(Table 1) Redox potential and chemical element contents in CaCO3 and amorphous silica free matter in surface layer bottom sediments of the Pacific Ocean from Hawaiian Islands to Mexico coast

Distribution of Fe, Mn, P, Ti, Cu, Ni, Co, V, Cr, W, Mo, and As in the surface sediment layer on the section from the Hawaiian Islands to the coast of Mexico (Mexico section) is studied. Contents of all studied elements increase from biogenic-terrigenous sediments off the coast of Mexico to pelagic red clays of the Northeast Basin, and more sharply for mobile elements - Mn, Mo, Cu, Ni, Co, and As. In near Hawaii sediments rich in coarsely fragmented volcanic-terrigenous and pyroclastic material of basaltic composition with high contents of Ti, Fe, V, Cr, W, and P, contents of these elements increase sharply, and contents of Mn, Mo, Ni, Co, and Cu for the same reason decrease sharply in comparison with red clay. Abnormally high contents of Mn, Mo, Cu, Ni, Co, and As in the upper layer of hemipelagic and transition sediments of the Mexico section result from diagenetic redistribution and their accumulation on the surface. Processes of diagenetic redistribution in hemipelagic and transition sediment mass of the Mexico section are more rapid than in similar sediments of the Japan section due lower sedimentation rates and higher initial concentrations of Mn. Basic similarity of element distribution regularities in sediments of Japan and Mexico sections is shown.

Concentration of hydrogen sulfide in waters of the Black Sea in the layer of its coexistence with oxygen

About 100 parallel determinations of hydrogen sulfide by the volumetric and photometric methods were made in the layer of coexistence of oxygen with hydrogen sulfide (C layer). Thiosulfates were determined simultaneously. Regardless of locations of the stations, determinations by two methods coincided for the entire range of depths of occurrence of the C layer upper boundary. Within the C layer hydrogen sulfide readings obtained by these two independent methods agreed; thiosulfates were not found by direct measurements. Difference in the readings appears at the lower boundary of the C layer and below it, accompanied by appearance of thiosulfates. It is therefore concluded that it is correct to determine the upper boundary of the C layer by the iodometric method and to use concentration of hydrogen sulfide obtained by this method in the C layer to calculate rate of chemical oxidation of hydrogen sulfide in quasistationary processes.

Rates of sulfide formation and oxidation in the Black Sea waters in February-April 1991

Rate of hydrogen sulfide oxidation in the redox zone of the Black Sea and rate of hydrogen sulfide formation due to bacterial sulfate reduction in the upper layer of anaerobic waters were measured in February-April 1991. These measurements were made using sulfur radioisotope under conditions close to those in situ. It was established that hydrogen sulfide is oxidized in the layer of oxygen and hydrogen sulfide coexistence under the upper boundary of the hydrogen sulfide layer. Maximum rate of hydrogen sulfide oxidation was recorded within the limits of density values dT of 16.20-16.30, while varying in the layer from 2 to 4.5 µmol/day. The average rate of hydrogen sulfide oxidation was 1.5-3 times higher than that during the warm season. Sulfide formation was not observed at most of the stations in the examined lower portion of the pycnocline layer (140 to 400 m). Noticeable sulfate reduction was detected only at one station on the northwestern shelf. Intensified hydrodynamics in the upper layers of the water mass during the cold season can be a probable reason for such noticeable changes in sulfur dynamics in the water mass of the Black Sea. Data suggesting that hydrogen sulfide oxidation proceeds under the hydrogen sulfide boundary indicate absence of the so-called "suboxic zone" in this basin.

(Table 1) Iron and manganese speciations in surface layer bottom sediments of the Pacific Ocean

Distribution of iron and manganese speciations in ocean sediments of a section from the coast of Japan to the open Pacific Ocean is under consideration. Determinations of total iron, as well as of reactive iron contents and of total manganese, as well as of Mn4+ contents have been done. Significant increase of total Fe content in sediments from the coast to the pelagic zone occurs without noticeable increase in reactive Fe content. Presence of layers of volcanic and terrigenous coarse clastic material in clayey sediments results to sharp change in iron content. Manganese content increases from near coastal to pelagic sediments more than 10 times; oxidation degree of sediments also increases. There are three types of bottom sediments different by contents of iron and manganese forms: reduced, oxidized (red clay), and transitional. Content of total Fe is almost does not change with depth in sediments, content of reactive Fe increases in reduced sediments, and decreases in oxidized ones. Manganese content in red clay mass increases several times.