Analyses of shocked quartz from the K-P boundary

The precise cause and timing of the Cretaceous-Paleocene (K-P) mass extinction 65 Ma ago remains a matter of debate. Many advocate that the extinction was caused by a meteorite impact at Chicxulub, Mexico, and a number of potential kill-mechanisms have been proposed for this. Although we now have good constraints on the size of this impact and chemistry of the target rocks, estimates of its environmental consequences are hindered by a lack of knowledge about the obliquity of this impact. An oblique impact is likely to have been far more catastrophic than a sub-vertical one, because greater volumes of volatiles would have been released into the atmosphere. The principal purpose of this study was to characterize shocked quartz within distal K-P ejecta, to investigate whether the quartz distribution carried a signature of the direction and angle of impact. Our analyses show that the total number, maximum and average size of shocked quartz grains all decrease gradually with paleodistance from Chicxulub. We do not find particularly high abundances in Pacific sites relative to Atlantic and European sites, as has been previously reported, and the size-distribution around Chicxulub is relatively symmetric. Ejecta samples at any one site display features that are indicative of a wide range of shock pressures, but the mean degree of shock increases with paleodistance. These shock- and size-distributions are both consistent with the K-P layer having been formed by a single impact at Chicxulub. One site in the South Atlantic contains quartz indicating an anomalously high average shock degree, that may be indicative of an oblique impact with an uprange direction to the southeast +/- 45°. The apparent continuous coverage of proximal ejecta in this quadrant of the crater, however, suggests a relatively high impact angle of >45°. We conclude that some of the more extreme predictions of the environmental consequences of a low-angle impact at Chicxulub are probably not applicable.

B, d11B, K and d18O data for altered oceanic crust at DSDP Sites 417/418

Samples of drilled oceanic crust, from DSDP Holes 417A, 417D and 418A and ODP Hole 735B, and oceanic crust from the Oman and Cyprus ophiolites, were analyzed for B contents and d11B. Composite samples from DSDP Holes 417A, 417D and 418A were used to represent the upper 550 m of altered oceanic crustal Layer 2A. Whole-rock samples from the Troodos ophiolite, Cyprus, and the Oman ophiolite were selected to represent crustal Layer 2B dikes. Composite samples from ODP Hole 735B were used to represent crustal Layer 3. The B content of the DSDP composites ranges from 7.2 ppm to 104 ppm and correlates with both d1818O and K, showing that it is a good indicator of the extent of low temperature alteration. The d11B of the DSDP composites varies between -2.5? and 5.4?. The B content of the samples from the Troodos ophiolite ranges from 2.4 ppm to 8.1 ppm; d11B varies from -0.9? to 7.8?. The B content of the Oman ophiolite samples ranges from 5.0 ppm to 11.1 ppm; d11B varies from -1.6? to 16.9?. The B content of the samples from ODP Hole 735B ranges from 1.1 ppm to 7.1 ppm; d11B varies from -4.3? to 24.9?. The general pattern displayed by these samples is one of greatest (and most variable) B enrichment at the top of the crust and least enrichment at the bottom of the section. All of these samples are enriched compared to unaltered MORB, which is believed to have a B content of approximately 0.5 ppm. The d11B values of deeper samples, from Layers 2B and 3, are more variable and generally higher than those from Layer 2A. Boron contents and d11B are not correlated. The data from the DSDP Site 417/418 composites indicate that the d11B of fluid circulating in the upper crust changes only slightly during alteration, increasing by an average of 5.1? with an accompanying decrease in B concentration of 7%. Low temperature alteration appears to be a water-dominated process resulting in minor modification of circulating seawater. A minimum water-rock ratio of 400 is calculated for these samples, implying a minimum low-temperature seawater flux through the upper oceanic crust of 3.4?10**14 l/y. The average B content of altered oceanic crust, as represented by these samples, is 5.2+/-1.7 ppm and the average d11B is 3.4+/-1.1?. This average isotopic composition is measurably different from the apparent average of oceanic sediments, supporting the idea that d11B could be useful for identifying the source(s) of B in island arcs.

Environmental variables and multivariate seabed classification maps via k means clustering of Potter Cove, Antarctica, link to input and result files in GeoTIFF format

This study subdivides the Potter Cove, King George Island, Antarctica, into seafloor regions using multivariate statistical methods. These regions are categories used for comparing, contrasting and quantifying biogeochemical processes and biodiversity between ocean regions geographically but also regions under development within the scope of global change. The division obtained is characterized by the dominating components and interpreted in terms of ruling environmental conditions. The analysis includes in total 42 different environmental variables, interpolated based on samples taken during Australian summer seasons 2010/2011 and 2011/2012. The statistical errors of several interpolation methods (e.g. IDW, Indicator, Ordinary and Co-Kriging) with changing settings have been compared and the most reasonable method has been applied. The multivariate mathematical procedures used are regionalized classification via k means cluster analysis, canonical-correlation analysis and multidimensional scaling. Canonical-correlation analysis identifies the influencing factors in the different parts of the cove. Several methods for the identification of the optimum number of clusters have been tested and 4, 7, 10 as well as 12 were identified as reasonable numbers for clustering the Potter Cove. Especially the results of 10 and 12 clusters identify marine-influenced regions which can be clearly separated from those determined by the geological catchment area and the ones dominated by river discharge.

