Spectral analysis of seabed elevation from the Danish Wadden Sea

Bedforms both reflect and influence shallow water hydrodynamics and sediment dynamics. A correct characterization of their spatial distribution and dimensions is required for the understanding, assessment and prediction of numerous coastal processes. A method to parameterize geometrical characteristics using two-dimensional (2D) spectral analysis is presented and tested on seabed elevation data from the Knudedyb tidal inlet in the Danish Wadden Sea, where large compound bedforms are found. The bathymetric data were divided into 20x20 m areas on which a 2D spectral analysis was applied. The most energetic peak of the 2D spectrum was found and its energy, frequency and direction were calculated. A power-law was fitted to the average of slices taken through the 2D spectrum; its slope and y-intercept were calculated. Using these results the test area was morphologically classified into 4 distinct morphological regions. The most energetic peak and the slope and intercept of the power-law showed high values above the crest of the primary bedforms and scour holes, low values in areas without bedforms, and intermediate values in areas with secondary bedforms. The secondary bedform dimensions and orientations were calculated. An area of 700x700 m was used to determine the characteristics of the primary bedforms. However, they were less distinctively characterized compared to the secondary bedforms due to relatively large variations in their orientations and wavelengths. The method is thus appropriate for morphological classification of the seabed and for bedform characterization, being most efficient in areas characterized by bedforms with regular dimensions and directions.

(Table 1) Cesium-137 concentrations and salinity in surface waters from the Atlantic and Pacific Oceans in January-May 1978

Cesium-137 concentrations of surface waters were measured during Cruise 20 of R/V Dmitry Mendeleev across the Atlantic and Pacific Oceans. The measurements were combined with simultaneous salinity measurements. The radioactivity field of surface waters is governed by presence of closed circulation systems and their component currents. Crossing the oceans from west to east decrease in cesium-137 concentrations was noted. In surface waters in the northeastern periphery of the southern anticyclonic gyre in the Pacific Ocean Cs-137 concentrations increased (up to 21.5 Bq/m**3) due to a series of nuclear tests on the Muroroa Atoll.

Phosphate d18O pore-water profiles of sediment core GeoB11807-2 and GeoB11804-4

Phosphorus cycling in the ocean is influenced by biological and geochemical processes that are reflected in the oxygen isotope signature of dissolved inorganic phosphate (Pi). Extending the Pi oxygen isotope record from the water column into the seabed is difficult due to low Pi concentrations and small amounts of marine porewaters available for analysis. We obtained porewater profiles of Pi oxygen isotopes using a refined protocol based on the original micro-extraction designed by Colman (2002). This refined and customized method allows the conversion of ultra-low quantities (0.5 - 1 µmol) of porewater Pi to silver phosphate (Ag3PO4) for routine analysis by mass spectrometry. A combination of magnesium hydroxide co-precipitation with ion exchange resin treatment steps is used to remove dissolved organic matter, anions, and cations from the sample before precipitating Ag3PO4. Samples as low as 200 µg were analyzed in a continuous flow isotope ratio mass spectrometer setup. Tests with external and laboratory internal standards validated the preservation of the original phosphate oxygen isotope signature (d18OP) during micro extraction. Porewater data on d18OP has been obtained from two sediment cores of the Moroccan margin. The d18OP values are in a range of +19.49 to +27.30 per mill. We apply a simple isotope mass balance model to disentangle processes contributing to benthic P cycling and find evidence for Pi regeneration outbalancing microbial demand in the upper sediment layers. This highlights the great potential of using d18OP to study microbial processes in the subseafloor and at the sediment water interface.