Paleomagnetism at DSDP Leg 85 Holes

On Leg 85, 16 holes were cored at five sites. Thirteen of the holes were cored with the hydraulic piston corer (HPC) or the variable-length hydraulic piston corer (VLHPC) or both; the remainder were rotary drilled. Partially duplicating stratigraphic sections were successfully recovered by hydraulic piston coring at Sites 572 to 575. Sub-bottom penetration was deepest (about 210 m) at HPC Hole 575A, which bottomed in lower Miocene sediments. Penetration by hydraulic piston coring was limited at all sites not by the failure of the corer to stroke out but by the excessive force (overpull) necessary to retrieve the core barrel from the hole. The sediments recovered are relatively uniform siliceous-calcareous oozes to calcareous ooze-chalks. Paleomagnetic measurements were made at all stratigraphic levels, but magnetostratigraphic sequences could be resolved only for the Pleistocene-Pliocene and for brief upper, middle, and lower Miocene sections. In the younger and less consolidated sediments, the declination often shows large-scale azimuthal rotations downcore. These smooth trends vary from core to core, indicating either rotation between the sediment and the core liner or the rotation of the core barrel during the coring or retrieval process. Thus, azimuthal orientation of the samples was impossible even though a Kuster azimuthal orientation tool was used during the hydraulic piston coring. At all sites, the downhole shift from mainly siliceous to mainly calcareous ooze-chalk coincided with a decrease in NRM intensity of at least one order of magnitude, to 1.0*10**-8 G. Diagenesis is the probable reason for this behavior, although the dilution of magnetic carriers as the result of higher accumulation rates may also be a factor. A tectonic analysis using data from samples with stable remanence indicates a northward plate motion of about 0.3 deg/m.y. during the last 18 m.y., a rate that agrees with most previous reconstructions of Pacific Plate motion.

Magnetic remanence acquisition in DSDP Leg 73 Holes

The major magnetic mineral in the turbidites and slumped sediments recovered at Leg 73 drill sites was near to magnetite in composition and in the form of small multidomain particles. There was no variation in magnetic mineralogy with the lithology. The variations in the intensities and directions of the natural remanent magnetization could be explained in terms of postdepositional grain rotations within the wet sediment. In the sands realignment was partial, whereas in some of the slumps the entire remanent magnetization was reset. Fine-particle magnetite was also the main magnetic constituent of the red clays. A significant proportion of a higher-coercivity mineral was also present. The magnetic characteristics of the red clays are explained as a combination of concentration and grain rotation effects. The implications to the assessment of the reliability of paleomagnetic data are discussed. Note: Conversion factors are as follows: 1 Am**2/kg = 1 emu/g, and 80 A/m about 1 Oe.

Structural description and paleomagnetic directions of ODP Hole 152-917A

During Ocean Drilling Program Legs 152 and 163, we recovered core from the offshore East Greenland volcanic province. The basaltic core recovered included a set of structural elements reflecting the history of extrusion, cooling, postdeposition alteration, and minor tectonism. Brittle features in the basaltic core include faults and several generations of veins. Several minicore samples from the lower sections of core from Hole 917A were taken for paleomagnetic analysis, primarily to test whether there were any significant postdepositional tectonic rotations or whether the core could be reoriented using paleomagnetic techniques. The characteristic magnetization direction was used to estimate the in situ orientation of measured structural features within the core. Although significant uncertainty is associated with the analysis, the corrected attitudes of veins in basalt at Site 917 dip moderately west, with a smaller, conjugate group of veins dipping moderately east-southeast, parallel to other seaward-dipping faults in the area, which were interpreted from seismic lines.

Paleomagnetic reconstructions of sediments at ODP Sites 135-840 and 135-841

The geometry of the Tonga Arc implies that it has rotated approximately 17° clockwise away from the Lau Ridge as the Lau Basin formed in between. Questions have arisen about the timing of the opening, whether the arc behaved rigidly, and whether the opening occurred instead from motion of the Lau Ridge, the remanent arc. We undertook to address these questions by taking paleomagnetic samples from sediment cores drilled on the Tonga Arc at Sites 840 and 841, orienting the samples in azimuth, and comparing the paleodeclinations to expected directions. Advanced hydraulic piston corer (APC) cores from Holes 840C and 841A were oriented during drilling with a tool based on a magnetic compass and attached to the core barrel. Samples from Hole 841B were drilled with a rotary core barrel (RCB) and therefore are azimuthally unoriented. They were oriented by identifying faults and dipping beds in the core and aligning them with the same features in the Formation MicroScanner (FMS) wireline logs, which were themselves oriented with a three-axis magnetometer in the FMS tool. The best results came from the APC cores, which yielded a mean pole at -69.0°S, 112.2°E for an age of 4 Ma. This pole implies a declination anomaly of 20.8° ± 12.6° (95% confidence limit), which appears to have occurred by tectonic rotation of the Tonga Arc. This value is almost exactly that expected from the geometry of the arc and implies that it did indeed rotate clockwise as a rigid body. The large uncertainty in azimuth results from core orientation errors, which have an average standard deviation of 18.6°. The youngest cores used to calculate the APC pole contain sediments deposited during Subchron 2A (2.48-3.40 Ma), and their declinations are indistinguishable from the others. This observation suggests that most of the rotation occurred after their deposition; this conclusion must be treated with caution, however, because of the large azimuthal orientation errors. Poles from late and early Miocene sediments of Hole 841B are more difficult to interpret. Samples from this hole are mostly normal in polarity, fail a reversal test, and yield poles that suggest that the normal-polarity directions may be a recent overprint. Late Miocene reversed-polarity samples may be unaffected by this overprint; if so, they imply a declination anomaly of 51.1° ± 11.5°. This observation may indicate that, for older sediments, Tonga forearc rotations are larger than expected.