Tab. 1: Rates of advance of the frontal push-moraines of 19 lobes in front of an approx. 4.5 km long margin of the Kötlujökull

In the last years masses of ice, about 5 km long, have been protruding from the lowest part of an advancing glacier margin of the Kötlujökull in Southern Iceland. In the summer of 1983, they appeared as sediment-covered lobes, 10-60 m long, bordering the glacier rnargin like agarland. 1 to 3 push-rnoraines without ice core, rnostly sickle-shaped, occured first in the frontal parts of the lobes: behind thern came several ice-cored moraines with heights of up to several metres. The active ice in front of the precipice of the glacier is called the "glacier-foot" in this paper. The digging out of 9 lobes and the measuring of the advance of 19 lobes showed that in most cases this glacierfoot had split up at its distal end into several plate- or stem-shaped pieces of ice which were situated one upon the other, separated by moraine deposits and proceeding irregularly into the foreland at the rate of several mm/h, The sometimes different rate of advance in the same lobe and different rates of advanee in adjoining lobes (some being entirely inactive) point to a type of rnovement which is independent of the general advance of the glacier. Research in the winter of 1983/84 showed less activity in 3 examined lobes, but the activity had not ceased. The advancement of the lower parts of the glacier-foot into and across the sands of the foreland implies the following genesis of pushmoraines: Shoving off a plate of sand, folding it and pushing it over the foreland at average rates of up to 7,2 mm/h, according to the investigations in thc summer of 1983. At a certain stage of the folding process, new folds begin to develop in front of the old, and the old folds are shifted onto the backslope of thc folds in front of them until they are completely unired. In this way, "püe-moraines" arise, which become higher and higher. They include two or more folds declining towards the glacier. Systems of small moraines presumably of the same genesis occur on old moraine areas in front of the Kötlujökull. The possible cause of formation of a glacier-foot is discussed, and the moraines of the Kötlujökull are compared with certain pleistocene push-moraines.

Composition of Carnian to Norian sandstones from the Wombat Plateau (Table 1)

The Carnian to Norian sediments, as much as 600 m in total thickness, recovered from ODP Sites 759 and 760 on the Wombat Plateau, are generally represented by fluvial-dominated deltaic successions. In general, the Carnian to Norian sandstones are quartzose. The average ratio of monocrystalline quartz grains, total feldspar grains, and total lithic fragments (i.e., Qm:F:Lt ratio) is 71:22:7. This indicates that they were derived mainly from the transitional continental and cratonic interior provenance terranes, such as the Pilbara Precambrian block to the south of the Wombat Plateau. The upper Carnian sediments, however, are characterized by more feldspathic sandstone petrofacies. They typically contain some volcanic rock fragments with trachytic texture and indicate the onset of the incipient rift-related tectonic movement, such as uplift and subsequent abrupt basin subsidence, together with volcanism in the Gondwana continental block. Mixed siliciclastic and carbonate cycles are typically intercalated in the prodelta to delta front deposits that developed mainly in a lagoon-like, restricted marine environment. The restricted marine environment developed during transgressions as the outflow of shallow water was restricted by depositional barriers. Around the barriers and/or delta lobes, carbonate shoals/banks were probably developed and the allochemical components of the neritic limestones may have been transported into the restricted marine environment by overwash processes and/or storm waves. Siliciclastic detritus, on the other hand, was mainly derived accompanied by delta progradation dominated by fluvial processes in the restricted marine environment. Therefore, we interpret the mixed siliciclastic and carbonate cycles in the deltaic successions to be a result of transgression-regression cycles in a deltaic system during the Late Triassic.

Trace-element geochemistry of tholeiitic basalts from DSDP Hole 55-433C

Hole 433C, a multiple re-entry hole drilled in 1862 meters of water on Suiko Seamount in the central Emperor Seamounts, penetrated 387.5 meters of lava flows overlain by 163.0 meters of sediments. The recovered volcanic rocks consist of three flow units (1-3) of alkalic basalt underlain by more than 105 flows or flow lobes (Flow Units 4-67) of tholeiitic basalt. This study reports trace-element, including rare-earth element (REE), data for 25 samples from 24 of the least altered tholeiitic flows. These data are used to evaluate the origin and evolution of tholeiitic basalts from Suiko Seamount and to evaluate changes in the mantle source between the time when Suiko Seamount formed, 64.7 ± 1.1 m.y. ago (see Dalrymple et al., 1980), and the present day. Stearns (1946), Macdonald and Katsura (1964) and Macdonald (1968) have established that chemically distinct lavas erupt during four eruptive stages of development of a Hawaiian volcano. These stages, from initial to final, are shield-building, caldera-filling, post-caldera, and post-erosional. The lavas of the shield-building stage are tholeiitic basalts, which erupt rapidly and in great volume. The shield-building stage is quickly followed by caldera collapse and by the caldera-filling stage, during which the caldera is filled by tholeiitic and alkalic lavas. During the post-caldera stage, a relatively thin veneer of alkalic basalts and associated differentiated lavas are erupted, sometimes accompanied by minor eruptions of tholeiitic lava. After a period of volcanic quiescence and erosion, lavas of the nephelinitic suite, which include both alkalic basalts and strongly SiO2-undersaturated nephelinitic basalts, may erupt from satellite vents during the post-erosional stage. Many Hawaiian volcanoes develop through all four stages; but individual volcanoes have become extinct before the cycle is complete. We interpret the tholeiitic lavas drilled on Suiko Seamount to have erupted during either the shield-building or the caldera-filling stage, and the overlying alkalic flows to have erupted during either the caldera-filling or the post-caldera stage (see Kirkpatrick et al., 1980).