(Table 1) K-Ar age determinations on biotite from coarse sand within DSDP Sample 72-516F-76-4,107-115

Qualitative petrographic study of selected clastic horizons within the Eocene section of Hole 516F has revealed the presence of abundant fine-grained lithic fragments, probably volcanic, along with coarser fragments of quartz and feldspar apparently derived from a nearby plutonic terrain. In detail, poor sorting, presence of graded bedding, and an abundance of clay suggest these are turbidite horizons locally derived from a mixed volcanic/plutonic terrain, possibly with some direct contribution from contemporary volcanic ash falls. A progressive increase in plutonic versus volcanic components with time is, however, more consistent with an erosional origin for most of this material. Unusual euhedral dark biotite is abundant in several of the lower clastic horizons; it is most easily interpreted as microphenocrysts weathered in situ out of alkalic volcanic ash. Biotite separated from Sample 516F-76-4,107-115 cm, has been dated by the K-Ar method at about 46 Ma. Alkaline volcanoes active on the Rio Grande Rise in the middle Eocene would be the most probable source of this ash and would be consistent with other evidence for potassic, alkaline volcanism along the Rio Grande Rise and at the Tristan da Cunha hot spot.

K-Ar dating of altered deep-sea igneous rocks from DSDP Legs 2, 34, and 35

In an attempt to establish criteria for obtaining reliable K-Ar dates, conventional K-Ar studies of several Deep Sea Drilling Project sites were undertaken. K-Ar dates of these rocks may be subject to inaccuracies as the result of sea-water alteration. Inaccuracies may also result from the presence of excess radiogenic 40Ar trapped in rapidly cooled rocks at the time of their formation. The results obtained for DSDP Leg 34 basalts indicate that lowering of K-Ar dates, which is related to potassium addition by weathering, is a major cause of uncertainty in obtaining reliable K-Ar dates for deep-sea rocks. It could not be determined if the potassium addition to the basalts occurred at the time of formation, t_o, or continuously from t_o to the present. Calculations show that sediment cover is not a significant barrier to the diffusion of potassium into the basalt. 40Ar loss contributes, at least in part, to the lowering of the K-Ar date in rocks that have added potassium. The meaning of the K-Ar results obtained for DSDP Legs 35 and 2 basalts could not be unambiguously established. Because of the problems involved, caution must be used in interpreting the meaning of conventional K-Ar dates for deep-sea rocks.

Minerals and geochemistry abundance and occurance, as well as K-Ar determinations for DSDP Site 92-597 basalts

Preliminary studies of hydrothermally altered massive basalts formed at the fast-spreading Mendoza Rise and recovered from DSDP Holes 597B and 597C indicate the presence of three secondary mineral assemblages which formed in the following order: (1) trioctahedral chlorite and talc, (2) goethite and smectite, and (3) calcite and celadonite. The sequential precipitation of these mineral assemblages denotes high water:rock ratios and time-varying conditions of temperature (early >200°C to late <30°C) and state of oxidation (early nonoxidative to late oxidative). A decrease in the relative proportion of oxidative mineral assemblages with depth to 70 m in Site 597 basement indicates a zone of oxidative alteration that became shallower with time as the deeper, more constricted fracture systems were filled by secondary mineralization. In this report we present the first results of the K-Ar dating of celadonite formation age; celadonite formation reflects end-stage hydrothermal alteration in Site 597 basement. Three celadonite dates obtained from Site 597 samples include 13.1 ± 0.3 m.y. from 17 m basement depth (Hole 597B), 19.9 ± 0.4 m.y. from 18 m basement depth (Hole 597C), and 19.3 ± 1.6 m.y. from 60 m basement depth (Hole 597C). The age of host rock crystallization (28.6 m.y.) and the K-Ar dates of celadonite formation establish that hydrothermal alteration in the upper 70 m of Site 597 basement continued for at least 10 m.y. and possibly as long as 16 m.y. after basalt crystallization at the ridge crest. Assuming a half-spreading rate of 55 km/m.y., we calculate that hydrothermal circulation was active in shallow basement at a distance of at least 550 km off ridge crest and possibly as far as 1000 km off ridge crest.

Table 2. Performance summary of K-based sorbents capturing CO2

This article reviews the progress made in CO2 capture, storage, and utilization in Chinese Academy of Sciences (CAS). New concepts such as adsorption using dry regenerable solid sorbents as well as functional ionic liquids (ILs) for CO2 capture are thoroughly discussed. Carbon sequestration, such as geological sequestration, mineral carbonation and ocean storage are also covered. The utilization of CO2 as a raw material in the synthesis of chemicals and liquid energy carriers which offers a way to mitigate the increasing CO2 buildup is introduced.