U/Th systematics of authigenic carbonates and d18O records from Hydrate Ridge, off the coast of Oregon, USA

Uranium (U) concentrations and activity ratios (d234U) of authigenic carbonates are sensitive recorders of different fluid compositions at submarine seeps of hydrocarbon-rich fluids ("cold seeps") at Hydrate Ridge, off the coast of Oregon, USA. The low U concentrations (mean: 1.3 ± 0.4 µg/g) and high 234U values (165-317 per mil) of gas hydrate carbonates reflect the influence of sedimentary pore water indicating that these carbonates were formed under reducing conditions below or at the seafloor. Their 230Th/234U ages span a time interval from 0.8 to 6.4 ka and cluster around 1.2 and 4.7 ka. In contrast, chemoherm carbonates precipitate from marine bottom water marked by relatively high U concentrations (mean: 5.2 ± 0.8 µg/g) and a mean d234U ratio of 166 ± 3 per mil. Their U isotopes reflect the d234U ratios of the bottom water being enriched in 234U relative to normal seawater. Simple mass balance calculations based on U concentrations and their corresponding d234U ratios reveal a contribution of about 11% of sedimentary pore water to the bottom water. From the U pore water flux and the reconstructed U pore water concentration a mean flow rate of about 147 ± 68 cm/a can be estimated. 230Th/234U ages of chemoherm carbonates range from 7.3 to 267.6 ka. 230Th/234U ages of two chemoherms (Alvin and SE-Knoll chemoherm) correspond to time intervals of low sealevel stands in marine isotope stages (MIS) 2, 4, 5, 6, 7 and 8. This observation indicates that fluid flow at cold seep sites sensitively reflects pressure changes of the hydraulic head in the sediments. The d18OPDB ratios of the chemoherm carbonates support the hypothesis of precipitation during glacial times. Deviations of the chemoherm d18O values from the marine d18O record can be interpreted as to reflect temporally and spatially varying bottom water and/or vent fluid temperatures during carbonate precipitation between 2.6 and 8.6°C.

Rb-Sr isotope systematics and Sr/Ca-Ba/Ca ratios at DSDP Hole 89-462A

Four samples of Nauru Basin basalts (Cores 94 to 109 of Hole 462A, sub-bottom depth 1077-1209 m) have 87Sr/86Sr ratios in the range 0.7037 to 0.7038, which is distinctly higher than the ratios of N-type MORB. The Rb contents of the samples are depleted in comparison with those of MORB and ocean-island basalts. These chemical and isotopic characteristics are identical to those of the basalts previously drilled during Leg 61 (Cores 75 to 90 of Hole 462A), and are explained in terms of inhomogeneity of the source region in the mantle or later alteration effects. Sr/Ca-Ba/Ca systematics of 15 samples from Cores 462A-94 to 462A-109 and 14 samples from Cores 462A-75 to 462A-90 suggest that the Nauru Basin basalts are derived from a mantle peridotite by 20 to 30% partial melting with subsequent Plagioclase crystallization.

Velocity-density systematics for basalts at DSPD Leg 54 Holes

Precise velocity and density measurements at atmospheric and elevated pressures have been obtained on basalts drilled in 13 holes during Leg 54. The vp-sigma data show systematics which are controlled by the degree of crystallinity (or conversely, glassiness), microstructure, and original mineralogy and chemistry. Extensively fractionated basalts with marked iron enrichment produce anomalously low measured velocities at densities above 2.90 g/cm**3. Also, the effective in situ pressure acting on Leg 54 basalts is less than hydrostatic, and perhaps close to zero. At zero effective pressure, the measured velocities average 2.5 km/s higher than East Pacific Rise upper crustal velocities determined by seismic refraction. This implies that the in situ velocities are undoubtedly a result of the highly fragmented nature of East Pacific Rise crust.

