Effect of enhanced pCO2 levels on the production of dissolved organic carbon and transparent exopolymer particles in short-term bioassay experiments

It has been proposed that increasing levels of pCO2 in the surface ocean will lead to more partitioning of the organic carbon fixed by marine primary production into the dissolved rather than the particulate fraction. This process may result in enhanced accumulation of dissolved organic carbon (DOC) in the surface ocean and/or concurrent accumulation of transparent exopolymer particles (TEPs), with important implications for the functioning of the marine carbon cycle. We investigated this in shipboard bioassay experiments that considered the effect of four different pCO2 scenarios (ambient, 550, 750 and 1000 µatm) on unamended natural phytoplankton communities from a range of locations in the northwest European shelf seas. The environmental settings, in terms of nutrient availability, phytoplankton community structure and growth conditions, varied considerably between locations. We did not observe any strong or consistent effect of pCO2 on DOC production. There was a significant but highly variable effect of pCO2 on the production of TEPs. In three of the five experiments, variation of TEP production between pCO2 treatments was caused by the effect of pCO2 on phytoplankton growth rather than a direct effect on TEP production. In one of the five experiments, there was evidence of enhanced TEP production at high pCO2 (twice as much production over the 96 h incubation period in the 750 ?atm treatment compared with the ambient treatment) independent of indirect effects, as hypothesised by previous studies. Our results suggest that the environmental setting of experiments (community structure, nutrient availability and occurrence of phytoplankton growth) is a key factor determining the TEP response to pCO2 perturbations.

(Table 1) Granulometry of sediments obtained during research cruises of Tender Ems and Hermann Wattenberg in Kiel Bay, Baltic Sea

Sediment cores, mainly push-box samples, from a channel system of the Kiel Bay are described. The channel system, of glacial and fluviatile origin, is important for the distribution of heavy, salt-rich water entering from the North Sea through the Great Belt, Sediment erosion and transport in the channels is due entirely to currents, because the bottom lies too deep for wave action. The sediments of these channels proude information about current velocities and their frequencies. Grain-size, minor sediment structures and thickness of the sediments vary remarkably. Nevertheless, for those parts of the channels where stronger currents occur, some typical features can be shown. These include: small thickness of the marine sediments, erosional effects upon the underlying sediments, and poor sorting of the sediments, whereby fine and coarse fractions are mixed very intensively. Besides strong currents which effect the bottom configuration and deposits in the Fehmarn Belt, there must exist longer periods of low current action upon the bottom, although current measurements show that current velocities higher than 50 cm/sec at some meters above the bottom occur frequently during the year. In the channel to the west of the southern mouth of Great Belt, coarse sediments were found only in elongate, deep throughs within the channels. This is believed to be due to an acceleration of the entering tongues of heavy water as they flow downslope into the throughs. Minor structures of two sediment cores were made visible by X-ray photographs. These showed that the mixing of sand and clayey material is due partly to bottom organisms and that the mud, which appears 'homogeneous' to the bare eye, is built up of fine wavy laminae which are also partly destroyed by boring animals. At another location in the channel system, there was found a thin finegrained layer of marine sediment resting upon peat. Palynological dating of the peat shows that very little older sediment could have been eroded. The current velocities, therefore, must be too low for the movement of coarse material and erosion, but too high to allow the Sedimentation of a lot of fine-grained material.