Bone metabolic and hormonal characteristics of Australian Antarctic expeditioners

Summary: Serum 25(OH)D levels decline without sunlight exposure. We studied 120 expeditioners to Antarctica to determine the skeletal and hormonal responses to sunlight deprivation. With emerging vitamin D insufficiency, serum calcium decreased, PTH increased, and bone loss at the proximal femur was observed. Baseline serum 25(OH)D levels >100 nmol/L prevented vitamin D insufficiency. Introduction: Vitamin D stores deplete without adequate sunlight exposure unless supplementation is provided. We studied 120 healthy adults who spent a year in Antarctica as a model for sunlight deprivation to define the timing and magnitude of the skeletal and hormonal responses to emerging vitamin D insufficiency. Methods: Fasting blood samples were assessed at baseline, 6 and 12 months for serum 25-hydroxyvitamin D (25(OH)D), osteocalcin (OC), bone formation (P1NP) and resorption (CTx), PTH and calcium. Lumbar spine and proximal femur BMD was measured using DXA. Differences over time were determined using repeated measures ANOVA. Percent changes were expressed as (Delta value/(value A +value B)/2)x100. Relationships between outcome measures were determined using Spearman's correlations. Results: Vitamin D insufficiency (<50 nmol/L) was observed in 85% of expeditioners by 6 months when serum calcium decreased and PTH increased (p<0.01). By 12 months, OC increased by 7.4±3.0% (p<0.05), and BMD decreased by 1.0±2.0% at the total proximal femur (p<0.05). For those with vitamin D sufficiency at baseline (>50 nmol/L), sunlight deprivation produced vitamin D insufficiency within 4 months unless baseline values were >100 nmol/L. Conclusion: Supplementation may be necessary for expeditioners with limited access to UV light.

Physical, Geochemical, Geomechanical, Geophysical and Hydrodynamic Characterization and Anisotropy Assessment of Corvio Sandstone

Corvio sandstone is a ~20 m thick unit (Corvio Formation) that appears in the top section of the Frontada Formation (Campoó Group; Lower Cretaceous) located in Northern Spain in the southern margin of the Basque-Cantabrian Basin. Up to 228 plugs were cored from four 0.3 x 0.2 x 0.5 m blocks of Corvio sandstone, to perform a comprehensive characterization of the physical, mineralogical, geomechanical, geophysical and hydrodynamic properties of this geological formation, and the anisotropic assessment of the most relevant parameters. Here we present the first data set obtained on 53 plugs which covers (i) basic physical and chemical properties including density, porosity, specific surface area and elementary analysis (XRF - CHNS); (ii) the curves obtained during unconfined and confined strengths tests, the tensile strengths, the calculated static elastic moduli and the characteristic stress levels describing the brittle behaviour of the rock; (iii) P- and S-wave velocities (and dynamic elastic moduli) and their respective attenuation factors Qp and Qs, electrical resistivity for a wide range of confining stress; and (iv) permeability and transport tracer tests. Furthermore, the geophysical, permeability and transport tests were additionally performed along the three main orthogonal directions of the original blocks, in order to complete a preliminary anisotropic assessment of the Corvio sandstone.

Physical properties, mineral and chemical compositions, and accumulation rates of Holocene and Upper Pleistocene bottom sediments from the Sea of Okhotsk

Mineral and chemical compositions and physical properties of diatomaceous clayey-siliceous sediments from the Sea of Okhotsk are studied. Accumulation rates of silica are determined. Their compositional model based on silica content is similar to that of Late Jurassic and Olenekian-Middle Anisian cherts from the Sikhote Alin region. Thickness of Holocene siliceous unit and accumulation rates of siliceous deposits depended on bioproductivity in the upper water layer and seafloor topography. Accumulation rates of amorphous SiO2 (0.05-5.7 g/cm**2/ka) and free SiO2 (0.5-11.6 g/cm**2/ka) are minimal on seamounts and maximal in depressions near foothills. These values match accumulation rates of free SiO2 in Triassic and Late Jurassic basins of the Sikhote Alin region (0.33-3 g/cm**2/ka). Comparison of composition and accumulation rates of silica shows that Triassic and Late Jurassic siliceous sequences of Sikhote Alin could accumulate in a marginal marine basin near a continent.