Seawater carbonate chemistry and zooxanthellate coral Cladocora caespitosa boron isotopic and elemental systematics during experiments, 2011

Boron isotopic and elemental systematics are used to define the vital effects for the temperate shallow water Mediterranean coral Cladocora caespitosa. The corals are from a range of seawater pH conditions (pHT ~ 7.6 to ~ 8.1) and environmental settings: (1) naturally living colonies harvested from normal pH waters offshore Levanto, (2) colonies transplanted nearby a subsea volcanic vent system, and (3) corals cultured in aquaria exposed to high (700 µatm) and near present day (400 µatm) pCO2 levels. B/Ca compositions measured using laser ablation inductively coupled mass spectrometry (LA-ICPMS) show that boron uptake by C. caespitosa cultured at different pCO2 levels is independent of ambient seawater pH being mainly controlled by temperature-dependent calcification. In contrast, the boron isotope compositions (delta11Bcarb) of the full suite of corals determined by positive thermal ionisation mass spectrometry (PTIMS) shows a clear trend of decreasing delta11Bcarb (from 26.7 to 22.2 %o) with decreasing seawater pH, reflecting the strong pH dependence of the boron isotope system. The delta11Bcarb compositions together with measurements of ambient seawater parameters enable calibration of the boron pH proxy for C. caespitosa, by using a new approach that defines the relationship between ambient seawater pH (pHsw) and the internally controlled pH at the site of calcification (pHbiol). C. caespitosa exhibits a linear relationship between pHsw and the shift in pH due to physiological processes (deltapH = pHbiol - pHsw) giving the regression deltapHClad = 4.80 - 0.52* pHsw for this species. We further apply this method ("deltapH-pHsw") to calibrate tropical species of Porites, Acropora, and Stylophora reported in the literature. The temperate and tropical species calibrations are all linearly correlated (r2 > 0.9) and the biological fractionation component (deltapH) between species varies within ~ 0.2 pH units. Our "deltapH-pHsw" approach provides a robust and accurate tool to reconstruct palaeoseawater pHsw for both temperate and tropical corals, further validating the boron fractionation factor (alphaB3-B4 = 1.0272) determined experimentally by Klochko et al. (2006) and the boron isotope pH proxy, both of which have been the foci of considerable debate.

Mn/Ca and Fe/Ca systematics in benthic foraminifera from the Peruvian OMZ

In this study we present an initial dataset of Mn/Ca and Fe/Ca ratios in tests of benthic foraminifera from the Peruvian oxygen minimum zone (OMZ) determined with SIMS. These results are a contribution to a better understanding of the proxy potential of these elemental ratios for ambient redox conditions. Foraminiferal tests are often contaminated by diagenetic coatings, like Mn rich carbonate- or Fe and Mn rich (oxyhydr)oxide coatings. Thus, it is substantial to assure that the cleaning protocols are efficient or that spots chosen for microanalyses are free of contaminants. Prior to the determination of the element/Ca ratios, the distributions of several elements (Ca, Mn, Fe, Mg, Ba, Al, Si, P and S) in tests of the shallow infaunal species Uvigerina peregrina and Bolivina spissa were mapped with an electron microprobe (EMP). To visualize the effects of cleaning protocols uncleaned and cleaned specimens were compared. The cleaning protocol included an oxidative cleaning step. An Fe rich phase was found on the inner test surface of uncleaned U. peregrina specimens. This phase was also enriched in Al, Si, P and S. A similar Fe rich phase was found at the inner test surface of B. spissa. Specimens of both species treated with oxidative cleaning show the absence of this phase. Neither in B. spissa nor in U. peregrina were any hints found for diagenetic (oxyhydr)oxide or carbonate coatings. Mn/Ca and Fe/Ca ratios of single specimens of B. spissa from different locations have been determined by secondary ion mass spectrometry (SIMS). Bulk analyses using solution ICP-MS of several samples were compared to the SIMS data. The difference between SIMS analyses and ICP-MS bulk analyses from the same sampling sites was 14.0-134.8 µmol mol-1 for the Fe/Ca and 1.68(±0.41) µmol mol-1 for the Mn/Ca ratios. This is in the same order of magnitude as the variability inside single specimens determined with SIMS at these sampling sites (1sigma[Mn/Ca] = 0.35-2.07 µmol mol-1; 1sigma[Fe/Ca] = 93.9-188.4 µmol mol-1). The Mn/Ca ratios in the calcite were generally relatively low (2.21-9.93 µmol mol-1) but in the same magnitude and proportional to the surrounding pore waters (1.37-6.67 µmol mol-1). However, the Fe/Ca ratios in B. spissa show a negative correlation to the concentrations in the surrounding pore waters. Lowest foraminiferal Fe/Ca ratios (87.0-101.0 µmol mol-1) were found at 465 m water depth, a location with a strong sharp Fe peak in the pore water next to the sediment surface and respectively, high Fe concentrations in the surrounding pore waters. Previous studies found no living specimens of B. spissa at this location. All these facts hint that the analysed specimens already were dead before the Fe flux started and the sampling site just recently turned anoxic due to fluctuations of the lower boundary of the OMZ near the sampling site (465 m water depth). Summarized Mn/Ca and Fe/Ca ratios are potential proxies for redox conditions, if cleaning protocols are carefully applied. The data presented here may be rated as base for the still pending detailed calibration.

