Diagenetic development of deep-sea carbonate sediments from DSDP Holes 30-228, 30-289 and 33-316

Laboratory measurements of ultrasonic velocity (VP, VS) and attenuation (QP**-1, QS**-1) in deep-sea carbonate sequences at DSDP Sites 288, 289 and 316 in the equatorial Pacific were made in conjunction with studies of sediment density, porosity and pore geometry in order to investigate the role of diagenesis in the development of physical properties. Bulk porosity decrease appears to be related more significantly to depth of burial than to age of strata. Both depth of burial and age, however, are important factors controlling the modal pore diameter. In deep-burial diagenesis the modification of pore geometry is influenced by the presence of silica during diagenesis. In carbonate sequences at the three DSDP sites studied, shear wave attenuation anisotropy (QSHH**-1/QSHV**-1) correlates with the shear wave velocity anisotropy. Pore orientation, resulting from overburden pressure and other deep-burial diagenetic processes, is an important factor controlling the increase of VP anisotropy with age and depth of burial. On the basis of observed minor changes in anisotropy values with increasing pressure for some samples, other contributions to VP anisotropy such as grain orientation and bedding lamination cannot be ruled out.

Magnetic properties and sand composition at DSDP Site 87-582 and Hole 87-583D

At Site 582, DSDP Leg 87, turbidites about 560 m thick were recovered from the floor of the Nankai Trough. A turbidite bed is typically composed of three subdivisions: a lower graded sand unit, an upper massive silt unit, and an uppermost Chondrites burrowed silt unit. The turbidites intercalate with bluish gray hemipelagic mud which apparently accumulated below the calcite compensation depth. In order to investigate the nature and provenance of the turbidites, we studied the grain orientation, based on magnetic fabric measurements and thin-section grain counting, and grain size, using a photo-extinction settling tube and detrital modal analysis. The following results were obtained: (1) grain orientation analysis indicates that the turbidity current transport parallels the trench axis, predominantly from the northeast; (2) Nankai Trough turbidites generally decrease in grain size to the southwest; (3) turbidite sands include skeletal remains indicative of fresh-water and shallow-marine environments; and (4) turbidites contain abundant volcanic components, and their composition is analogous to the sediments of the Fuji River-Suruga Bay area. Considering other evidence, such as physiography and geometry of trench fill, we conclude that the turbidites of Site 582 as well as Site 583 were derived predominantly from the mouth of Fuji River and were transported through the Suruga Trough to the Nankai Trough, a distance of some 700 km. This turbidite transport system has tectonic implications: (1) the filling of the Nankai Trough is the direct consequence of the Izu collision in Pliocene- Pleistocene times; (2) the accretion of trench fill at the trench inner slope observed in the Nankai Trough is controlled by collision tectonics; and (3) each event of turbidite deposition may be related to a Tokai mega-earthquake.

(Table 1) Grain size parameters of intertidal channel sand bars near Sylt, North-Frisian Wadden Sea

The aim of the present study is to investigate directional asymmetric properties and internal structures of the bedforms on the intertidal sand bars in comparison with the migration problems of the sand bodies developed in the channel systems of the tidal basin off the west coast of Schleswig-Holstein. The tidal channel sand bodies studied have 'V'-shaped outlines and are asymmetric in cross-section. Based on such knowledge it was hoped to understand and find possible factors for application to recent and ancient tidal depositional environments. The V-shaped intertidal channel sand bodies developed in the tidal environments between Sylt and Föhr Island are constantly migrating sand bars. The migration directions are in good agreement with the resultant vector mean directions of internal cross-stratification structures of asymmetric sedimentary bedforms. Finally, it is shown that the orientation of the apex of V-shaped sand bar as an equilibrium form alone can not indicate the migration direction, but that the orientation of the resultant vector mean of internal structures of sedimentary bedforms does indicate the migration direction. Based on the analyses of textural parameters of the migrating intertidal bar sands, it seems that sands of typical intertidal sand bars are negatively skewed and well sorted. The high rounding of quarz sand grains of these tidal channel sand bars seems to be an additional characteristical criterion for tidal depositional environments, as also indicated by Balazs and Klein (1972).

Physical properties, grain size distribution and clay mineralogy of ODP Leg 117 sites

The fabric of sediments recovered at sites drilled on the Indus Fan, Owen Ridge, and Oman margin during Ocean Drilling Program Leg 117 was examined by scanning electron microscopy to document changes that accompany sediment burial. Two sediment types were studied: (1) biogenic sediments consisting of a variety of marly nannofossil and nannofossil oozes and chalks and (2) terrigenous sediments consisting of fine-grained turbidites deposited in association with the Indus Fan. Biogenic sediments were examined with samples from the seafloor to depths of 306 m below seafloor (mbsf) on the Owen Ridge (Site 722) and 368 mbsf on the Oman margin (Sites 723 and 728). Over these depth ranges the biogenic sediments are characterized by a random arrangement of microfossils and display little chemical diagenetic alteration. The microfossils are dispersed within a fine-grained matrix that is predominantly microcrystalline carbonate particles on the Owen Ridge and clay and organic matter on the Oman margin. Sediments with abundant siliceous microfossils display distinct, open fabrics with high porosity. Porosity reduction resulting from gravitational compaction appears to be the primary process affecting fabric change in the biogenic sediment sections. Fabric of illite-rich clayey silts and silty claystones from the Indus Fan (Site 720) and Owen Ridge (Sites 722 and 731) was examined for a composite section extending from 45 to 985 mbsf. In this section fabric of the fine-grained turbidites changes from one with small flocculated clay domains, random particle arrangement, and high porosity to a fabric with larger domains, strong preferred particle orientation roughly parallel to bedding, and lower porosity. These changes are accomplished by a growth in domain size, primarily through increasing face-to-face contacts, and by particle reorientation which is characterized by a sharp increase in alignment with bedding between 200 and 400 mbsf. Despite extensive particle reorientation, flocculated clay fabric persists in the deepest samples examined, particularly adjacent to silt grains, and the sediments lack fissility. Fabric changes over the 45-985 mbsf interval occur in response to gravitational compaction. Porosity reduction and development of preferred particle orientation in the Indus Fan and Owen Ridge sections occur at greater depths than outlined in previous fabric models for terrigenous sediments as a consequence of a greater abundance of silt and a greater abundance of illite and chlorite clays.

Chemical and mineral compositions of Northwest Pacific bottom sediments and their grain size fractions

A detailed study of chemical composition of bottom sediments along a profile through the Northwest Pacific Basin has allowed to identify and describe four lithofacies types of bottom sediments. Distinguished types of sediments form a genetic series reflecting changing conditions of sedimentation from near-shore to central regions of the ocean. Along the strike of pelagic clays a gradual transition from ash containing clays to zeolite containing clays is established. Ash particles and zeolites have similar forms of occurrence. Together with other data it suggests that zeolites have been formed by diagenetic transformation of rhyolitic glass. Regular changes of CaCO3, amorphous SiO2, Fe and Mn contents in bottom sediments from the coast to the pelagic zone are shown.