Oxygen, carbon and strontium isotope data for DSDP Hole 35-323

A downhole decrease in 18O, Mg(2+) and K+, an increase in Ca(2+) and a low 87Sr/86Sr ratio of 0.7067 in the pore fluids of DSDP site 323 were caused principally by the alteration of volcanic material. These chemical and isotopic patterns were produced by the alteration, in order of decreasing importance of: a 60-m thick basal layer of volcanic ash; the underlying basalts; and igneous components in the 640-m thick upper sequence composed largely of terrigenous material. A significant portion of the alteration of the ash in the basal sequence must have occurred before the deposition of the upper sediments, perhaps under the influence of advecting solutions. The rest of the alteration occurred during the deposition of the thick upper sediments. Mass balance considerations and the low d18O values of most of the alteration products suggest that much of the later alteration occurred progressively over the last 13 Myr. The principal alteration products were smectite, potassium feldspar, clinoptilolite and calcite.

Isotopic analyses of DSDP Hole 45-395A samples from veins containing gypsum (Table 1)

Gypsum and halite crystals, together with saponite and phillipsite, were found in a vein in a basalt sill 625 m below the sea floor at DSDP Site 395A, located 190 km west of the crest of the Mid-Atlantic Ridge. The delta34S value of the gypsum (+19.4?) indicates a seawater source for the sulfate. The delta18O values of the saponite (+19.9?) and phillipsite (+18.1?) indicate either formation from normal seawater at about 55°C or formation from delta18O-depleted seawater at a lower temperature. The gypsum (which could be secondary after anhydrite) was formed by reaction between Ca[2+] released from basalt and SO4[2-] in circulating seawater. The halite could have formed when water was consumed by hydration of basalt under conditions of extremely restricted circulation. A more probable mechanism is that the gypsum was originally precipitated as anhydrite at temperatures above 60°C. As the temperature dropped the anhydrite converted to gypsum. The conversion would consume water, which could cause halite precipitation, and would cause an increase in the volume of solids, which would plug the vein and prevent subsequent dissolution of the halite.

Pollen record and lithology of a profile from Dumfriesshire, Scotland

Four samples, G5, G7, G8, and G10, collected by Dr W. W. Bishop from an exposed section in the bank of the River Annan, at Roberthill Farm, Dumfriesshire (S35, 110794) were submitted for pollen analysis (Table I.). The samples, with the exception of the uppermost, were from thin peat layers that lie in the middle of a series of water- laid sands, silts and clays several feet in thickness and now rather strongly arched. The lowermost sample, G5, was taken from an organic layer about | in. thick overlying fine sand and underlying some 2.5 in. of grey, silty fine sand. A narrow layer of sandy peat immediately above the silty, fine sand yielded sample G7, and G8 was collected from a similar peaty layer separated from G7 by more sandy- silty peat. The uppermost sample, G10, was taken from light grey clay 13 in. above sample G8.