(Table 1) Composition of clay minerals in DSDP Hole 75-532

An investigation of the quantitative composition of the coarse (> 40 µm) and clay (< 2 µm) fraction of HPC 532, DSDP Leg 75, in 1300 m water depth on the eastern Walvis Ridge off Southwest Africa yielded the following results: (1) The sediments reflect a complete Latest Miocene to Recent depositional history. Sedimentation rates vary between 2.3 and 7.8 cm/ka. (2) Preservation of calcium carbonate is subject to strong variations: short-term (< 100,000 years) and long-term (about 1 m.y.) cycles in carbonate dissolution have been observed, with strongest dissolution occurring during periods of lowered sea level. (3) Upwelling influence from the near-coastal upwelling centre has been detected by means of the opal content: interglacial periods show high opal contents, because the Benguela Current turned westward at about 20°S and carried opal-laden upwelled water to the west. Sediments from glacial periods, however, show opal minima. Besides these short-term cyclic variations in opal content, long-term cycles have been found, with maximum upwelling influence in the latest Pliocene/early Quaternary. (4) Each CaCO3 dissolution minimum (maximum) is correlated with an opal maximum (minimum) throughout the sediment sequence. (5) The oceanographic system off southwest Africa remained essentially unchanged since the latest Miocene: sea level rose and fell periodically on a small and on a large scale, and the Benguela Current flowed southeast-northwest and turned to the west at the latitude of Site 532 during interglacial periods, when sea level was high. (6) The climate in the near-coastal area of southwest Africa in the latitude of Site 532 has probably been arid throughout the investigated period.

Bulk and clay mineralogy of ODP Leg 110 holes

The mineralogy of both bulk- and clay-sized fractions of samples from Sites 671, 672, and 674 of ODP Leg 110 was determined by X-ray diffraction. The major minerals include quartz, calcite, plagioclase feldspar, and the clay minerals smectite, illite, and kaolinite. The smectite is a dioctahedral montmorillonite and is derived primarily from degradation of volcanic ash. Percentage of smectite varies with sediment age; Miocene and Eocene sediments are the most smectite-rich. High smectite content tends to correlate with elevated porosity, presumably because of the ability of smectite clays to absorb significant amounts of interlayer water. Because of a change in physical properties, the decollement zone at Site 671 formed in sediments immediately subjacent to a section of smectite-rich, high-porosity, Miocene-age sediments. Sediments above the decollement at Site 671, as well as all sediments analyzed from Sites 672 and 674, contain nearly pure smectite characteristic of the alteration of volcanic ash. Within the decollement zone and underthrust sequence, however, the smectite contains up to 65% illite interlayers. Although the illite/smectite could be interpreted as detrital clay derived from South America, its absence in the sediments stratigraphically equivalent to the decollement and underthrust sequences at Sites 672 and 674 favors the interpretation that it originated by diagenetic alteration of pre-existing smectite similar to that in the overlying sediments. A significant percentage of the freshening of the pore waters observed in these zones could be due to the water released during smectite dehydration.

Mineral and chemical compositions of clay sediments from the Pacific Ocean, DSDP data

Mineral and chemical compositions, as well as conditions of formation of clay sediments in major structural elements of the Pacific Ocean floor with different ages are under consideration in the monograph. Depending on evolution of the region two ways of clay sediment formation are identified: terrigenous and authigenic. It is shown that terrigenous clay sediments predominate in marginal parts of the Pacific Ocean. Authigenic mineral formation occurring in the basal part of the sedimentary cover primarily results from removal of material from underlying basalts. This material is released during secondary alteration of the basalts due to their interaction with sea water, as well as with deep solutions.