Geochemistry of the oceanic crust from ocean drilling samples

This book presents new data on chemical and mineral compositions and on density of altered and fresh igneous rocks from key DSDP and ODP holes drilled on the following main tectonomagmatic structures of the ocean floor: 1. Mid-ocean ridges and abyssal plains and basins (DSDP Legs 37, 61, 63, 64, 65, 69, 70, 83, and 91 and ODP Legs 106, 111, 123, 129, 137, 139, 140, 148, and 169); 2. Seamounts and guyots (DSDP Legs 19, 55, and 62 and ODP Legs 143 and 144); 3. Intraplate rises (DSDP Legs 26, 33, 51, 52, 53, 72, and 74 and ODP Legs 104, 115, 120, 121, and 183); and 4. Marginal seas (DSDP Legs 19, 59, and 60 and ODP Legs 124, 125, 126, 127, 128, and 135). Study results of altered gabbro from the Southwest Indian Ridge (ODP Leg 118) and serpentinized ultramafic rocks from the Galicia margin (ODP Leg 103) are also presented. Samples were collected by the authors from the DSDP/ODP repositories, as well as during some Glomar Challenger and JOIDES Resolution legs. The book also includes descriptions of thin sections, geochemical diagrams, data on secondary mineral assemblages, and recalculated results of chemical analyses with corrections for rock density. Atomic content of each element can be quantified in grams per standard volume (g/1000 cm**3). The suite of results can be used to estimate mass balance, but parts of the data need additional work, which depends on locating fresh analogs of altered rocks studied here. Results of quantitative estimation of element mobility in recovered sections of the upper oceanic crust as a whole are shown for certain cases: Hole 504B (Costa Rica Rift) and Holes 856H, 857C, and 857D (Middle Valley, Juan de Fuca Ridge).

(Table 1) Chemical composition of plagioclase and amphibole-pyroxene containing samples from pyroxene-amphibole-asbestos rock collected in the Hess Deep

Recent sediments with distinct signs of hydrothermal alteration sampled in the Hess Deep(Galapagos Ridge, East Pacific Rise) contained a piece of ash-gray rock, which differed from other rock fragments by degree of consolidation, conchoidal fracture, and had properties of asbestos. Our studies found that the sample represented mixture of asbestos-like pyroxene of diopside-hedenbergite composition, amphibole of tremolite composition and a new mineral, which basic structure consisted of bands of triple pyroxene chains with the radical [Si6O16]. The latter can be regarded as intermediate between amphiboles and layered silicates. Also in some parts of the sample presence of trioctahedral vermiculite-chlorite was indicated. Genesis of the studied asbestos rock is considered from the standpoint of high-temperature hydrothermal-metasomatic alteration of sediment by post-magmatic mineralized halide solutions.

Geochemistry of felsic rocks and minerals of ODP Hole 135-841B

A felsic volcanic series (605-825 mbsf) overlain by upper Eocene shallow-water sediments (500-605 mbsf) and basalticandesitic sills that intruded into sediments of Holocene to Miocene age (0-500 mbsf) was drilled in the forearc region of the Lau Basin at a water depth of 4810 m. The volcanic sequence at Site 841 includes altered and mineralized calc-alkaline rhyolites and dacites, dacitic tuffs, lapilli tuffs, flow breccias, and welded tuffs. These rocks formed subaerially or in a very shallow-water environment suffering a subsidence of >5000 m since Eocene times. Calculations of gains and losses of the major components during alteration show most pronounced changes in the uppermost 70 m of the volcanic sequence. Here, Al, Fe, Mg, and K are enriched, whereas Si and Na are strongly depleted. Illite, vermiculite, chlorite, and hematite predominate in this part of the hole. Throughout the section, quartz, plagioclase, kaolinite, and calcite are present. Sulfide mineralization (up to 10 vol%) consisting mainly of disseminated pyrite (with minor pyrrhotite inclusions) and marcasite together with minor amounts of chalcopyrite is pervasive throughout. Locally, a few sulfide-bearing quartz-carbonate veins as well as Ti-amphibole replacement by rutile and then by pyrite were observed. Strong variations in the As content of sulfides (from 0 to 0.69 wt%) from the same depth interval and local enrichments of Co, Ni, and Cu in pyrite are interpreted to result from fluctuations in fluid composition. Calculations of oxygen and sulfur fugacities indicate that fO2 and fS2 were high at the top and lower at the bottom of the sequence. Sulfur isotope determinations on separated pyrite grains from two samples give d34S values of +6.4ë and +8.4ë, which are close to those reported from Kuroko and Okinawa Trough massive sulfide deposits and calc-alkaline volcanic rocks of the Japanese Ryukyu Island Arc. Calculated chlorite formation temperatures of 265°-290°C at the top of the sequence are consistent with minimum formation temperatures of fluid inclusions in secondary quartz, revealing a narrow range of 270°-297°C. Chlorite formation temperatures are constant downhole and do not exceed 300°C. The presence of marcasite and 4C-type pyrrhotite indicates a formation temperature of <= 250°C. At a later stage, illite was formed at the top of the volcanic series at temperatures well below 200°C.