Rb-Sr systematics of volcanic rocks and alteration minerals of ODP Hole 104-642E

Subaerially erupted tholeiites at Hole 642E were never exposed to the high-temperature seawater circulation and alteration conditions that are found at subaqueous ridges. Alteration of Site 642 rocks is therefore the product of the interaction of rocks and fluids at low temperatures. The alteration mineralogy can thus be used to provide information on the geochemical effects of low temperature circulation of seawater. Rubidium-strontium systematics of leached and unleached tholeiites and underlying, continentally-derived dacites reflect interactions with seawater in fractures and vesicular flow tops. The secondary mineral assemblage in the tholeiites consists mainly of smectite, accompanied in a few flows by the assemblage celadonite + calcite (+/- native Cu). Textural relationships suggest that smectites formed early and that celadonite + calcite, which are at least in part cogenetic, formed later than and partially at the expense of smectite. Smectite precipitation occurred under variable, but generally low, water/rock conditions. The smectites contain much lower concentrations of alkali elements than has been reported in seafloor basalts, and sequentially leached fractions of smectite contain Sr that has not achieved isotopic equilibrium. 87Sr/86Sr results of the leaching experiments suggest that Sr was mostly derived from seawater during early periods of smectite precipitation. The basalt-like 87Sr/86Sr of the most readily exchangeable fraction seems to suggest a late period of exposure to very low water /rock. Smectite formation may have primarily occurred in the interval between the nearly 58-Ma age given by the lower series dacites and the 54.5 +/- 0.2 Ma model age given by a celadonite from the top of the tholeiitic section. The 54.5 +/- 0.2 Ma Rb-Sr model age may be recording the timing of foundering of the Voring Plateau. Celadonites precipitated in flows below the top of the tholeiitic section define a Rb-Sr isochron with a slope corresponding to an age of 24.3 +/- 0.4 Ma. This isochron may be reflecting mixing effects due to long-term chemical interaction between seawater and basalts, in which case the age provides only a minimum for the timing of late alteration. Alternatively, inferrential arguments can be made that the 24.3 +/- 0.4 isochron age reflects the timing of the late Oligocene-early Miocene erosional event that affected the Norwegian-Greenland Sea. Correlation of 87Sr/86Sr and 1/Sr in calcites results in a two-component mixing model for late alteration products. One end-member of the mixing trend is Eocene or younger seawater. Strontium from the nonradiogenic endmember can not, however, have been derived directly from the basalts. Rather, the data suggest that Sr in the calcites is a mixture of Sr derived from seawater and from pre-existing smectites. For Site 642, the reaction involved can be generalized as smectite + seawater ++ celadonite + calcite. The geochemical effects of this reaction include net gains of K and CO2 by the secondary mineral assemblage. The gross similarity of the reactions involved in late, low-temperature alteration at Site 642 to those observed in other sea floor basalts suggests that the transfer of K and C02 to the crust during low-temperature seawater-ocean crust interactions may be significant in calculations of global fluxes.