Composition of Messinian sediments from the Tyrrhenian Sea

The data base for this study is represented by essentially nonevaporitic Messinian sediments recovered at ODP Sites 654, 653, 652, and 656 along the eastern Sardinian margin, and of the overlying early Pliocene oozes. Grain-size distribution, carbonate content, and microscopic observation of the sand size fractions were investigated. Messinian paleoenvironments, documented in the western Tyrrhenian Sea (ODP Sites 654 and 653), provide additional evidence supporting the deep basin desiccation model. A sharp lithologic contrast between early Pliocene pelagic oozes and latest Messinian conformable gypsiferous silts supports this model. The "lago-mare" biofacies was only occasionally observed in the shallowest site and is limited to the topmost part of the Messinian. Sites 652 and 656, lying in the deeper part of the Tyrrhenian and located on the downthrown side of an important eastward dipping fault system known as "Faglia centrale" are characterized by terrigenous sedimentation, with partly recycled minor evaporites. Of special interest is Site 652, where the thickness of the (probable) Messinian is 530 m. Sedimentary characters indicate a permanently subaqueous but nonmarine environment, with turbidites accumulating in a rapidly subsiding basin. According to the model proposed, this basin was fed by continental waters during times of maximum evaporitic draw-down, with temporary marine incursions from the west or southwest when the water level was higher. A basement ridge separated the evaporating pond from this endoreic lake located on the opposite (eastern) margin of the Tyrrhenian Basin, which was then limited to its western part. Post-Messinian reactivation of the "Faglia centrale" is necessary to account for the inversion of the relief.

Petrographic description and mineral composition of ODP Site 161-975 sediments

Ocean Drilling Program Site 975 is located near the base of the Menorca Rise in the South Balearic Basin of the western Mediterranean Sea. Coring at this site penetrated the Pliocene/Miocene boundary and recovered a sequence of sediments that represent the final stages of salt deposition and the transition from evaporitic to open marine conditions at the end of the Miocene (Messinian). Detailed petrographic observations and bulk mineralogical analyses by X-ray diffraction form the basis for preliminary interpretations of depositional environments for this section. Gypsum is thought to have been deposited in an evaporating basin below wave base. Cycles consisting of a clay layer overlain by gypsiferous chalk, laminated gypsum, and finally pinch-and-swell gypsum suggest upsection increases in salinity. The gypsum section is overlain by two exotic sand layers thought to mark events of fresher water (marine or meteoric) inflow to the basin. Gypsum deposition terminated and was replaced by inorganic precipitation of micritic calcite with periodic, variable dilution by fine-grained terrigenous sediment. The micritic sediments have fine, slightly wavy, laminations indicating either an algal/microbial mat origin, or varve-like fluctuations in deposition, perhaps in a deep basin. The Pliocene/Miocene boundary falls within an interval of banded micritic silty clays that reflect the final environmental fluctuations during the transition to the open marine conditions of the Pliocene.

(Table 1) Carbon and isotopic composition of organic carbon in sediments from DSDP Leg 56 Holes

We have analyzed inorganic and organic carbons and determined the isotopic composition of both sedimentary organic carbon and inorganic carbon in carbonates contained in sediments recovered from Holes 434, 434A, 434B, 435, and 435A in the landward slope of Japan and from Hole 436 in the oceanic slope of the Japan Trench. Both inorganic and organic carbons were assayed at the P. P. Shirshov Institute of Oceanology, in the same sample, using the Knopp technique and measuring evolved CO2 gravimetrically. Each sample was analyzed twice in parallel. Measurements were of a ±0.05 per cent accuracy and a probability level of 0.95. Carbon isotopic analysis was carried out on a MI-1305 mass spectrometer at the I. M. Gubkin Institute of Petrochemical and Gas Industry and the results presented as dC13 values related to the PDB standard. The procedure for preparing samples for organic carbon isotopic analysis involved (1) drying damp sediments at 60°C; (2) treating samples, while heating, with 10 N HCl to remove carbonate carbon; and (3) evaporating surplus HCl at 60°C. The organic substance was turned to CO2 by oxidizing it in an oxygen atmosphere. To prepare samples for inorganic carbon isotopic analysis we decomposed the carbonates with orthophosphoric acid and refined the gas evolved. The dC13 measurements, including a full cycle of sample preparation, were of a ±0.5 per cent accuracy and a probability level of 0.95.