Chemical and mineral compositions of bottom sediments from the Sea of Japan

Physical properties (water content, bulk density, magnetic susceptibility, natural remanent magnetization, nature of magnetization, and composition of ferromagnetic fraction), chemical, and (optionally) mineral composition of bottom sediments from the north-west Sea of Japan have been studied. Their stratigraphic subdivision based on composition of diatoms has been carried out. Obtained data have allowed to find out some aspects of influence of paleogeographic conditions and diagenetic processes on change of physical properties of the sediments, as well as on their composition in Holocene and Late Pleistocene.

Sedimentation rate, bulk density, accumulation rate of terrigenous material and grain sizes of ODP Leg 167 sites

The terrigenous mineral fraction of sediments recovered by drilling during Ocean Drilling Program Leg 167 at Sites 1018 and 1020 is used to evaluate changes in the source and transport of fine-grained terrigenous sediment and its relation to regional climates and the paleoceanographic evolution of the California Current system during the late Pleistocene. Preliminary time scales developed by correlation of oxygen isotope stratigraphies with the global SPECMAP record show average linear sedimentation rates in excess of 100 m/m.y., which provide an opportunity for high-resolution studies of terrigenous flux, grain size, and mineralogy. The mass flux of terrigenous minerals at Site 1018 varies from 5 to 30 g/(cm**2 x k.y.) and displays a general trend toward increased flux during glacials. The terrigenous record at Site 1020 shows a similar pattern of increased glacial input, but overall accumulation rates are significantly lower. Spectral analysis demonstrates that most of this variability is concentrated in frequency bands related to orbital cycles of eccentricity, tilt, and precession. Detailed grain-size analysis performed on the isolated terrigenous mineral fraction shows that sediments from Site 1018 are associated with higher energy transport and depositional regimes than those found at Site 1020. Grain-size data are remarkably uniform throughout the last 500 k.y., with no discernible difference observed between glacial and interglacial size distributions within each site. X-ray diffraction analysis of the <2-µm clay component suggests that the deposition of minerals found at Site 1020 is consistent with transport from a southern source during intervals of increased terrigenous input.

Chemical and mineral compositions of basalts from the Pacific Ocean, DSDP data

Mineral and chemical alterations of basalts were studied in the upper part of the ocean crust using data of deep-sea drilling from D/S Glomar Challenger in the main structures of the Pacific floor. Extraction of majority of chemical elements (including heavy metals) from basalts results mainly from their interaction with heated sea water. As a result mineralized hydrothermal solutions are formed. On entering the ocean they influence greatly on ocean sedimentation and ore formation.

Cenozoic record of continental mineral deposit on Broken and Ninetyeast Ridges, Indian Ocean

The mineral component of pelagic sediments recovered from the Indian Ocean provides both a history of eolian deposition related to climatic changes in southern Africa and a record of terrigenous input related to sediment delivery from the Himalayas. A composite Cenozoic dust flux record from four sites in the central Indian Ocean is used to define the evolution of the Kalahari and Namib desert source regions. The overall record of dust input is one of very low flux for much of the Cenozoic indicating a long history of climate stability and regional hyperaridity. The most significant reduction in dust flux occurred near the Paleocene/Eocene boundary and is interpreted as a shift from semiarid climates during the Paleocene to more arid conditions in the early Eocene. Further aridification is recorded as stepwise reductions in the input of dust material which occur from about 35 to 40 Ma, 27 to 32 Ma, and 13 to 15 Ma and correlate to significant enrichments in benthic foraminifer delta18O values. The mineral flux in sediments from the northern Indian Ocean, site 758, records changes in the terrigenous input apparently related to the erosion of the Himalayas and indicates a rapid late Cenozoic uplift history. Three major pulses of increased terrigeneous sediment flux are inferred from the depositional record. The initial increase began at about 9.5 Ma and continued for roughly 1.0 million years. A second pulse with approximately the same magnitude occurred from about 7.0 to 5.6 Ma. The largest pulse of enhanced terrigenous influx occurred during the Pliocene from about 3.9 to 2.0 Ma when average flux values were severalfold greater than at any other time in the Cenozoic.