Physical properties of 4 cores from the Bengal Fan

New stratigraphic and high-resolution seismic data from the Bengal Fan indicate that the world's largest fan shows active growth during the most recent sea-level rise and the recent highstand. This unique phenomenon contradicts common sequence-stratigraphic models, and the sediment preserved provides new insight into the sedimentological response of a fan system to sea-level rise, climatic terminations, and monsoon intensity during the past climatic cycle. We present a detailed dated sequence of turbidite sedimentation based on a core transect perpendicular to the active channel-levee system in the upper mid-fan area. Between the two major terminations 1a (12 800 14C yr B.P.) and 1b (9700 14C yr B.P.), and especially at the end of the Younger Dryas, a 13-km-wide channel built up levees 50 m high. With decreasing sediment supply, continued sea-level rise, and increasing monsoon intensity during the early Holocene, turbidity currents were confined to the channel and gradually filled it. The canyon "Swatch of No Ground," a shelf depocenter that serves as the source for frequent turbidity currents, and the channel-levee system provide the unique opportunity for studying an active highstand system. Many fans showed this behavior only during lowered sea-level.

Physical properties of sediment cores of the Bengal Fan

We examined geophysical data from a Multi-Sensor Core Logger (MSCL), a logging device providing continuous measurements of gamma-ray attenuation, p-wave travel time, and magnetic susceptibility on marine sediment cores. In the first part we focused on the gamma-ray system and compared two different calibration methods. From the gamma-ray attenuation, we calculated densities and porosities by incorporating mass weighted attenuation coefficients. The application of an iteration method reduces the error of the density and porosity estimates compared to GRAPE data. In addition, we derived equations to calculate water content and dry bulk density from gamma-ray attenuation measurements. Comparison with physical properties determined on discrete samples revealed a very good correlation of both data sets (r = 0.99). This correlation is valid for sediments from substantially different geological settings (e.g., turbidites, hemipelagic muds, and opal-rich sediments). In the second part we applied our data to marine geological questions. For sediments from the Antarctic Polar Frontal Zone, there is indication that the content of biogenic opal can be assessed using a correlation of density and p-wave velocity. For sediments from the Bengal Fan, the relationship between the MSCL acoustic impedance (the product of density and p-wave velocity) and the grain-size distribution in discrete samples can be used to predict clay and sand/silt ratios for sediment cores from the shelf and upper continental slope.

Physical properties of 39 sediment cores from the Bengal Fan and northeast Indian Ocean

We obtained sediment physical properties and geochemical data from 47 piston and gravity cores located in the Bay of Bengal, to study the complex history of the Late Pleistocene run-off from the Ganges and Brahmaputra rivers and its imprint on the Bengal Fan. Grain-size parameters were predicted from core logs of density and velocity to infer sediment transport energy and to distinguish different environments along the 3000-km-long transport path from the delta platform to the lower fan. On the shelf, 27 cores indicate rapidly prograding delta foresets today that contain primarily mud, whereas outer shelf sediment has 25% higher silt contents, indicative of stronger and more stable transport regime, which prevent deposition and expose a Late Pleistocene relic surface. Deposition is currently directed towards the shelf canyon 'Swatch of No Ground', where turbidites are released to the only channel-levee system that is active on the fan during the Holocene. Active growth of the channel-levee system occurred throughout sea-level rise and highstand with a distinct growth phase at the end of the Younger Dryas. Coarse-grained material bypasses the upper fan and upper parts of the middle fan, where particle flow is enhanced as a result of flow-restriction in well-defined channels. Sandier material is deposited mainly as sheet-flow deposits on turbidite-dominated plains at the lower fan. The currently most active part of the fan with 10-40 cm thick turbidites is documented for the central channel including inner levees (e.g., site 40). Site 47 from the lower fan far to the east of the active channel-levee system indicates the end of turbidite sedimentation at 300 ka for that location. That time corresponds to the sea-level lowering during late isotopic stage 9 when sediment supply to the fan increased and led to channel avulsion farther upstream, probably indicating a close relation of climate variability and fan activity. Pelagic deep-sea sites 22 and 28 contain a 630-kyear record of climate response to orbital forcing with dominant 21- and 41-kyear cycles for carbonate and magnetic susceptibility, respectively, pointing to teleconnections of low-latitude monsoonal forcing on the precession band to high-latitude obliquity forcing. Upper slope sites 115, 124, and 126 contain a record of the response to high-frequency climate change in the Dansgaard-Oeschger bands during the last glacial cycle with shared frequencies between 0.75 and 2.5 kyear. Correlation of highs in Bengal Fan physical properties to lows in the d18O record of the GISP2 ice-core suggests that times of greater sediment transport energy in the Bay of Bengal are associated with cooler air temperatures over Greenland. Teleconnections were probably established through moisture and other greenhouse-gas forcing that could have been initiated by instabilities in the methane hydrate reservoir in the oceans.

