Pore water methane characteristics and sulphate reduction rates of ODP Leg 164 sediments

Anaerobic methane oxidation (AMO) was characterized in sediment cores from the Blake Ridge collected during Ocean Drilling Program (ODP) Leg 164. Three independent lines of evidence support the occurrence and scale of AMO at Sites 994 and 995. First, concentration depth profiles of methane from Hole 995B exhibit a region of upward concavity suggestive of methane consumption. Diagenetic modeling of the concentration profile indicates a 1.85-m-thick zone of AMO centered at 21.22 mbsf, with a peak rate of 12.4 nM/d. Second, subsurface maxima in tracer-based sulfate reduction rates from Holes 994B and 995B were observed at depths that coincide with the model-predicted AMO zone. The subsurface zone of sulfate reduction was 2 m thick and had a depth integrated rate that compared favorably to that of AMO (1.3 vs. 1.1 nmol/cm**2/d, respectively). These features suggest close coupling of AMO and sulfate reduction in the Blake Ridge sediments. Third, measured d13CH4 values are lightest at the point of peak model-predicted methane oxidation and become increasingly 13C-enriched with decreasing sediment depth, consistent with kinetic isotope fractionation during bacterially mediated methane oxidation. The isotopic data predict a somewhat (60 cm) shallower maximum depth of methane oxidation than do the model and sulfate reduction data.

Pore water isotopic ratios of CO2 and SO4, and sediment CH4 content of ODP Leg 164 sites

A unique set of geochemical pore-water data, characterizing the sulfate reduction and uppermost methanogenic zones, has been collected at the Blake Ridge (offshore southeastern North America) from Ocean Drilling Program (ODP) Leg 164 cores and piston cores. The d13C values of dissolved CO2 (sum CO2) are as 13C-depleted as -37.7 per mil PDB (Site 995) at the sulfate-methane interface, reflecting a substantial contribution of isotopically light carbon from methane. Although the geochemical system is complex and difficult to fully quantify, we use two methods to constrain and illustrate the intensity of anaerobic methane oxidation in Blake Ridge sediments. An estimate using a two-component mixing model suggests that ~24% of the carbon residing in the sum CO2 pool is derived from biogenic methane. Independent diagenetic modeling of a methane concentration profile (Site 995) indicates that peak methane oxidation rates approach 0.005 µmol/cm**3/yr, and that anaerobic methane oxidation is responsible for consuming ~35% of the total sulfate flux into the sediments. Thus, anaerobic methane oxidation is a significant biogeochemical sink for sulfate, and must affect interstitial sulfate concentrations and sulfate gradients. Such high proportions of sulfate depletion because of anaerobic methane oxidation are largely undocumented in continental rise sediments with overlying oxic bottom waters. We infer that the additional amount of sulfate depleted through anaerobic methane oxidation, fueled by methane flux from below, causes steeper sulfate gradients above methane-rich sediments. Similar pore water chemistries should occur at other methane-rich, continental-rise settings associated with gas hydrates.

Amino acids in interstitial waters from ODP Sites 126-790 and 126-791

Sites 790 and 791 lie in the eastern half graben of the Sumisu Rift, a backarc graben west of the active Izu-Bonin arc volcanoes Sumisu Jima and Tori Shima, at 30°54.96'N, 139°50.66'E, in 2223 m water depth and 30°54.97'N, 139°52.20'E, in 2268 m water depth, respectively. A small decrease in the sulfate concentration in the interstitial waters from these sites suggests fairly low microbial activity by sulfate-reducing bacteria. The values of the dissolved free amino acids (DFAA) in the interstitial waters from both sites range from 1.26 to 6.82 µmol/L, with an average of 3.81 µmol/L. The acidic, basic, neutral, aromatic, and sulfur-containing amino acids have average values of 0.32, 0.50, 2.71, 0.15, and 0.09 µmol/L, respectively. The relative abundances of the acidic, basic, neutral, aromatic, and sulfur-containing amino acids average 8, 13,72, 4, and 1 mol%, respectively. Glycine, serine, alanine, ornithine, and aspartic acid are major constituent amino acids. The dissolved combined amino acids (DCAA) values range between 1.25 and 44.35 µmol/L, with an average of 10.36 µmol/L. The mean concentrations and relative abundances of the acidic, basic, neutral, aromatic, and sulfur-containing amino acids are 2.29 (22 mol%), 0.60 (6 mol%), 6.70 (65 mol%), 0.09 (1 mol%), and 0.00 µmol/L (0 mol%), respectively. Glycine is the most abundant amino acid residue, followed by glutamic acid, serine, and alanine. The predominance of DCAA over DFAA present in the interstitial waters from Sites 790 and 791 is consistent with previous results from interstitial-water and seawater analyses. The most plausible source for the DCAA is biogenic calcareous debris. A much greater depletion of aspartic acid and the basic fraction, except for ornithine, is found in the DCAA. The decomposition of the basic amino acid fraction or its incorporation to clay minerals would result in a decrease in its relative abundance, whereas ornithine is produced during early diagenesis. The characteristics of the amino acids in the interstitial waters are (1) a greater depletion of the acidic amino acid fraction in the DFAA than in the DCAA and (2) the enrichment of glycine and serine in both. The adsorption or reaction of the amino acids in interstitial waters with biogenic carbonates would be responsible for the lower relative abundance of the acidic fraction of the DFAA. The production of glycine during early diagenesis and its stability in solution would raise its relative abundance in the interstitial waters.