Planktonic foraminifera and sea surface temperature reconstruction of sediments from the Mediterranean Sea

Water exchange between the Black Sea and the Mediterranean Sea has been a major focus of the paleohydrography of the eastern Mediterranean. Glacial melt water released from the Black Sea is a potential factor in the formation of sapropel S1, an organic-rich sediment layer that accumulated during the Early Holocene. A high-resolution study done on sediments from the Marmara Sea, the gateway between the Mediterranean and the Black Sea, sheds light on the Holocene exchange processes. Past sea surface temperature and sea surface salinity (SSS) were derived from stable oxygen isotope ratios (delta18O) of foraminiferal calcite and alkenone unsaturation ratios (Uk'37). Heavy delta18O values and high SSS in the Marmara Sea suggest absence of low salinity water from the Black Sea during S1. The comparison with data from the Levantine Basin and southern Aegean Sea outlines gradients of freshening in the eastern Mediterranean Sea, whereby the major sources of freshwater were closer to the Levantine Basin. It is thus concluded that the Black Sea was not a major freshwater source contributing to formation of S1. Given the absence of a low salinity layer, the deposition of organic-rich sediments corresponding to S1 in the Marmara Sea is likely the result of the global transgression and the concomitant re-organization of biogeochemical cycles, leading to enhanced productivity as shown by Globigerina bulloides.

Major oxides for tektites and for conglomerate clast of the Upper Eocene ejecta-bearing layer of ODP Hole 150-904A (Table 1)

Evidence for the Chesapeake Bay Crater as the source for New Jersey continental margin ejecta is provided by fine-grained tektites and coarse-grained unmelted ejecta. The Upper Eocene ejecta deposit, now demonstrated to be part of the North American strewn field, occurs on the New Jersey continental margin at Ocean Drilling Program (ODP) Sites 904 and 903. The mineralogy, major oxide composition of the ejecta materials, and biostratigraphic age of the enclosing sediments link the origin of these ejecta to the recently recognized Chesapeake Bay impact crater, located only 330 km away. Sediments associated with the ejecta provide information about the dynamics of impact events. The 35-cm-thick ejecta-bearing layer can be subdivided into three subunits that indicate a sequence of events. Bottom subunit III documents sediment failure and deposition of gravel-sized fragments, middle subunit II records deposition of abundant sand-sized ejecta by gravity settling, and upper subunit I contains a 12-cm-thick sedimentary deposit containing rare silt-sized tektites and evidence of waning currents. These events are interpreted by linking sediment deposition to seismic ground motion and subsequent tsunami waves triggered by both the Chesapeake Bay impact and slope failures.

Geochemical analysis of sediments from three coring sites in the Mediterranean

In a gravity core from the eastern Mediterranean Sea, a chemically and mineralogically distinct, 5.5-cm-thick layer is present above sapropel S-1 and overlain by hemipelagic marls. Calcite is completely absent in this exotic layer, dolomite is present only in small amounts, and the Cr concentrations are significantly enhanced. The layer was deposited primarily under reducing conditions, but the distributions of redox-sensitive elements show that a large part of the exotic layer is now oxidised by a downward-progressing oxidation front. Sediments from within the nearby anoxic, hypersaline Urania Basin are similar to those from the exotic layer, in particular in S-, C-, and O-isotope distributions of pyrite and dolomite, as well as increased Cr concentrations. Mud expulsion due to expansion of gas-rich mud is proposed to explain the presence of the exotic layer outside the Urania Basin. The deposition of an anoxic layer above S-1 shielded the sapropel from oxidation which resulted in the rare occurrence of a complete preservation of S-1 and provides the first minimum age for the start of anoxic mud accumulation in the Urania Basin.

