137Cs concentrations in the southeastern Baltic Sea in 1997-2000

Variations of 137Cs concentration in the southeastern Baltic Sea were investigated over the period 1997-2000, i.e. in 11-14 years after the Chernobyl Nuclear Power Plant accident. Rate of "self-cleaning" proved to be very slow. Some results obtained in 1999 were almost the same as those measured after the accident, in 1986. Calculated results showed that "Chernobyl" caesium-137 would be "cleaned" in the Baltic Sea by 2020-2022. In 2000 average concentration had to be about 50-60 Bq/m**3. Sometimes mentioned concentrations were observed. In some cases higher concentrations averaging from 67 to 80 Bq/m**3 were registered in the southeastern Baltic Sea in 1999; and in some samples 137Cs concentrations were very high. They varied from 110 to 212 Bq/m**3. No steady correlation was observed between 137Cs concentration, salinity and temperature in surface water of the area. Distribution of radionuclide concentration sometimes depends on direction of water mass transport. Abnormally high concentrations of 137Cs in the southeastern Baltic Sea may result from additional radioactive waste discharge.

Step-heating degassing data for argon-39 from volcanic rocks drilled in the Shikoku Basin and Mariana trench, DSDP Legs 58 and 60

From the experimental data on stepwise thermal release of neutron induced 39Ar (39K (n, p) 39Ar) from rocks and minerals, Arrhenius plots were constructed, which gave activation energies for the thermal release process. The activation energies for DSDP Leg 58 and Leg 60 submarine volcanic rocks range from 12 to 20 kcal/mol, whereas those for granodiorites and the K-feldspar separates have activation energies ranging from 37 to 48 kcal/mol. The smaller activation energies for the submarine volcanic rocks reflect the grain boundary diffusion process, while the thermal diffusion of 39Ar from granodiorites and K-feldspar is essentially controlled by a volume diffusion. The grain boundary diffusion for the submarine volcanic rocks suggests that K resides essentially in the grain boundaries.

(Table 1) Apparent ages from 40Ar/39Ar heating steps for DSDP Hole 72-516F basalts

Submarine basalts are difficult to date accurately by the potassium-argon method. Dalrymple and Moore (1968) and Dymond (1970), for example, showed that, when the conventional K-Ar method is used, pillow lavas may contain excess 40Ar. Use of the 40Ar/39Ar step-heating method has not overcome the problem, as had been hoped, and has produced some conflicting results. Ozima and Saito (1973) concluded that the excess 40Ar is retained only in high temperature sites, but Seidemann (1978) found that it could be released at all temperatures. Furthermore, addition of potassium, from seawater, to the rock after it has solidified can result in low ages (Seidemann, 1977), the opposite effect to that of excess 40Ar. Thus, apparent ages may be either greater or less than the age of extrusion. Because of this discouraging record, the present study was approached pragmatically, to investigate whether self-consistent results can be obtained by the 40Ar/39Ar step-heating method.