Geochemistry of phosphatic crusts from the shelf off Peru

Authigenic phosphorite crusts from the shelf off Peru (9°40°S to 13°30°S) consist of a facies with phosphatic coated grains covered by younger phosphatic laminite. The crusts are composed of carbonate fluorapatite, which probably formed via an amorphous precursor close to the sediment water interface as indicated by low F/P2O5 ratios, Sr and Ca isotopes, as well as rare earth element patterns agreeing with seawater-dominated fluids. Small negative Ce anomalies and U enrichment in the laminite suggest suboxic conditions close to the sediment-water interface during its formation. Increased contents of chalcophilic elements and abundant sulfide minerals in the facies with phosphatic coated grains as well as in the laminite denote sulfate reduction and, consequently, point to episodical development of anoxic conditions during phosphogenesis. The Peruvian phosphorites formed episodically over an extended period of time lasting from Middle Miocene to Pleistocene. Individual phosphatic coated grains show a succession of phosphatic layers with varying contents of organic matter and sulfide-rich phosphatic layers. Coated grains supposedly formed as a result of episodic suspension caused by high turbulence and shifting redox conditions. Episodic anoxia in the pore water induced pyritization in the outermost carbonate fluorapatite layer. Phosphatic coated grains were later transported to the place of crust formation, where subsequent laminite formation was favored under lower energy conditions. A similar succession of phosphatic layers with varying contents of organic matter and sulfide-rich layers in the laminite suggests a formation mechanism analogous to that of individual coated grains.

Lagrangian back-tracing results for Kohnen station; output of time dependent numerical experiment with a 3D nested Antarctic ice sheet model

A nested ice flow model was developed for eastern Dronning Maud Land to assist with the dating and interpretation of the EDML deep ice core. The model consists of a high-resolution higher-order ice dynamic flow model that was nested into a comprehensive 3-D thermomechanical model of the whole Antarctic ice sheet. As the drill site is on a flank position the calculations specifically take into account the effects of horizontal advection as deeper ice in the core originated from higher inland. First the regional velocity field and ice sheet geometry is obtained from a forward experiment over the last 8 glacial cycles. The result is subsequently employed in a Lagrangian backtracing algorithm to provide particle paths back to their time and place of deposition. The procedure directly yields the depth-age distribution, surface conditions at particle origin, and a suite of relevant parameters such as initial annual layer thickness. This paper discusses the method and the main results of the experiment, including the ice core chronology, the non-climatic corrections needed to extract the climatic part of the signal, and the thinning function. The focus is on the upper 89% of the ice core (appr. 170 kyears) as the dating below that is increasingly less robust owing to the unknown value of the geothermal heat flux. It is found that the temperature biases resulting from variations of surface elevation are up to half of the magnitude of the climatic changes themselves.

Sedimentary history and chemical characteristics of clay minerals from the Bengal Fan

The purpose of this study is to clarify the sedimentary history and chemical characteristics of clay minerals found in sediments deposited in the distal part of the Bengal Fan since the Himalayas were uplifted 17 m.y. ago. A total of seventy-eight samples were collected from three drilled cores which were to be used for the clay mineral analyses by means of XRD and ATEM. The results obtained from the analyses show that individual clay mineral species in the sediment samples at each site have similar features when the samples are of the same age, whereas these species have different features in samples of differing geological ages. Detrital clay minerals such as illite and chlorite were deposited in greater amounts than kaolinite and smectite during the Early to Middle Miocene. This means that the Himalayan uplift was vigorous at least until the Middle Miocene. In the Pliocene chemical weathering was more prevalent so that instead, in the distal part of the Bengal Fan, kaolinite shows the highest concentrations. This would accord with weaker uplift in the Himalayas. In the Pleistocene period, vigorous Himalayan uplift is characterized by illite-rich sediment in place of kaolinite. In the Holocene, smectite shows the highest concentration in place of the illite and kaolinite which were the predominant clay minerals of the earlier periods. Increasing smectite concentration suggests the Himalayan uplift to have been stable after the Pleistocene period. The smectite analyzed here is found to be dioctahedral Fe-beidellite, and it originated largely from the augite-basalt on the Indian Deccan Traps. The tri-octahedral chlorite is subdivided into three sub-species, an Fe-type, a Mg-type and an intermediate type. The mica clay mineral can be identified as di-octahedral illite which is rich in potassium. The chemical composition and morphology of each clay mineral appears to exhibit no change with burial depth in the sedimentary columns. This implies that there was no systematic transformation of clay minerals with time.

Chromatographic fractionation of bitumen from sediments and presence of glycerol ethers in immature sediments (Table 2)

Alkanes having unusual saturated isoprenoidal and methyl-branched structures have been isolated from the bitumen of several sediments. The methanogenic biomarkers 2,6,10,15,19-pentamethyleicosane and squalane were found in sediments which also contained bacteriogenic glycerol ethers. However, in one ether-containing sediment, 2,6,10,13,17,21-hexamethyldocosane was tentatively identified and this compound was found in place of the established alkane biomarkers. Other hydrocarbons found were regular C21 and C23 isoprenoid alkanes, compounds which cannot be derived from phytol; two isoprenoids of the type 3,7,11.-polymethylalkane, previously reported only in petroleums; 8-methylheptadecane, a probable biomarker for cyanobacteria and a number of its homologs and other methyl-branched alkanes. Ubiquitous branched-chain alkylbenzenes and a homology of trimethylalkylbenzenes were also isolated. Most, or all, of the compounds reported here are probably not catagenetic products but may represent direct algal or bacterial bioinputs.