Geochemistry on sapropel deposition in the eastern Mediterranean from cores TTR-GL94 and M25/4-KL11

The geochemistry of the youngest Mediterranean sapropel layer suggests changes in productivity and water column oxygen conditions during sapropel deposition. The Ba-enriched interval is broader than the organic-carbon-rich interval of this sapropel. We suggest that the Ba-enriched horizon records the original thickness of the sapropel prior to subsequent partial oxidation. The main carrier of Ba is barite, as microcrystals (0.5-5 µm ) having a morphology characteristic of marine barite, particularly abundant beneath high productivity regions. Ba concentrations do not change at the sapropel layer oxidation front and diagenetic barite crystals are absent, thus the Ba-enriched layer reflects original oceanic conditions of increased biological productivity during sapropel deposition and not diagenetic Ba remobilization. Paleoredox indicators point to restricted oxygenated bottom water but not to fully anoxic conditions. Detrital elements within this layer indicate a lower eolian terrigenous input, enhanced humidity, and increased precipitation/runoff, thus likely higher nutrient supply.

Using ground-penetrating radar, topography and classification of vegetation to model the sediment and active layer thickness in a periglacial lake catchment, Western Greenland, link to shapefiles

The geometries of a catchment constitute the basis for distributed physically based numerical modeling of different geoscientific disciplines. In this paper results from ground-penetrating radar (GPR) measurements, in terms of a 3D model of total sediment thickness and active layer thickness in a periglacial catchment in western Greenland, is presented. Using the topography, thickness and distribution of sediments is calculated. Vegetation classification and GPR measurements are used to scale active layer thickness from local measurements to catchment scale models. Annual maximum active layer thickness varies from 0.3 m in wetlands to 2.0 m in barren areas and areas of exposed bedrock. Maximum sediment thickness is estimated to be 12.3 m in the major valleys of the catchment. A method to correlate surface vegetation with active layer thickness is also presented. By using relatively simple methods, such as probing and vegetation classification, it is possible to upscale local point measurements to catchment scale models, in areas where the upper subsurface is relatively homogenous. The resulting spatial model of active layer thickness can be used in combination with the sediment model as a geometrical input to further studies of subsurface mass-transport and hydrological flow paths in the periglacial catchment through numerical modelling.

Distribution of Ivory Coast microtektite layer

During the present study the Ivory Coast microtektite layer was found in cores from five equatorial Atlantic sites, bringing the total number of Ivory Coast microtektite-bearing cores to eleven. The strewn field appears to be restricted to between 9°N and 12°S latitude. There is a general increase in the concentration of microtektites towards the Bosumtwi crater, which is generally thought to be the source of the Ivory Coast tektites. The relationship between the onset of the Jaramillo subchron and the Ivory Coast microtektite layer has been investigated in six cores. A plot of the difference in depth between the base of the Jaramillo subchron and the microtektite layer versus sediment accumulation rate was used to determine the average post-depositional remanent magnetization (PDRM) acquisition depth and the age difference between the onset of the Jaramillo subchron and the deposition of the microtektites. Assuming that the PDRM acquisition depth does not vary with sediment accumulation rate, we find that the average PDRM acquisition depth is 7 cm and that the microtektites were deposited approximately 8 ky after the onset of the Jaramillo subchron. This indicates that the impact responsible for the Ivory Coast tektites and microtektites could not be causally related to the geomagnetic reversal at the base of the Jaramillo subchron.

Detrital layer thickness in 12 varved sediment cores in Lake Mondsee and related flood events AD1976-2005

A succession of 23 sub-millimetre to maximum 12-mm-thick, mostly flood-triggered detrital layers, deposited between 1976 and 2005, was analysed in 12 varved surface sediment cores from meso-scale peri-alpine Lake Mondsee applying microfacies and high-resolution micro X-ray fluorescence analyses. Detailed intrabasin comparison of these layers enabled identification of (i) different source areas of detrital sediments, (ii) flood-triggered sediment flux and local erosion events, and (iii) seasonal differences of suspended flood sediment distribution within the lake basin. Additional calibration of the detrital layer record with river discharge and precipitation data reveals different empirical thresholds for flood layer deposition for different parts of the basin. At proximal locations detrital layer deposition requires floods exceeding a daily discharge of 40 m**3/s, whereas at a location 2 km more distal an hourly discharge of 80 m**3/s and at least 2 days of discharge above 40 m**3/s are necessary. Furthermore, we observe a better correlation between layer thickness and flood amplitude in the depocentre than in distal and proximal areas of the basin. Although our results are partly site-specific, the applied dual calibration approach is suitable to precisely decipher flood layer formation processes and, thereby, improve the interpretation of long flood time series from lake sediments.