Diagenesis of siliceous particles in ODP Hole 114-699A

A number of neogenic opaline structures, not previously reported in the literature, as well as other neogenic phases are described from four Oligocene to Pliocene biosiliceous sediment samples from Hole 699A. The possible influence of microbes on the formation or the morphology of some of them is discussed. The samples, which are early Pliocene, early to middle Miocene, and late Oligocene (two) in age, were histologically fixed aboard ship upon retrieval. Investigations of the samples used SEM (with Edax/Tracor) and XRD methods. Diagenesis has affected all four samples, but the most extensive development of neoformed structures occurs in the Miocene and uppermost Oligocene samples, where microbial filaments (0.05 to 10 ?m long), microbial colonies, and siliceous microhemispheroids (0.2 to 0.7 µm diameter) were observed. The latter encrust filaments, diatoms, and detrital grains to varying degrees. Other neoformed structures include (1) flakes formed by coalesced microhemispheroids, some of which are guided by short, stubby filaments, which occur only in the Miocene and uppermost Oligocene samples, and (2) flakes characterized by smooth or microfissured surfaces, which grow on diatom frustules and in pore spaces and have a more widespread distribution. The XRD data indicate possible cristobalite formation in the Miocene and uppermost Oligocene samples; we believe that the neoformed opaline structures (encrusted filaments and microhemispheroids) may represent an early phase of opal-CT. The timing of neoformation of most of these features appears to have been fairly recent, continuing even at the time of sampling. There appears to be no direct correlation of this incipient, lower Miocene-uppermost Oligocene diagenetic layer and the pore-water chemistry profiles; a massive increase in shear strength in these sediments, however, may indicate some cementation. Smectite was identified by XRD as the most prominent clay mineral in these generally clay-poor sediments. Honeycombed minerals with filamentous edges, which could correspond to smectite, were observed with SEM in the pore spaces.

Physical properties, mineral and chemical compositions, and accumulation rates of Holocene and Upper Pleistocene bottom sediments from the Sea of Okhotsk

Mineral and chemical compositions and physical properties of diatomaceous clayey-siliceous sediments from the Sea of Okhotsk are studied. Accumulation rates of silica are determined. Their compositional model based on silica content is similar to that of Late Jurassic and Olenekian-Middle Anisian cherts from the Sikhote Alin region. Thickness of Holocene siliceous unit and accumulation rates of siliceous deposits depended on bioproductivity in the upper water layer and seafloor topography. Accumulation rates of amorphous SiO2 (0.05-5.7 g/cm**2/ka) and free SiO2 (0.5-11.6 g/cm**2/ka) are minimal on seamounts and maximal in depressions near foothills. These values match accumulation rates of free SiO2 in Triassic and Late Jurassic basins of the Sikhote Alin region (0.33-3 g/cm**2/ka). Comparison of composition and accumulation rates of silica shows that Triassic and Late Jurassic siliceous sequences of Sikhote Alin could accumulate in a marginal marine basin near a continent.

Mineralogy and geochemistry of latest Miocene deposits in the Tyrrhenian Sea

Late Miocene sediments from ODP Sites 652 and 654, drilled on the Sardinian margin in the Western Tyrrhenian Sea, are investigated through mineralogical, micromorphological, geochemical, and microgeochemical analyses. Clay associations appear to be little controlled by conditions of deposition, and largely depend on pre- and post-depositional conditions. The sedimentary series from Central Mediterranean gives very different geodynamic information, according to the sector considered. While relatively stable conditions, like those encountered in Caltanissetta Basin, Sicily, favor the mineralogical expression of warm-temperate and subarid Messinian climate, the Eastern Sardinia margin (Site 654) clay suites mainly reflect the transition from tectonically active to relaxed conditions. The series deposited at the foot of the same margin above a thinner crust (Site 652) experienced the effects of burial diagenesis, enhanced by strong geothermal gradient.

Grain shape and mineralogy of loess on New Zealands South Island

Infilled fissures are described from the interface between two loess deposits on Banks Peninsula, South Island, New Zealand. Both loesses differ from the other loesses by having a solifluction deposit at their base consisting of angular basalt fragments of the same angularity as fresh frost shattered basalt mixed with the loess. Typically, the fissures are narrow and up to 160 cm deep while the infilling of the overlying loess shows no obvious structure. They occur mainly at higher elevations on south (poleward) facing slopes, and the host loess forms a fragipan of high density. They are most readily explained as being seasonal frost fissures or more probably ice-wedge casts, which would have required either permafrost or deep seasonal frost for their formation. If permafrost had existed, this would imply a cooling of the mean annual temperatures by at least 16 to 18°C.

Climatic records of the late Holocene from sediment core GeoB9504-3 off Senegal

High-resolution climatic records of the late Holocene along the north-west African continental margin are scarce. Here we combine sediment grain size, elemental distribution and mineral assemblage data to trace dust and riverine sources at a shallow-marine sediment depocentre in the vicinity of the Senegal River mouth. The aim is to understand how these terrigenous components reflect climate variability during the late Holocene. Major element contents were measured and mineral identification was performed on three sub-fractions of our sediment core: (i) fluvial material <2 µm, (ii) aeolian material of 18-63 µm and (iii) a sub-fraction of dual-origin material of 2-18 µm. Results show that more than 80% of the total Al and Fe terrigenous bulk content is present in the fluviogenic fraction. In contrast, Ti, K and Si cannot be considered as proxies for one specific source off Senegal. The Al/Ca ratio, recording the continental river runoff, reveals two dry periods from 3010 to 2750 cal a BP and from 1900 to 1000 cal a BP, and two main humid periods from 2750 to 1900 cal a BP and from 1000 to 700 cal a BP. The match between (i) intervals of low river runoff inferred by low Al/Ca values, (ii) reduced river discharge inferred by integrated palynological data from offshore Senegal and (iii) periods of enhanced dune reactivation in Mali confirms this interpretation.