Noble metal abundances in ODP Leg 115 basalts (Table 1)

A comparison of 50 basalts recovered at Sites 706, 707, 713, and 715 along the Reunion hotspot trace during Ocean Drilling Program Leg 115 in the Indian Ocean shows that seafloor alteration had little effect on noble metal concentrations (Au, Pd, Pt, Rh, Ru, and Ir), determined by inductively coupled plasma-mass spectrometry (ICP-MS), which generally tend to decrease with magma evolution. Their compatible-element behavior may be related to the precipitation of Ir-Os-based alloys, chromite, sulfides, and/or olivine and clinopyroxene in some combination. The simplest explanation indicates silicate control of concentrations during differentiation. Basalts from the different sites show varying degrees of alkalinity. Noble metal abundances tend to increase with decreasing basalt alkalinity (i.e., with increasing percentages of mantle melting), indicating that the metals behave as compatible elements during mantle melting. The retention of low-melting-point Au, Pd, and Rh in mantle sulfides, which mostly dissolve before significant proportions of Ir-Os-based alloys melt, explains increasing Pd/Ir ratios with decreasing alkalinity (increasing melting percentages) in oceanic basalts. High noble metal concentrations in Indian Ocean basalts (weighted averages of Au, Pd, Rh, Pt, Ru, and Ir in Leg 115 basalts are 3.2, 8.1, 0.31, 7.3, 0.22, and 0.11 ppb, respectively), compared with basalts from some other ocean basins, may reflect fundamental primary variations in upper- mantle noble metal abundances

(Table 5) Experimental hydrodynamic parameters for different soil types obtained in the Lüchow-Dannenberg district, Lower Saxony

In three typical sandy soils of Northern Germany the mobility of radioactive fission products of technetium, iodine, ruthenium and zirconium have been investigated in dependence of the hydrodynamic and physico-chemical soil properties. The laboratory experiments, which simulated fall-out events, used soil columns (1 m length, 30 cm diameter) taken as undisturbed as possible. By measurements of the breakthrough curves in the percolate and of the depth distribution of radionuclides in the soil columns after 6 months the average transport velocity could be determined. These values could be compared with the average water velocity measured by 3H tagging. Three qualitative mobility relations were observed: Ranker: Tc > Ru > I > Zr; Podsol: Tc > Ru > I > Zr; Brown forest soil: Tc = Ru > I > Zr. Relations between some physico-chemical soil properties and the retardation of radionuclides due to adsorption could be observed (eg. retardation of iodine and technetium by organic substances). The average retardation factors of the radionuclides and the hydrodynamic soil parameters are used in a model which gives a quantitative assessment of the hazard of groundwater contamination by a fall-out event in areas covered with comparable soils.

Composition of ferromanganese crusts from the Atlantic, Pacific and Indian Oceans

A collection of layered ferromanganese ores (27 samples) from the Atlantic and Pacific oceans was studied. Trace element and PGE contents were determined layer-by-layer (up to 10 microlayers) in 13 of these samples. The trace, rare earth, and platinum group element distributions, including their layer-to-layer variations, were compared in hydrogenic and hydrothermal crusts from different regions. It was found that the main PGE variations (by a factor of 10-50) are related to their layer-to-layer variations within a given ore field. The distributions of PGE and trace elements are strongly heterogeneous, which is related, first, to different contents of the elements in the layers of different age in ferromanganese crusts (FMC) and, second, to the observed regional heterogeneity and influence of hydrothermal fluids. Geochemical data indicate that CFC formation was mainly caused by the hydrochemical precipitation of material from seawater. This process was accompanied by diagenetic phenomena, water-rock interaction, and influence of volcanic and hydrothermal sources.

Contents of major and noble chemical elements in phosphorites and bottom sediments

Ag and Au are typically concentrated in phosphorites; they genetically related to organic matter of bottom sediments that extract these elements from seawater or interstitial water. Consequently, the phosphorites inherit Ag and Au from host sediments that are not always enriched in them. In contrast to other organic-rich sediments, analyzed sample of recent diatom ooze from the Namibian shelf is not enriched in Ag and Au, although some sediments from this region are enriched in Au. In addition to authigenic Au, allochthonous Au associated with quartz grains and micrograins can also be present in shelf phosphorites. This was observed in oceanic phosphorites of various types. Anomalous Au and Fe contents recorded in one seamount phosphorite sample can be related to extraction of Au and nonferrous metals by ferromanganese hydroxides from seawater. This process can serve as one of major mechanisms of Au supply to ferromanganese crusts on seamounts. Phosphorites and sediments are enriched in Ru simultaneously with U. Author's data show that U content varies from 17 (seamount phosphorite) to 887 ppm (Pleistocene phosphorite nodule from the Namibian shelf). This is probably caused by different types of behavior of light and heavy PGEs in the marine environment.

