Boron isotopes, pH and pCO2 calculation for one Fiji coral specimen Porites (1898-1998), 2012

delta11B results and deduced pH, pCO2 and omega values obtained for a tropical coral specimen Porites collected in 1998 at Yasawa (16°48'S- 177°27'E) on the western side of the Fiji archipelago, location in the north western part of the Pacific Warm Pool. Such Porites specimen grew during the XXth century (1898-1998). Boron isotopes results allowed the reconstruction of surface ocean acidification in the vincinity of Fiji Islands with strong interdecadal influence of the ENSO at regional scale. pHT calculation parameters (Hönisch et al., 2007): a=0 PER MIL; alpha=0.9804; delta11B=39.5 PER MIL; salinity=35.02; pKB from Dickson (1990). pCO2 and omega calculation parameters: TA= 2350 µM; Ca= 10.2 mM; Dickson et al.(2007); Mucci 1983.

Calcite saturation and yield and Mg/Ca, Mn/Ca, Al/Ca, Fe/Ca for four species of planktic foraminifera cleaned using Mg-cleaning and Cd-cleaning methods

Four species of planktic foraminifera from core-tops spanning a depth transect on the Ontong Java Plateau were prepared for Mg/Ca analysis both with (Cd-cleaning) and without (Mg-cleaning) a reductive cleaning step. Reductive cleaning caused etching of foraminiferal calcite, focused on Mg-rich inner calcite, even on tests which had already been partially dissolved at the seafloor. Despite corrosion, there was no difference in Mg/Ca of Pulleniatina obliquiloculata between cleaning methods. Reductive cleaning decreased Mg/Ca by an average (all depths) of ~ 4% for Globigerinoides ruber white and ~ 10% for Neogloboquadrina dutertrei. Mg/Ca of Globigerinoides sacculifer (above the calcite saturation horizon only) was 5% lower after reductive cleaning. The decrease in Mg/Ca due to reductive cleaning appeared insensitive to preservation state for G. ruber, N. dutertrei and P. obliquiloculata. Mg/Ca of Cd-cleaned G. sacculifer appeared less sensitive to dissolution than that of Mg-cleaned. Mg-cleaning is adequate, but SEM and contaminants (Al/Ca, Fe/Ca and Mn/Ca) show that Cd-cleaning is more effective for porous species. A second aspect of the study addressed sample loss during cleaning. Lower yield after Cd-cleaning for G. ruber, G. sacculifer and N. dutertrei confirmed this to be the more aggressive method. Strongest correlations between yield and Delta[CO3^2-] in core-top samples were for Cd-cleaned G. ruber (r = 0.88, p = 0.020) and Cd-cleaned P. obliquiloculata (r = 0.68, p = 0.030). In a down-core record (WIND28K) correlation, r, between yield values > 30% and dissolution index, XDX, was -0.61 (p = 0.002). Where cleaning yield < 30% most Mg-cleaned Mg/Ca values were biased by dissolution.

Boron isotopes, trace elements and pH calculation for Norwegian deep sea coral specimen Madrepora o. (1968-2007), 2012

d11B and trace results obtained for a deep sea coral specimen Madrepora oculata collected from the Norwegian Sea (67°N, 9°E, 340 m) during the RV Polarstern ARK/II/Ia cruise (2007). Such coral specimen grew during the last four decades (1968-2007) and geochemical results highligh a seawater pH decrease with an order of magnitude in good agreement with an ocean acidification rate today known. This pH record is strongly impacted by inter-decadal change of ocean dynamic (NAO) and productivity. pHT calculation parameters (Hönisch et al., 2007): a=5; a=0.9804, d11B=39.5 PER MIL, Li/Mg temperature, salinity=35.1, pKB from Dickson (1990).