Stable isotope record of northeastern Australian Margin

Stable isotopic data obtained from planktonic and benthic foraminifers were used to study paleoceanographic changes along the northeastern Australian margin from late Miocene (10 Ma) to Holocene time, and to evaluate the influence of these changes on reef growth. The data indicate that variations in surface-water temperatures may have had an important effect on the reef complexes on the Queensland Plateau and possibly off the northeastern Australian margin. Three sites were studied: Leg 21, Site 209 on the eastern edge of the Queensland Plateau, and Leg 133, Site 811 on the western margin, and Site 817 on the lower southern slope of the plateau. Shallow-water bioclasts recovered from Holes 811A and 817A indicate extensive reef growth on the Queensland Plateau during the middle Miocene (before 12 Ma), signifying surface-water temperatures of 20°C or greater. The amount of reefal detritus produced during the late Miocene (10.0-5.2 Ma) decreased progressively, resulting in a reduction in area of the reef complexes. The isotopic data from planktonic foraminifers in these late Miocene age sediments indicate the presence of relatively cool surface waters (16°-19°C), which may have been a major factor contributing to the demise of the reefs on the Queensland Plateau. Surface waters remained cool until the middle Pleistocene (1.2-0.5 Ma), when the surface-water temperature apparently increased to approximately 25°C, recorded both in the isotopic data and by renewed reef growth. This increase occurred simultaneously (within the error of the age model) with the initiation of the Great Barrier Reef. We propose that cooling of surface waters during the early late Miocene contributed to reef decline on the Queensland Plateau, and that subsequent warming of surface waters during the middle Pleistocene promoted the initiation of reef growth on the northeastern Australian margin. Reef development on the Queensland Plateau never recovered to the middle Miocene extent because of a combination of tectonic (accelerated subsidence of the plateau) and paleoceanographic (the cooler surface waters present from the late Miocene throughout the Pliocene) factors. Variations in seafloor d18O appear to be controlled by regional factors, as indicated by the similarity of data from Sites 811 and 817 to those from Site 590 on Lord Howe Rise.

Late Pliocene carbonate mineralogy of ODP Hole 133-818B

Shedding of shallow carbonate material toward the deep slopes and basin floors is clearly tied to the position of the carbonate bank tops relative to the photic zone. The onset of bank shedding in periplatform sediments can record either the flooding of the bank tops within the photic zone during a rise in sea level following a period of exposure, referred to in the literature as the "highstand shedding" scenario, or the reentry of the bank tops into the photic zone during a lowering of sea level following a period of drowning, referred to as the "lowstand shedding" scenario. Results from Leg 133 post-cruise research on the Pliocene sequences, drilled in six sites within different slope settings of the Queensland Plateau, seem to point out that the latter "lowstand shedding" scenario can be applied to this particular carbonate system. At the Queensland Plateau sites, the early Pliocene (5.2-3.5 Ma) and the earliest part of the late Pliocene (3.5-2.9 Ma) age sequences were characterized, especially in the ôdeepö Sites 811 and 817, by pelagic sediments (foraminifers and coccoliths) and by typically pelagic sedimentation rates not exceeding 20 mm/k.y. The earliest part of the late Pliocene age section was characterized by well-developed hardgrounds in the "shallow" Sites 812 and 814 and by normal pelagic sediments mixed with reworked phosphatized planktonic foraminifers in Site 813. Finally, the early part of the late Pliocene (2.9-2.4 Ma) section was characterized by high sedimentation rates, related to the shedding and admixture into the pelagic sediments of bank-derived materials. These bank-derived materials consist of either diagenetically unaltered fine aragonite with traces of dolomite in Site 818 or micritic calcite resulting from seafloor and/or shallow burial alteration in the deepest Sites 817 and 811. The highest sedimentation rates (163 mm/k.y.) were recorded in Site 818, drilled nearest the modern carbonate bank of Tregrosse Reef. The sedimentation rates decrease with increasing distance from Tregrosse Reef - 120 mm/k.y. in Site 817 and 47.5 mm/k.y. in Site 811. The initial appearance of fine aragonite in Site 818, corresponding to the transition from pelagic to periplatform sedimentation rates, has been dated at 2.9 Ma. This Pliocene sediment pattern on the Queensland Plateau is different from the pattern observed in sediments from two earlier ODP legs (i.e., Leg 101 in the Bahamas and in Leg 115 in the Maldives), where aragonite-rich sediments, characterized by high periplatform sedimentation rates, were observed in the lower Pliocene section (5.2-3.5 Ma), whereas the upper Pliocene (3.5-1.6 Ma) sediments are more pelagic in nature and are characterized by low sedimentation rates or major hiatuses. These Pliocene periplatform sequences in the Bahamas and in the Maldives and late Quaternary age periplatform sequences worldwide have pointed out that "highstand shedding" was the typical response of carbonate platforms to fluctuations in sea level, just opposite to a "lowstand shedding" response to sea-level fluctuations, typical of siliciclastic shelves. Assuming that the envelope of Haq et al.'s (1987) sea-level curve, showing a well-defined lowering of sea level between 3.5 and 2.9 Ma, can also be applied to the southwest Pacific Ocean, based on a high-resolution Pliocene d18O record from the Ontong Java Plateau recently published by Jansen et al. (1993, doi:10.2973/odp.proc.sr.130.028.1993), the Pliocene periplatform sequences on the Queensland Plateau would have recorded the reentry of the bank tops into the photic zone during a general lowering of sea level, following an interval characterized by high sea level, during which the shallow carbonate system on the Queensland Plateau was drowned. The early Pliocene age (5.2-3.5 Ma) sediments deposited on the Queensland Plateau, an established interval of eustatic sea-level highstand, are typically pelagic in character. In addition, relatively cold surface temperatures (estimated to have ranged from 18° to 20°C by Isern et al. [this volume]) might have also stressed the reefs during early Pliocene time and contributed to the drowning of the Queensland Plateau carbonate system during the late Miocene and early Pliocene. Differential and relatively high subsidence rates, inferred by variations in paleodepth of water (based upon benthic foraminifer assemblages; Katz and Miller, this volume) may also have influenced the drowning of the carbonate bank tops on the Queensland Plateau during the late Miocene and early Pliocene. The sediments of early late Pliocene age (2.9-2.4 Ma), a well-established interval of lowering of sea level, are clearly periplatform and cyclic in nature. High-frequency (~40 k.y.) aragonite cycles, well-developed between 2.9 and 2.45 Ma, correlate with the planktonic high-resolution Pliocene d18O record from the Ontong Java Plateau, a good sea-level proxy (Jansen et al., in press). Contrary to late Quaternary age aragonite cycles from the Bahamas, the Nicaragua Rise, the Maldives, and the Queensland Plateau, the late Pliocene aragonite cycles in Hole 818B display high levels of aragonite during glacial stages and, therefore, lowstands of sea level. In addition, sediments deposited during the earliest part of the late Pliocene (3.5-2.9 Ma), transition between the early Pliocene highstand and the late Pliocene lowering in sea level, have recorded the first evidence of a fall in sea level, by (1) the occurrence of synchronous submarine hardgrounds in the two shallowest sites (Sites 812 and 814), (2) the deposition of reworked material from the shallower part of the slope into the intermediate Sites 813 and 818, and (3) the deposition of pelagic sediments in the deepest Sites 817 and 817. In summary, contrary to previous findings, the Pliocene periplatform sediments on the Queensland Plateau appear to have recorded a regional shedding of shallow carbonate bank tops during an interval of sea-level lowering, a good illustration of the "carbonate lowstand shedding" scenario, occurring during the reentry of previously drowned carbonate bank tops into the photic zone related to a decrease in sea level.

