization front. A diffusion model for sulfur isotopes shows that the SO4[2-] diffusing downward into the SO4[2-]-CH4 transition has an isotopic composition of +19 per mil, close to the +23 per mil of H2S diffusing upward. These isotopic compositions are, however, very different from the porewater SO4[2-] (+43 per mil) and H2S (-15 per mil) at the same depth. The model explains how methane-driven sulfate reduction combined with a deep H2S sink leads to isotopically heavy pyrite in a sediment open to diffusion. These results have general implications for the marine sulfur cycle and for the interpretation of sulfur isotopic data in modern sediments and in sedimentary rocks throughout earth's history.