606 resultados para Single reaction interface flow analysis
em Publishing Network for Geoscientific
Resumo:
The presence and abundance of anaerobic ammonium-oxidizing (anammox) bacteria was investigated in continental shelf and slope sediments (300-3000 m water depth) off northwest Africa in a combined approach applying quantitative polymerase chain reaction (q-PCR) analysis of anammox-specific 16S rRNA genes and anammox-specific ladderane biomarker lipids. We used the presence of an intact ladderane monoether lipid with a phosphocholine (PC) headgroup as a direct indicator for living anammox bacteria and compared it with the abundance of ladderane core lipids derived from both living and dead bacterial biomass. All investigated sediments contained ladderane lipids, both intact and core lipids, in agreement with the presence of anammoxspecific 16S rRNA gene copies, indicating that anammox occurs at all sites. Concentrations of ladderane core lipids in core top sediments varied between 0.3 and 97 ng g**-1 sediment, with the highest concentrations detected at the sites located on the shelf at shallower water depths between 300 and 500 m. In contrast, the C20 [3]-ladderane monoether-PC lipid was most abundant in a core top sediment from 1500 m water depth. Both anammox-specific 16S rRNA gene copy numbers and the concentration of the C20 [3]-ladderane monoether-PC lipid increased downcore in sediments located at greater water depths, showing highest concentrations of 1.2 x 10**8 copies g**-1 sediment and 30 pg g**-1 sediment, respectively, at the deepest station of 3000 m water depth. This suggests that the relative abundance of anammox bacteria is higher in sediments at intermediate to deep water depths where carbon mineralization rates are lower but where anammox is probably more important than denitrification.
Resumo:
Circulation of seawater through basaltic basement for several million years after crustal emplacement has been inferred from studies of surface heat flow, and may play a significant role in the exchange of elements between the oceanic crust and seawater. Without direct observation of the fluid chemistry, interpretations regarding the extent and timing of this exchange must be based on the integrated signal of alteration found in sampled basalts. Much interest has thus been expressed in obtaining and analyzing fluids directly from basaltic formations. It has been proposed that open oceanic boreholes can be used as oceanic groundwater wells to obtain fluids that are circulating within the formation. Water samples were collected from the open borehole in Hole 504B prior to drilling operations on Leg 137, with the original intention of collecting formation fluids from the surrounding basaltic rocks. Past results have yielded ambiguous conclusions as to the origin of the fluids recovered-specifically, whether or not the fluids were true formation fluids or merely the result of reaction of seawater in the borehole environment. The chemistry of eight borehole fluid samples collected during Leg 137 is discussed in this paper. Large changes in major, minor, and isotopic compositions relative to unaltered seawater were observed in the borehole fluids. Compositional changes increased with depth in the borehole. The samples exhibit the effect of simple mixing of seawater, throughout the borehole, with a single reacted fluid component. Analysis and interpretation of the results from Leg 137 in light of past results suggest that the chemical signals observed may originate predominantly from reaction with basaltic rubble residing at the bottom of the hole during the interim between drilling legs. Although this endeavor apparently did not recover formation waters, information on the nature of reaction between seawater and basalt at the prevalent temperatures in Hole 504B (>160°C) has been gained that can be related to reconstruction of the alteration history of the oceanic crust. Isotopic analyses allow calculation of element-specific water/rock mass ratios (Li and Sr) and are related to the extent of chemical exchange between the borehole fluids and basalt.
Resumo:
Most concentration profiles of sulfate in continental margin sediments show constant or continuously increasing gradients from the benthic boundary layer down to the deep sulfate reduction zone. However, a very marked change in this gradient has been observed several meters below the surface at many locations, which has been attributed to anoxic sulfide oxidation or to non-local transport mechanisms of pore waters. The subject of this study is to investigate whether this feature could be better explained by non-steady state conditions in the pore-water system. To this end, data are presented from two gravity cores recovered from the Zaire deep-sea fan. The sediments at this location can be subdivided into two sections. The upper layer, about 10 m thick, consists of stratified pelagic deposits representing a period of continuous sedimentation over the last 190 kyr. It is underlain by a turbidite sequence measuring several meters in thickness, which contains large crystals of authigenic calcium carbonate (ikaite: CaCO3·6H2O). Ikaite delta13C values are indicative of a methane carbon contribution to the CO2 pool. Radiocarbon ages of these minerals, as well as of the adjacent bulk sediments, provide strong evidence that the pelagic sediments have overthrust the lower section as a coherent block. Therefore, the emplacement of a relatively undisturbed sediment package is postulated. Pore-water profiles show the depth of the sulfate-methane transition zone within the turbiditic sediments. By the adaptation of a simple transport-reaction model, it is shown that the change in the geochemical environmental conditions, resulting from this slide emplacement, and the development towards a new steady state are fully sufficient to explain all features related to the pore-water profiles, particularly, [SO4]2- and dissolved inorganic carbon (DIC). The model shows that the downslope transport took place about 300 yr ago.