Tree heights and diameters of Switzerland's Sanasilva forests

Measurements of tree heights and crown sizes are essential in long-term monitoring of spatially distributed forests to assess the health of forests over time. In Switzerland, in 1994 and 1997, more than 4'500 trees have been recorded in a 8x8 km plot within the Sanasilva Inventory, which comprises the Swiss Level I sites of the International Co-operative Programme on Assessment and Monitoring of Air Pollution Effects on Forests' (ICP Forests). Tree heights and crown sizes were measured for the dominant and co-dominant trees (n = 1,723), resulting in a data set from 171 plots in Switzerland, spreading over a broad range of climatic gradient and forest characteristics (species recorded = 20). Average tree height was 22.1 m, average DBH 34.6 cm and crown diameter 6.5 m. The data set presented here is open to use and shall foster research in allometric equation modelling.

Abundance and biomass of phytoplankton in the western part of the Black Sea during the R/V Akademik cruise Ak082001 in August 2001

The dataset is composed of 41 samples from 10 stations. The phytoplankton samples were collected by 5l Niskin bottles attached to the CTD system. The sampling depths were selected according to the CTD profile and the in situ fluorometer readings: surface, temperature, salinity and fluorescence gradients and 1 m above the bottom. At some stations phytoplankton net samples (20 µm mesh-size) were collected to assist species biodiversity examination. The samples (1l sea water) were preserved in 4% buffered to pH 8-8.2 with disodiumtetraborate formaldehyde solution and stored in plastic containers. On board at each station few live samples were qualitatively examined under microscope for preliminary analysis of taxonomic composition and dominant species. The taxon-specific phytoplankton abundance samples were concentrated down to 50 cm**3 by slow decantation after storage for 20 days in a cool and dark place. The species identification was done under light microscope OLIMPUS-BS41 connected to a video-interactive image analysis system at magnification of the ocular 10X and objective - 40X. A Sedgwick-Rafter camera (1ml) was used for counting. 400 specimen were counted for each sample, while rare and large species were checked in the whole sample (Manual of phytoplankton, 2005). Species identification was mainly after Carmelo T. (1997) and Fukuyo, Y. (2000). Total phytoplankton abundance was calculated as sum of taxon-specific abundances. Total phytoplankton biomass was calculated as sum of taxon-specific biomasses. The cell biovolume was determined based on morpho-metric measurement of phytoplankton units and the corresponding geometric shapes as described in detail in (Edier, 1979).

Iridium concentrations and abundances of meteoritic ejecta from the Eltanin impact in sediment cores from POLARSTERN cruise ANT-XII/4

The abundances of meteoritic ejecta from the Eltanin asteroid impact have been examined in seven sediment cores recovered by the FS Polarstern during expedition ANT XII/4 using elemental concentrations of iridium and weights of coarse (>500 ?m) ejecta debris. Three cores with well-preserved impact deposits, PS2704-1, PS2708-1, and PS2709-1, each contain Ir and ejecta fluences similar to those found previously in USNS Eltanin core E13-4. Small Ir anomalies and traces of ejecta were found in cores PS2706-1 and PS2710-1, but since these cores lack well-defined deposits, these are considered to be reworked and not representative of the fallout. No evidence of ejecta was found in cores PS2702-1 and PS2705-1. These results confirm earlier speculation that the Eltanin impact resulted in deposits of ejecta with up to 1 g/cm**2 of debris over a wide area of the ocean floor. However, there are still large uncertainties over the actual regional or global extent of this unique sediment deposit.

Table 1. pH, Temperature, conductivity and hydrochemistry of samples

Carbon dioxide deep geological storage, especially in deep saline aquifers, is one of the preferred technological options to mitigate the effects of greenhouse gases emissions. Thus, in the last decade, studies characterising the behaviour of potential CO2 deep geological storage sites along with thorough safety assessments have been considered essential in order to minimise the risks associated with these sites. The study of natural analogues represents the best source of reliable information about the expected hydrogeochemical processes involved in the CO2 storage in such deep saline aquifers. In this work, a comprehensive study of the hydrogeochemical features and processes taking place at the natural analogue of the Alicún de las Torres thermal system (Betic Cordillera) has been conducted. Thus, the main water/CO2/rock interaction processes occurring at the thermal system have been identified, quantified and modelled, and a principle conclusion is that the hydrogeochemical evolution of the thermal system is controlled by a global dedolomitization process triggered by gypsum dissolution. This geochemical process generates a different geochemical environment to that which would result from the exclusive dissolution of carbonates from the deep aquifer, which is generally considered as the direct result of CO2 injection in a deep carbonate aquifer. Therefore, discounting of the dedolomitization process in any CO2 deep geological storage may lead to erroneous conclusions. This process will also influence the porosity evolution of the CO2 storage formation, which is a very relevant parameter when evaluating a reservoir for CO2 storage. The geothermometric calculation performed in this work leads to estimate that the thermal water reservoir is located between 650 and 800 m depth, which is very close to the minimum required to inject CO2 in a deep geological storage. It is clear that the proper characterisation of the features and hydrogeochemical processes taking place at a natural system analogous to a man-made deep geological storage will provide useful conceptual, semi-quantitative and even quantitative information about the processes and consequences that may occur at the artificial storage system.