Magnetic measurements performed on sediments from the Bay of Seine seafloor (France) from 2011 to 2013

Impact and monitoring of dredge spoils are an important environmental issue. This investigation aims to map two dredge-spoil dispersals in the Bay of Seine by using an innovative application of well-established environmental magnetic proxies. Low-field magnetic susceptibility measurements were performed on discrete samples from dredge sediments and from the Bay of Seine seafloor before & after dumping. The fingerprinting of the dispersion of dredge-dumped sediments is efficient due to the higher susceptibility of the dredge sediments with respect to the background. Besides, terrestrial input is also monitored in our susceptibility maps. Dilution of the susceptibility signal allows an estimation of the resilience of the sedimentary environment on a six-month survey. This susceptibility signal is controlled by the ferromagnetic fraction of the sediment. A constant magnetic mineralogy carried by magnetite is observed in the study area, thus a qualitative parameter for magnetic grain size was selected that shows an in-progress resilience pattern over the survey.

Tab 1-4 Weight and volume reduction as well as surface subsidence during abrasion experiments

Antarctic land surfaces in South Victoria Land, all without a covering of vegetation, are actively formed by winds which often reach velocities of more than 100 km/h. Consequently, deflation and abrasion are essential factors in the process of slope formation. Water erosion, active only during the very short summer period, is limited to a few localities in South Victoria Land. Experiments in a wind tunnel proved that ventifacts in the Dry Valleys can be formed within a few decades or at the most, a few centuries. Yearly corrasion rates average around a maximum of a few millimeters. Considerable variability is caused by the different exposures of ventifacts within the micro relief end the varying resistance of the rocks. The importance of ice crystals (snow) for abrasion processes should not be overestimated.

Ages and two-way travel times of ODP Sites 180-1109, 180-1115 and 180-1118

Synthetic seismograms are constructed from check shot-corrected velocity and density measurements collected during Ocean Drilling Program (ODP) Leg 180 at Sites 1109, 1115, and 1118. The synthetic seismograms facilitate direct correlation of a coincident multichannel seismic (MCS) profile with borehole data collected at the three sites. The MCS data and the synthetic seismograms correlate very well, with most major reflectors successfully reproduced in the synthetics. Our results enable a direct calibration of the MCS data in terms of age, paleoenvironment, and subsidence history. Seismic reflectors are time correlative within stratigraphic resolution but are often observed to result from different lithologies across strike. Our results facilitate the extrapolation of the sedimentation history into an unsampled section of Site 1118 and enable a full correlation between the three sites using all the data collected during ODP Leg 180. This study forms the foundation for regionalizing the site data to the northern margin of the Woodlark Basin, where the transition from continental rifting to seafloor spreading is taking place.