Composition of Eocene claystones of ODP Hole 105-647A

Authigenic carbonates were recovered in lower to middle Eocene claystones at Ocean Drilling Program Site 647 in the Labrador Sea. Detailed chemical, petrographic, and X-ray investigations reveal that these diagenetic carbonates have a complex mineralogical composition. At least five different carbonate phases are identified: calcium-rich rhodochrosite, rhodochrosite, manganosiderite, siderite, and calcite. Manganese carbonates are the dominant carbonate phases formed throughout the section. Textural analyses show two major generations of carbonate formation. Early cementation of micritic carbonate in burrow structures was followed by carbonate cementation forming microsparry to sparry crystals. At approximately 620 meters below seafloor (mbsf), three concretions of iron carbonates occur, which indicates a special pore-water chemistry. Thin section analyses from this level show (1) several generations of diagenetic carbonates, (2) widespread secondary cavity formation in burrow structures, and (3) various cement precipitations in voids. We suggest that this level represents a hiatus or highly condensed sequence, as indicated by (1) the low carbonate content in host sediments, (2) carbonate dissolution reflected by the high ratio of benthic to planktonic foraminifers, and (3) complex diagenetic alteration in the carbonate concretions. Iron and manganese enrichments observed in lithologic Unit IV may have been derived from a hydrothermal source at the adjacent, then active, Labrador Sea mid-ocean ridge. Authigenic smectites forming numerous pseudomorphs of siliceous microfossils are precipitated in burrow structures. We propose that diagenetic smectite formation from biogenic opal and iron oxyhydroxide (analogous to smectite formation in surface sediments of the East Pacific area) occurred in the Labrador Sea during the early and middle Eocene.

(Table 1) Stable-isotope and eolian grain size data across the Paleocene/Eocene boundary from DSDP Hole 22-215

Deep Sea Drilling Project (DSDP) Site 215 provides an expanded section across the Paleocene/Eocene boundary, the most complete mid-latitude sequence from a Southern Hemisphere location in the Indo-Pacific area. The events of this transition occurred during a span of about 1.2 m.y. Oxygen isotope values derived from benthic foraminiferal calcite decrease by about 1.0 per mil, a decrease most likely related to warming of deep ocean waters. Turnovers of benthic foraminifera accompany d18O changes and culminate in the predominant extinction event at the end of the Paleocene Epoch. Carbon isotope ratios also shift dramatically toward lighter values near the end of the Paleocene, beginning about 0.45 m.y. after oxygen isotope values start to change. The intensity of Southern Hemisphere atmospheric circulation as recorded by grain sizes of eolian particles shows a large and rapid reduction beginning another 0.45 m.y. later. A significant reduction of zonal wind strength at the Paleocene/Eocene boundary, until now observed only at Northern Hemisphere locations, appears to have been a global phenomenon related to decreased latitudinal thermal gradients occasioned by more effective poleward heat transport via the deep ocean.

Chemical composition of Late Cenozoic volcanic and volcaniclastic deposits from the western Woodlark Basin area, SW Pacific

Tephra fallout layers and volcaniclastic deposits, derived from volcanic sources around and on the Papuan Peninsula, form a substantial part of the Woodlark Basin marine sedimentary succession. Sampling by the Ocean Drilling Program Leg 180 in the western Woodlark Basin provides the opportunity to document the distribution of the volcanically-derived components as well as to evaluate their chronology, chemistry, and isotope compositions in order to gain information on the volcanic sources and original magmatic systems. Glass shards selected from 57 volcanogenic layers within the sampled Pliocene-Pleistocene sedimentary sequence show predominantly rhyolitic compositions, with subordinate basaltic andesites, basaltic trachy-andesites, andesites, trachy-andesites, dacites, and phonolites. It was possible to correlate only a few of the volcanogenic layers between sites using geochemical and age information apparently because of the formation of strongly compartmentalised sedimentary realms on this actively rifting margin. In many cases it was possible to correlate Leg 180 volcanic components with their eruption source areas based on chemical and isotope compositions. Likely sources for a considerable number of the volcanogenic deposits are Moresby and Dawson Strait volcanoes (D'Entrecasteaux Islands region) for high-K calc-alkaline glasses. The Dawson Strait volcanoes appear to represent the source for five peralkaline tephra layers. One basaltic andesitic volcaniclastic layer shows affinities to basaltic andesites from the Woodlark spreading tip and Cheshire Seamount. For other layers, a clear identification of the sources proved impossible, although their isotope and chemical signatures suggest similarities to south-west Pacific subduction volcanism, e.g. New Britain and Tonga- Kermadec island arcs. Volcanic islands in the Trobriand Arc (for example, Woodlark Island Amphlett Islands and/or Egum Atoll) are probable sources for several volcaniclastic layers with ages between 1.5 to 3 Ma. The Lusancay Islands can be excluded as a source for the volcanogenic layers found during Leg 180. Generally, the volcanogenic layers indicate much calc-alkaline rhyolitic volcanism in eastern Papua since 3.8 Ma. Starting at 135 ka, however, peralkaline tephra layers appear. This geochemical change in source characteristics might reflect the onset of a change in geotectonic regime, from crustal subduction to spreading, affecting the D'Entrecasteaux Islands region. Initial 143Nd/144Nd ratios as low as 0.5121 and 0.5127 for two of the tephra layers are interpreted as indicating that D'Entrecasteaux Islands volcanism younger than 2.9 Ma occasionally interacted with the Late Archean basement, possibly reflecting the mobilisation of the deep continental crust during active rift propagation.

Mapping of the Eltanin impact area in the South-East Pacific

Two Polarstern expeditions were conducted in 1995 (ANT-XII/4) and 2001 (ANT-XVIII/5a) to the Bellingshausen Sea and Amundsen Sea and the suspected Eltanin meteorite impact in the SE-Pacific. A survey of the sediment distribution and its acoustic structure along the cruise track was performed. The seafloor topography was sampled using the multibeam sonar system Hydrosweep DS2 which operates on a frequency of 15.5 kHz. The resulting AWI Bathymetric Chart of the Eltanin Meteorite Impact Area is based on a Digital Terrain Model of this area. The mapping was performed using ArcGIS. The Eltanin impact area which covers the 4.100 m high Freden Seamount is visualized by one overview sheet of the scale 1:200,000 and four 1:100,000 subsheets.

(Table 1) Contents of tungsten and other metals in Fe-Mn nodules from the Pacific Ocean

Tungsten contents in iron-manganese nodules and crusts from different parts of the World Ocean, as well as its relationships with a number of chemical elements are under consideration. A trend to correlation of tungsten with Fe, Ti, W, Pb, and Co is noticed. Comparison of tungsten contents in the nodules and host sediments indicates its low geochemical mobility.