Clay mineralogy of sediments from the Bengal Fan

We have measured the relative abundances of smectite, illite, chlorite, and kaolinite in a composite section of the distal Bengal Fan. Two sources of sediment appear to dominate, a smectite-poor, illite-rich source associated with rapid denudation of the Himalayas and a smectite-rich, illite-poor source probably on the continental margin of the Indian sub-continent. Changes in source appear to be related to uplift in the Himalayas and Tibetan Plateau both directly and through the climatic and oceanographic consequences of uplift.

Nd and Pb isotope data for DSDP and ODP sediments from the Bengal Fan

Correlation of new multichannel seismic profiles across the upper Indus Fan and Murray Ridge with a dated industrial well on the Pakistan shelf demonstrates that ~40% of the Indus Fan predates the middle Miocene, and ~35% predates uplift of the Murray Ridge (early Miocene, ~22 Ma). The Arabian Sea, in addition to the Makran accretionary complex, was therefore an important repository of sediment from the Indus River system during the Paleogene. Channel and levee complexes are most pronounced after the early Miocene, coincident with an increase in sedimentation rates. Middle Eocene sandstones from Deep Sea Drilling Project Site 224 on the Owen Ridge yield K-feldspars whose Pb isotopic composition, measured by in situ ion microprobe methods, indicates an origin in, or north of, the Indus suture zone. This observation requires that India-Asia collision had occurred by this time and that an Indus River system, feeding material from the suture zone into the basin, was active soon after collision. Pleistocene provenance was similar to that during the Eocene, albeit with greater contribution from the Karakoram. A mass balance of the erosional record on land with deposition in the fan and associated basins suggests that only ~40% of the Neogene sediment in the fan is derived from the Indian plate.

Sedimentary history and chemical characteristics of clay minerals from the Bengal Fan

The purpose of this study is to clarify the sedimentary history and chemical characteristics of clay minerals found in sediments deposited in the distal part of the Bengal Fan since the Himalayas were uplifted 17 m.y. ago. A total of seventy-eight samples were collected from three drilled cores which were to be used for the clay mineral analyses by means of XRD and ATEM. The results obtained from the analyses show that individual clay mineral species in the sediment samples at each site have similar features when the samples are of the same age, whereas these species have different features in samples of differing geological ages. Detrital clay minerals such as illite and chlorite were deposited in greater amounts than kaolinite and smectite during the Early to Middle Miocene. This means that the Himalayan uplift was vigorous at least until the Middle Miocene. In the Pliocene chemical weathering was more prevalent so that instead, in the distal part of the Bengal Fan, kaolinite shows the highest concentrations. This would accord with weaker uplift in the Himalayas. In the Pleistocene period, vigorous Himalayan uplift is characterized by illite-rich sediment in place of kaolinite. In the Holocene, smectite shows the highest concentration in place of the illite and kaolinite which were the predominant clay minerals of the earlier periods. Increasing smectite concentration suggests the Himalayan uplift to have been stable after the Pleistocene period. The smectite analyzed here is found to be dioctahedral Fe-beidellite, and it originated largely from the augite-basalt on the Indian Deccan Traps. The tri-octahedral chlorite is subdivided into three sub-species, an Fe-type, a Mg-type and an intermediate type. The mica clay mineral can be identified as di-octahedral illite which is rich in potassium. The chemical composition and morphology of each clay mineral appears to exhibit no change with burial depth in the sedimentary columns. This implies that there was no systematic transformation of clay minerals with time.