Fluor and opal in surface sediment from the Bransfield Strait (Table 1)

The influence of biogenic opal sediment input (mainly diatom skeletons) on the fluorine budget of marine sediments will be shown for 24 sampling stations of the antarctic regions of Bransfield Strait, Powell Basin, South Orkney Plateau and northwestern Weddell Sea. 4 bulk samples, one from each sedimentation area, contain 9 to 28 wt.-% of biogenic opal , the clay fraction of the 24 samples investigated have 2 to 82 wt.-%. The fluorine concentration in the amorphous biogenic component is 15 ppm. 300 to 800 ppm of fluorine were measured in the clay fractions, 330 to 920 ppm in their lithogenic components. Biogenic opal causes a decrease in fluorine concentration of the sediment by a considerable amount: 6 to 56 % relative to the clay fraction, due to the proportions involved. Biogenic opal is therefore taken into account as a 'diluting' factor for the fluorine budget in marine sediments.

Chemistry of minerals from amphibole-chlorite veins of ODP Site 209-1270

We examined small-scale shear zones in drillcore samples of abyssal peridotites from the Mid-Atlantic Ridge. These shear zones are associated with veins consisting of chlorite + actinolite/tremolite assemblages, with accessory phases zircon and apatite, and they are interpreted as altered plagiogranite melt impregnations, which originate from hydrous partial melting of gabbroic intrusion in an oceanic detachment fault. Ti-in-zircon thermometry yields temperatures around 820°C for the crystallization of the evolved melt. Reaction path modeling indicates that the alteration assemblage includes serpentine of the adjacent altered peridotites. Based on the model results, we propose that formation of chlorite occurred at higher temperatures than serpentinization, thus leading to strain localization around former plagiogranites during alteration. The detachment fault represents a major pathway for fluids through the oceanic crust, as evidenced by extremely low d18O of altered plagiogranite veins (+3.0-4.2 per mil) and adjacent serpentinites (+ 2.6-3.7 per mil). The uniform oxygen isotope data indicate that fluid flow in the detachment fault system affected veins and adjacent host serpentinites likewise.

Isotopic composition and chemistry of pore waters from ODP Site 195-1201 sediments, West Philippine Basin

This report summarizes chemical and isotopic data from Ocean Drilling Program Leg 195 Site 1201. Pore water is divided into three intervals based on the rate of chemical change with depth. The shallowest interval is the red clay unit between 1.26 and 56.40 meters below seafloor (mbsf). In this section, there are overall decreases in the concentrations of alkalinity, boron, lithium, magnesium, potassium, sodium, and sulfate, whereas concentrations of calcium and chloride increase. Values of d18O and dD plot near standard mean ocean water to the right of the global meteoric water line (GMWL). Five samples from 72.60 and 83.33 mbsf yielded pore water for analyses. These samples help define a trend in the second interval, which is between 56.4 and 238.98 mbsf. Here, concentrations of magnesium, potassium, sodium, and sulfate decease, whereas concentrations of boron, calcium, and chloride increase. Concentrations of alkalinity and lithium remain roughly constant. The deepest interval, between 238.04 and 504.8 mbsf, has comparatively slower decreases of sodium and sulfate, increases of calcium and chloride, slow increases of alkalinity and lithium, and roughly constant concentrations of magnesium, potassium, and boron. Values of d18O and dD in pore water between 146.98 and 504.80 mbsf plot in a linear trend to the right of the GMWL.

(Table T1) Pore water chemistry of ODP Site 195-1202 sediments, southern Okinawa Trough

Pore water was collected from sediment cores from Holes 1202A and 1202D in the southern Okinawa Trough during Ocean Drilling Program (ODP) Leg 195. Because drilling at this site was completed only a few hours out of port during the end of the leg, whole rounds of sediment core 5 or 10 cm long were sealed and stored at ~3°C until pore water could be extracted from them during Leg 196, using a titanium squeezer designed by Manheim and Sayles (1974) and standard handling techniques (Shipboard Scientific Party, 2002, doi:10.2973/odp.proc.ir.195.103.2002).