Mineralogy and geochemistry of sulfide minerals and bulk rocks from ODP Hole 176-735B

Ocean Drilling Program (ODP) Leg 176 built upon the work of ODP Leg 118 wherein the 500-m section that was sampled represented the most complete recovery of an intact portion of lower oceanic crust ever described. During Leg 176, we deepened Hole 735B to >1500 m below seafloor in an environment where gabbroic rocks have been tectonically exposed at the Southwest Indian Ridge. This new expedition extended the remarkable recovery (>85%) that allowed unprecedented investigations into the nature of the lower oceanic crust as a result of Leg 118. Sulfide mineral and bulk rock compositions were determined from samples in the 1000-m section of oceanic gabbros recovered during Leg 176. The sulfide assemblage of pyrrhotite, chalcopyrite, pentlandite, and troilite is present throughout this section, as it is throughout the 500-m gabbroic section above that was sampled during Leg 118. Troilite is commonly present as lamellae, and the only interval where troilite was not observed is from the uppermost 150 m of the section sampled during Leg 118, which is intensely metamorphosed. The common presence of troilite indicates that much of the sulfide assemblage from Hole 735B precipitated from a magmatic system and subsequently underwent low-temperature reequilibration. Evaluation of geochemical trends in bulk rock and sulfides indicates that the combined effects of olivine accumulation in troctolites and high pentlandite to pyrrhotite ratios account for the sporadic bulk rock compositions high in Ni. Bulk rock and sulfide mineral geochemical indicators that are spatially coincident with structural and physical properties anomalies indicate a heretofore unrecognized lithologic unit boundary in this section. Platinum-group element (PGE) compositions were also determined for 36 samples from throughout the section that were recovered during Leg 176. Whereas most samples had low (<0.4 ppb) PGE concentrations, rare samples had elevated PGE values, but no unique common trend between these samples is evident.

Geochemical provenance analysis of fine-grained sediment of sediment core AND1-1

Bulk chemical fine-grained sediment compositions from southern Victoria Land glacimarine sediments provide significant constraints on the reconstruction of sediment provenance models in the McMurdo Sound during Late Cenozoic time. High-resolution (~ 1 ka) geochemical data were obtained with a non-destructive AVAATECH XRF Core Scanner (XRF-CS) on the 1285 m long ANDRILL McMurdo Ice Shelf Project (MIS) sediment core AND-1B. This data set is complemented by high-precision chemical analyses (XRF and ICP-OES) on discrete samples. Statistical analyses reveal three geochemical facies which are interpreted to represent the following sources for the sediments recovered in the AND-1B core: 1) local McMurdo Volcanic Group (MVG) rocks, 2) Transantarctic Mountain rocks west of Ross Island (W TAM), and 3) Transantarctic Mountain rocks from more southerly areas (S TAM). Data indicate in combination with other sediment facies analyses (McKay et al., 2009, doi:10.1130/B26540.1) and provenance scenarios (Talarico and Sandroni, 2009, doi:10.1016/j.gloplacha.2009.04.007) that diamictites at the drill site are largely dominated by local sources (MVG) and are interpreted to indicate cold polar conditions with dry-based ice. MVG is interpreted to indicate cold polar condition with dry-based ice. A mixture of MVG and W TAM is interpreted to represent polar conditions and the S TAM facies is interpreted to represent open-marine conditions. Down-core variations in geochemical facies in the AND-1B core are interpreted to represent five major paleoclimate phases over the past 14 Ma. Cold polar conditions with major MVG influence occur below 1045 mbsf and above 120 mbsf. A section of warmer climate conditions with extensive peaks of S TAM influence characterizes the rest of the core, which is interrupted by a section from 525 to 855 mbsf of alternating influences of MVG and W TAM.

Platinum-group element abundances in background samples and the K-T boundary interval from DSDP Hole 91-596 (Table 2)

New data on Ru/Ir abundance ratios are presented for nonmarine (Hell Creek, Montana; Frenchman River, Saskatchewan) and marine Cretaceous-Tertiary boundary sites (Brazos River, Texas; Beloc, Haiti; DSDP 577 and DSDP 596). The Ru/Ir ratio varies from 0.5 to 1 within 4000 km of Chicxulub and increases to 2-3 at paleodistances (65 Ma) of up to 12,000 km from the impact site. For CI chondrites, Ru/Ir = 1.5. A ballistic model of ejecta cloud cooling and expansion, which employs the available vapor-pressure versus temperature data for Ru and It, predicts qualitatively similar global variation in the Ru/Ir ratio but by only a factor of 1.5. We infer that several other factors, such as remobilization of PGE during diagenesis, preferential oxidation of Ru, condensation kinetics and atmospheric chemical and circulation processes, may account for the observed larger Ru/Ir variation.

(Table 1) Platinoids in Fe-Mn crusts and nodules from the Pacific Ocean

Platinoid element contents were determined in 16 samples of Fe-Mn crusts and nodules collected during dredging deep-sea mound slopes of the Pacific Ocean from the equator to 27°N. The method of neutron activation analysis with pre-concentration of the platinoids was used for these determinations. There is no relationship between platinoid contents in deep-sea (>3000 m) Fe-Mn nodules with depth of sampling, as well as with age of nodule layers. It is concludet that ultramafic rocks are the primary source of platinoids in Fe-Mn nodules.

Precious metals and volatiles in rocks of the Mid-Atlantic Ridge near 15°20'N

Distribution patterns of gold, platinum group metals (PGE), and volatile components are studied in the main rock types of the Mid-Atlantic Ridge lithosphere (ultrabasites, gabbro, and basalts) from the transform fracture zone at 15°20'N. It is ascertained that PGE content depends on the reduction degree of fluids, on rock types, and on their formation conditions. It is noted that concentrations of refractory elements (Os, Ir, Rh) decrease, while those of fusible elements (Pt, Pd, Au) increase with depth. The chondrite type of distribution is only noted in the ultrabasite rocks. Increase in water and CO2 contents and in oxidation degree of fluids occurs with transition from basalts to ultrabasites, as well as from normal magmatic systems to fluid-enriched anomalous systems.