Sulphur and iron species in Dvurechenskii mud volcano sediments

The deep Black Sea is known to be depleted in electron-acceptors for sulphide oxidation. This study on depth distributions of sulphur species (S(II), S(0),S(n)**2-,S2O3**2-,SO3**2-,SO4**2-) in the Dvurechenskii mud volcano, a cold seep situated in the permanently anoxic eastern Black Sea basin (Sorokin Trough, 2060 m water depth), showed remarkable concentrations of sulphide oxidation products. Sulphite concentrations of up to 11 µmol L**1-, thiosulphate concentrations of up to 22 µmol L**1-, zero-valent sulphur concentrations of up to 150 µmol L**1- and up to five polysulphide species were measured in the upper 20 cm of the sediment. Electron-acceptors found to be available in the Dvurechenskii mud volcano (DMV) for the oxidation of hydrogen sulphide to sulphide oxidation intermediates are iron-minerals, and probably also reactive manganese phases. Up to 60 µmol g**1- of reactive iron-minerals and up to 170 µmol L**1- dissolved iron was present in the central summit with the highest fluid upflow and fresh mud outflow. Thus, the source for the oxidative power in the DMV are reactive iron phases extruded with the mud from an ancient source in the deeply buried sediments, leading to the formation of various sulphur intermediates in comparably high concentrations. Another possible source of sulphide oxidation intermediates in DMV sediments could be the formation of zero-valent sulphur by sulphate dependent anaerobic microbial oxidation of methane followed by disproportionation of zero-valent sulphur. Sulphide oxidation intermediates, which are produced by these processes, do not reach thermodynamic equilibrium with rhombic sulphur, especially close to the active center of the DMV due to a short equilibration time. Thus, mud volcano sediments, such as in the DMV, can provide oxidizing niches even in a highly reduced environment like the abyssal part of the Black Sea.

Thermal diagenesis of clay minerals within volcanogenic material from ODP Site 135-841

Clay minerals are examined in detail in the sediment from the Tonga Trench margin at Site 841 (Leg 135 ODP). The changes in amount and nature of secondary clays with depth provide an alternative explanation for the intensive alteration of volcanogenic material at convergent margins. A characteristic distribution of clay minerals with depth shows four distinct zones unexplainable by simple burial diagenesis processes. These are named the upper, reactive, lower and rhyolitic zones. The reactive zone is intercalated with numerous sills and is characterized by the dominant iron-rich clays such as saponite, corrensite and chlorite associated with analcime. The occurrence of such iron-rich clays, mostly associated with a large amount of analcime, yields chemical and mineralogical evidence for thermal diagenesis. The required heat for the diagenetic process was transferred from recently intruded basaltic andesite sills. In the vicinity of these intrusions, the iron-rich clay minerals may have formed at temperatures up to 200°C. A zoning with respect to clay and zeolite minerals indicates that the influence of the palaeoheat flow decreased with the distance from the intrusion. The formation of interlayered I/S, illite, kaolinite and aluminous chlorite, which are recognized as major secondary minerals within the rhyolitic complex, was mainly controlled by both early diagenesis at moderately elevated temperatures, and since the Eocene by burial diagenesis at low temperatures. The occurrence of a steam zone in an early stage of the intrusion is restricted to Miocene tuffs and has overprinted the early alteration of the volcanogenic material within the tuffs and has changed the originally pristine composition of the pore fluids.

Iron and carbon geochemistry of sediment core GeoB1401-4

Iron speciation was determined in hemiplegic sediments from a high productivity area to investigate systematically the early diagenetic reactivity of Fe. A combination of various leaching agents (1 M HCI, dithionite buffered in citrate/acetic acid, HF/H2SO4, acetic Cr(II)) was applied to sediment and extracted more than 80% of total Fe. Subsequent Fe species determination defined specific mineral fractions that are available for Fe reduction and fractions formed as products of Fe diagenesis. To determine the Fe speciation of (sheet) silicates we explored an extraction procedure (HF/H2SO4) and verified the procedure by application to standard rocks. Variations of Fe speciation of (sheet) silicates reflect the possible formation of Fe-bearing silicates in near surface sediments. The same fraction indicates a change in the primary input at greater depth, which is supported by other parameters. The Fe(II)/ Fe(III) -ratio of total sediment determined by extractions was compared with Mössbauer-spectroscopy ] at room temperature and showed agreement within 10%. M6ssbauer-spectroscopy indicates the occurrence of siderite in the presence of free sulfide and pyrite, supporting the importance of microenvironments during mineral formation. The occurrence of other Fe(II) bearing minerals such as ankerite (Ca-, Fe-, Mg-carbonate) can be presumed but remains speculative.

Geochemistry, trace elements and minerals at DSDP Holes 80-550B and 80-551

The Leg 80 basalts drilled on the Porcupine Abyssal Plain 10 km southwest of Goban Spur (Hole 550B) and on the western edge of Goban Spur (Hole 551), respectively, are typical light-rare-earth-element- (LREE-) depleted oceanic tholeiites. The basalts from the two holes are almost identical; most of their primary geochemical and mineralogical characteristics have been preserved, but they have undergone some low-temperature alteration by seawater, such as enrichment in K, Rb, and Cs and development of secondary potassic minerals of the "brownstone facies." K/Ar dating fail to give realistic emplacement ages; the apparent ages obtained become younger with alteration (causing an increase in K2O). Hole 551 basalts are clearly different from the continental tholeiites emplaced on the margins of oceanizing domains during the prerift and synrift stages.

