Carbon isotopic composition of dissolved CO2, CO2 gas and methane in sediments from ODP Leg 172 sites

Carbon isotopic data of interstitial dissolved CO2 (CO2), CO2 gas, and methane show that a variety of microbial diagenetic processes produce the observed isotopic trends. Anaerobic methane oxidation (AMO) is an important process near the sulfate-methane interface (SMI) that strongly influences the isotopic composition of CO2 in the sulfate reduction and upper methanogenic zones, which in turn impacts methane isotopic composition. Dissolved CO2 and methane are maximally depleted in 13C near the SMI, where 13C values are as light as -31.8 and -101 PDB for CO2 and methane, respectively. CO2 reduction links the CO2 and methane pools in the methanogenic zone so that the carbon isotopic composition of both pools evolves in concert, generally showing increasing enrichments of 13C with increasing depth. These isotopic trends mirror those within other methane-rich continental rise sediments worldwide.

Hydrocarbon gar in sediments of the Costa Rica ubduction zone

At the active continental margin off Costa Rica substantial amounts of hydrocarbon gases are encountered in sediments. The molecular composition (C1-C3) of free hydrocarbon gas as well as the isotopic composition (d13C of methane and ethane and D of methane) was analysed on core samples (ranging between 50 and 380 m depth) collected at sites 1040-1043 which was drilled during ODP Leg 170. In addition, the molecular composition of the C1-C3 hydrocarbons and the d13C composition of C1 and C2 hydrocarbons was determined on adsorbed gas from selected depth intervals at Site 1041 (50-380 mbsf). The molecular composition, and stable carbon and hydrogen isotope signature of low molecular weight hydrocarbons from core sediments and gas pockets indicate that most of the gas was generated by microbial CO2-reduction. Beside d13C values of about -80 per mil for methane (which is typical for microbially- generated methane) extremely light d13C values of -55 per mil were measured for ethane. The carbon isotope composition of methane and ethane, as well as the C1/(C2+C3) ratio display distinct trends with increasing depth. Gas mixing calculations indicate that the percentage of thermally-generated ethane increases from 10% at about 75 mbsf to almost 80% at 380 mbsf. The fraction of thermogenic methane in this depth interval is calculated to range from 0.03 to 1.8% of the total methane. The small contribution of thermogenic methane would increase the d13C value by <1 per mil. Therefore, the increase of d13C of methane (by about 12 per mil) with depth cannot be explained by gas mixing alone. Instead, the observed d13C trend is caused by successive isotope depletion of the methane precursor within the sedimentary organic matter due to progressing microbial gas generation.

Properties of seawater (partial pressure of carbon dioxide (pCO2)) from a ProOceanus CO2-Pro sensor mounted on the continuous surface water sampling system during the Tara Oceans expedition 2009-2013

The Tara Oceans Expedition (2009-2013) sampled the world oceans on board a 36 m long schooner, collecting environmental data and organisms from viruses to planktonic metazoans for later analyses using modern sequencing and state-of-the-art imaging technologies. Tara Oceans Data are particularly suited to study the genetic, morphological and functional diversity of plankton. The present data set provides continuous measurements of partial pressure of carbon dioxide (pCO2), using a ProOceanus CO2-Pro instrument mounted on the flowthrough system. This automatic sensor is fitted with an equilibrator made of gas permeable silicone membrane and an internal detection loop with a non-dispersive infrared detector of PPSystems SBA-4 CO2 analyzer. A zero-CO2 baseline is provided for the subsequent measurements circulating the internal gas through a CO2 absorption chamber containing soda lime or Ascarite. The frequency of this automatic zero point calibration was set to be 24 hours. All data recorded during zeroing processes were discarded with the 15-minute data after each calibration. The output of CO2-Pro is the mole fraction of CO2 in the measured water and the pCO2 is obtained using the measured total pressure of the internal wet gas. The fugacity of CO2 (fCO2) in the surface seawater, whose difference with the atmospheric CO2 fugacity is proportional to the air-sea CO2 fluxes, is obtained by correcting the pCO2 for non-ideal CO2 gas concentration according to Weiss (1974). The fCO2 computed using CO2-Pro measurements was corrected to the sea surface condition by considering the temperature effect on fCO2 (Takahashi et al., 1993). The surface seawater observations that were initially estimated with a 15 seconds frequency were averaged every 5-min cycle. The performance of CO2-Pro was adjusted by comparing the sensor outputs against the thermodynamic carbonate calculation of pCO2 using the carbonic system constants of Millero et al. (2006) from the determinations of total inorganic carbon (CT ) and total alkalinity (AT ) in discrete samples collected at sea surface. AT was determined using an automated open cell potentiometric titration (Haraldsson et al. 1997). CT was determined with an automated coulometric titration (Johnson et al. 1985; 1987), using the MIDSOMMA system (Mintrop, 2005). fCO2 data are flagged according to the WOCE guidelines following Pierrot et al. (2009) identifying recommended values and questionable measurements giving additional information about the reasons of the questionability.