Table I. Composition of till in north Greenland

From 1950 through 1900 studies on the glacial geology of northern Greenland have been made in cooperation with the U.S. Air Force Cambridge Research Laboratories. As a result of these studies four distinct phases of the latest glaciation have been recognized. The last glaciation extended over most of the land and removed traces of previous anes. Retreat of the ice mass began some time previous to 6000 years ago. This was followed by a rtse in sea level which deposited clay-silt succeeded by karne gravels around stagnant ice lobes in the large valleys. Marine terraces, up to 129 meters above present sea level, developed as readjustment occurred in the land free of ice. About 3700 years ago an advance of glaciers down major fjords took place followed by retreat to approximately the present position of the ice. Till in Peary Land, north of Frederick E. Hyde Fjord, contains only locally derived matertals indicating that the central Greenland ice cap did not cover the area.

Study of the fronts of Johnsons and Hurd Glaciers (Livingston Island, Antarctica) from 1957 to 2013, with links to shapefiles

The study of glacier fronts combines different geomatics measurement techniques as the classic survey using total station or theodolite, technical GNSS (Global Navigation Satellite System), using laser-scanner or using photogrammetry (air or ground). The measure by direct methods (classical surveying and GNSS) is useful and fast when accessibility to the glaciers fronts is easy, while it is practically impossible to realize, in the case of glacier fronts that end up in the sea (tide water glaciers). In this paper, a methodology that combines photogrammetric methods and other techniques for lifting the front of the glacier Johnsons, inaccessible is studied. The images obtained from the front, come from a non-metric digital camera; its georeferencing to a global coordinate system is performed by measuring points GNSS support in accessible areas of the glacier front side and applying methods of direct intersection in inaccessible points of the front, taking measurements with theodolite. The result of observations obtained were applied to study the temporal evolution (1957-2014) of the position of the Johnsons glacier front and the position of the Argentina, Las Palmas and Sally Rocks lobes front (Hurd glacier).

Petrophysical measurement of ODP Leg 122 and 123 samples (Tables 1, 2)

The capillary-pressure characteristics of 22 samples of lithified post-Paleozoic Indian-Ocean carbonates were compared to published data from older carbonate rocks (lower Paleozoic Hunton Group of Texas and Oklahoma). The Indian-Ocean samples are considerably more porous than are the Paleozoic samples, yet all of the Indian-Ocean samples fit readily into a descriptive petrofacies scheme previously established for the Hunton Group. The Indian-Ocean samples may be assigned to four petrophysical facies (petrofacies) based on the shapes of their capillary-pressure curves, their pore-throat-size distributions, their estimated recovery efficiency values (for nonwetting fluids), and the visual characteristics of their pore systems, as observed with a scanning-electron microscope. Petrofacies assignments for the Indian-Ocean samples are as follows. Petrofacies I includes six samples collected from the coarse basal portions of event deposits (primarily turbidites). These samples have large throats, leptokurtic throat-size distributions, low- to moderate recovery efficiency values, concave cumulative-intrusion capillary-pressure curves, and high porosity values. Petrofacies II includes two sedimentologically dissimilar samples that have medium-size throats, platykurtic throat-size distributions, moderate- to-high recovery efficiency values, gently sloping cumulative-intrusion capillary-pressure curves, and high porosity values. Petrofacies III includes two polymictic sandstones and a skeletal packstone that have small throats, polymodal throat-size distributions, moderate recovery efficiency values, gently sloping cumulative-intrusion capillary-pressure curves, and high porosity values. Petrofacies IV includes 11 samples, mostly recrystallized neritic carbonates, that have small throats, leptokurtic throat-size distributions, high recovery efficiency values, convex cumulative-intrusion capillary-pressure curves, and low porosity values. Comparison of petrofacies assignment to core-, thin-section-, and smear-slide data, and to inferred depositional setting, suggests that pore systems in most samples from Holes 765C and 766A result from primary depositional features, whereas pore systems in samples from Hole 761C and one sample from Hole 765C have been strongly influenced by diagenetic processes. For Hole 761C, prediction of petrophysical parameters should be most successful if based on diagenetic facies patterns. By contrast, the distribution of favorable reservoir facies and of permeability barriers in less highly altered rocks collected from Holes 765C and 766A is related to depositional patterns. Recovery efficiency is inversely related to both porosity and median throat size for the present data set. This relationship is similar to that observed for carbonates of the lower Paleozoic Hunton Group and the Ordovician Ellenburger dolomite, but opposite of that observed for some other ancient carbonates. The coarse deposits of the massive basal units of turbidites are petrophysically distinct and form a coherent petrophysical group (Petrofacies I) with substantial reservoir potential. Two samples assigned to Petrofacies I have extremely large throats (median throat size at least 4 ?m, and at least six times that of any other sample) and therefore high permeability values. These two samples come from thin, coarse turbidites that lack or have poorly developed fine divisions and are interpreted to have been deposited on channeled suprafan lobes in a proximal mid-fan setting. The restriction of extremely high permeability values to a single depositional facies suggests that careful facies mapping of deep-sea fans in a deliberate search for such coarse turbidites could dramatically enhance the success of exploration for aquifers or hydrocarbon reservoirs. Such reservoirs should have substantial vertical heterogeneity. They should have high lateral permeability values but low vertical permeability values, and reservoir sections should include numerous thin units having widely differing petrophysical characteristics.