Preliminary results and documentation of sediment core CRP-1 from the Ross Sea off Cape Roberts, Antarctica

The first hole of the Cape Roberts Project, CRP-1, was drilled in October, 1997, to a depth of 148 metres below the sea floor (mbsf) before being terminated unexpectedly the loss of fast sea-ice seaward of the rig following a severe storm. The site lies in 150 m of water at 77.008°S and 163.755°E, 16 km off Cape Roberts. This part of the report outlines the geologic setting, a gently tilted sequence near the margin of the Victoria Land Basin, and describes the history of the growth of sea ice, which provided the drilling platform, as well as the history of the drilling itself. Core recovery was around 77% in soft and brittle strata to 100 m and 98% below that. The sequence was found to comprise a Quaternary glacigenic interval down to 43.55 mbsf and below this an early Miocene interval that was also glacigenic. Core properties that were studied include fracture patterns, porosity, sonic velocity and magnetic susceptibility. Velocity in particular was useful in relating the cored sequence to the regional seismic stratigraphy. A preliminary assessment suggests that the bottom of the hole is 15 m short of the boundary between seismic sequences V3 and V4. Analytical facilities new to the Antarctic and used for processing samples for the project are described here and include a bench top palynological processing system and a palaeomagnetic laboratory. The core management and sampling system, which recorded over 2000 samples, is also outlined.

(Table 1) Physical properties of basalts from DSDP Legs 69 and 70

Physical properties of basalts from Deep Sea Drilling Project Sites 504 and 505, south of the Costa Rica Rift, including wet-bulk density, water content, sonic velocity, and thermal conductivity, were measured on board D/V Glomar Challenger during Legs 69 and 70. The mean wet-bulk density is 2.90±0.06 g/cm**3, porosity 5.0±2.2%, sonic velocity 5.75±0.30 km/s, and thermal conductivity 1.67±0.09 W/m°K. Basalts from this young ocean crust (5.9 m.y.) have relatively low porosity and consequently high density and sonic velocity, as compared to average DSDP basalts. Some systematic trends in depth variation of physical properties were found: down to Core 40 in Hole 504B, grain densities were lower than those deeper in the hole, whereas porosity in the upper section was higher. This can be attributed either to differences in the flow type or in the nature of alteration of basalts at the different levels in the hole.