179 resultados para SPIN-DENSITY-WAVE

em Publishing Network for Geoscientific


Relevância:

80.00% 80.00%

Publicador:

Resumo:

I analyzed Leg 57 sediments organogeochemically and spectroscopically. Organic carbon and extractable organic matter prevail from the Pliocene to the Miocene. Humic acids occur widely from the Pleistocene to the lower Miocene and one portion of the Oligocene. The absence of humic acids in Oligocene and Cretaceous samples suggests that humic acids had changed to kerogen. Visible spectroscopic data reveal that humic acids in this study have a low degree of condensed aromatic-ring system, which is a feature of anaerobic conditions during deposition, and that chlorophyll derivatives that had at first combined with humic acids moved to the solvent- soluble fraction during diagenesis. The elemental compositions of humic acids show high H/C and O/C ratios, which seem appropriate to a stage before transformation to kerogen. The relation between the linewidths and g-values on the electron spin resonance data indicates that the free radicals in humic acids are quite different from those in kerogen. The low spin concentrations of kerogen and the yields of humic acids up to the lower Miocene demonstrate that organic matter in these sediments is immature. The foregoing indicate the necessity to isolate humic acids even in ancient rocks in the study of kerogen.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

The effects of intrusive thermal stress have been studied on a number of Pleistocene sediment samples obtained from Leg 64 of the DSDP-IPOD program in the Gulf of California. Samples were selected from Sites 477, 478 and 481 where the organic matter was subjected to thermal stress from sill intrusions. For comparison purposes, samples from Sites 474 and 479 were selected as representative of unaltered material. The GC and GC-MS data show that lipids of the thermally unaltered samples were derived from microbial and terrestrial higher-plant detritus. Samples from sill proximities were found to contain thermally-derived distillates and those adjacent to sills contained essentially no lipids. Curie point pyrolysis combined with GC and GC-MS was used to show that kerogens from the unaltered samples reflected their predominantly autochthonous microbial origin. Pyrograms of the altered kerogens were much less complex than the unaltered samples, reflecting the thermal effects. The kerogens adjacent to the sills produce little or no pyrolysis products since these intrusions into unconsolidated, wet sediments resulted in in situ pyrolysis of the organic matter. Examination of the kerogens by ESR showed that spin density and line width pass through a maximum during the course of alteration but ESR g-values show no correlation with maturity. Stable carbon isotope (d13C) values of kerogens decrease by 1-1.5 per mil near the sills at Sites 477 and 481 and the atomic N/C decreases slightly with proximity to a smaller sill at Site 478. Differences in maturation behavior between Site 477 and 481 and Site 478 are attributed to dissimilarities in thermal stress and to chemical and isotopic heterogeneity of Guaymas Basin protokerogen.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

Isolated kerogens from four sites in the Middle Valley hydrothermal region of the Juan de Fuca Ridge (Ocean Drilling Project (ODP) Leg 139) were analysed by electron paramagnetic resonance (EPR) spectroscopy. Measurements of peak width, spin density and power saturation for site 857 kerogens, which increased regularly in maturity downhole, show correlation with vitrinite reflectance values from 0.61 to 2.5%, indicating the start of the oil window at depths from 200 to 400 m. Spin density increases to 1.56 * 10**17 spins per gram and peak width decreases to 3.45 G (gauss) with increasing depth. The tendency to power saturate also decreases with increasing maturity and increasing vitrinite reflectance within the oil window. These trends are consistent with a model in which exchange processes are occurring and cause changes in the EPR behavior of samples from this site. Sediments from other Middle Valley sites, 855, 856 and 858 contain large quantities of pyrite with Mn2+ impurities which interact with the carbon radical to distort the EPR measurements.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

Seismic velocities in rocks are influenced by the properties of the solid, the pore fluid, and the pore space. Cracks dramatically affect seismic velocities in rocks; their influence on the effective elastic moduli of rocks depends on their shape and concentration. Thin cracks (or fractures) substantially lower the moduli of a rock relative to the effect of spherical voids (or vesicles), and lower moduli are reflected by lower P- and S-wave velocities. The objective of this research is to determine the types and concentrations of cracks and their influence on the seismic properties of subaerially erupted basalts drilled from Hole 990A on the Southeast Greenland margin during Ocean Drilling Program Leg 163. Ellipsoidal cracks are used to model the voids in the rocks. The elastic moduli of the solid (grains) are also free parameters in the inverse modeling procedure. The apparent grain moduli reflect a weighted average of the moduli of the constituent minerals (e.g., plagioclase, augite, and clay minerals). The results indicate that (1) there is a strong relationship between P-wave velocity and porosity, suggesting a similarity of pore shape distributions, (2) the distribution of crack types within the massive, central region of aa flows from Hole 990A is independent of total porosity, (3) thin cracks are the first to be effectively sealed by alteration products, and (4) grain densities (an alteration index) and apparent grain moduli of the basalt samples are directly related.