Petrology and geochemistry of basalts at DSDP Hole 86-581

Approximately 5 m of aphyric to sparsely phyric basalt was recovered from Hole 581, the only hole on Leg 86 where basement was cored. The occurrence of samples with altered glassy rinds indicates that at least three cooling units (pillows or thin flows) were sampled. The samples were moderately to intensely altered; groundmass crystals are generally fresh, but all glass is altered. Alteration is greatest in vesicular samples, but most of the samples have fractures filled with iron oxyhydroxide, clay, and/or calcite. All 13 samples analyzed are moderately fractionated aluminous N-type mid-ocean ridge basalts. The samples can be divided into two groups based on TiO2 and FeO contents. The least-evolved group may be derived from a more primitive mid-ocean ridge basalt by the crystallization of 18% plagioclase, 24% clinopyroxene, and 3% olivine. The more evolved group may be derived from the first group by the fractionation of 18% plagioclase, 11% clinopyroxene, and 3% olivine. However, higher Ce/Yb ratios in the more evolved group cannot be produced by fractionation and thus we must invoke a more complex process such as dynamic melting to relate the two groups to a common source.

Mössbauer study at DSDP Hole 95-612

57Fe Mössbauer spectra of 15 oceanic sediment samples collected from Site 612 (Deep Sea Drilling Project Leg 95) were recorded. These spectra showed that most of the iron in the sediments was present as high-spin, paramagnetic Fe2+ and Fe3+. The ferrous iron was mainly distributed in terrigenous clays and biogenic carbonates. The variation of the Mössbauer parameters for Fe2+ with sub-bottom depth suggests that the main Fe2+-bearing component changed with geologic time. The amount of iron in each iron-bearing phase as estimated from the corresponding peak areas in the spectra also changed with depth. These variations in the Mössbauer parameters and peak areas are correlated with lithologic changes in the sediment column.

Supplementary material: XRF core scanning data, CaCO3 values, foraminiferal carbon and oxygen isotope data, Mg/Ca data, clay mineralogy and helium isotope results

The Paleocene-Eocene Thermal Maximum (PETM; ~56 Ma) is associated with abrupt climate change, carbon cycle perturbation, ocean acidification, as well as biogeographic shifts in marine and terrestrial biota that were largely reversed as the climatic transient waned. We report a clear exception to the behavior of the PETM as a reversing climatic transient in the eastern North Atlantic (Deep-Sea Drilling Project Site 401, Bay of Biscay) where the PETM initiates a greatly prolonged environmental change compared to other places on Earth where records exist. The observed environmental perturbation extended well past the d13C recovery phase and up to 650 kyr after the PETM onset according to our extraterrestrial 3He-based age-model. We observe a strong decoupling of planktic foraminiferal d18O and Mg/Ca values during the PETM d13C recovery phase, which in combination with results from helium isotopes and clay mineralogy, suggests that the PETM triggered a hydrologic change in western Europe that increased freshwater flux and the delivery of weathering products to the eastern North Atlantic. This state change persisted long after the carbon-cycle perturbation had stopped. We hypothesize that either long-lived continental drainage patterns were altered by enhanced hydrological cycling induced by the PETM, or alternatively that the climate system in the hinterland area of Site 401 was forced into a new climate state that was not easily reversed in the aftermath of the PETM.

Sedimentary history and chemical characteristics of clay minerals from the Bengal Fan

The purpose of this study is to clarify the sedimentary history and chemical characteristics of clay minerals found in sediments deposited in the distal part of the Bengal Fan since the Himalayas were uplifted 17 m.y. ago. A total of seventy-eight samples were collected from three drilled cores which were to be used for the clay mineral analyses by means of XRD and ATEM. The results obtained from the analyses show that individual clay mineral species in the sediment samples at each site have similar features when the samples are of the same age, whereas these species have different features in samples of differing geological ages. Detrital clay minerals such as illite and chlorite were deposited in greater amounts than kaolinite and smectite during the Early to Middle Miocene. This means that the Himalayan uplift was vigorous at least until the Middle Miocene. In the Pliocene chemical weathering was more prevalent so that instead, in the distal part of the Bengal Fan, kaolinite shows the highest concentrations. This would accord with weaker uplift in the Himalayas. In the Pleistocene period, vigorous Himalayan uplift is characterized by illite-rich sediment in place of kaolinite. In the Holocene, smectite shows the highest concentration in place of the illite and kaolinite which were the predominant clay minerals of the earlier periods. Increasing smectite concentration suggests the Himalayan uplift to have been stable after the Pleistocene period. The smectite analyzed here is found to be dioctahedral Fe-beidellite, and it originated largely from the augite-basalt on the Indian Deccan Traps. The tri-octahedral chlorite is subdivided into three sub-species, an Fe-type, a Mg-type and an intermediate type. The mica clay mineral can be identified as di-octahedral illite which is rich in potassium. The chemical composition and morphology of each clay mineral appears to exhibit no change with burial depth in the sedimentary columns. This implies that there was no systematic transformation of clay minerals with time.