Physical oceanography from eight Seaglider missions in the Mediterranean Sea, Eastern Basin

In 2008, the Oceanography Center at the University of Cyprus acquired two underwater gliders in the framework of a nationally-managed infrastructure upgrade program. The gliders were purchased from the Seaglider Fabrication Center at the University of Washington. Both gliders are rated to 1000 m and carry a typical sensor payload: non-pumped conductivity-temperature-depth sensors (CTD), a dissolved oxygen sensor, an optical triplet to measure optical backscatter at 400 nm, 700 nm, and chlorophyll-a fluorescence. Since March of 2009, the gliders have been used in a long-term observing program of the Cypriot EEZ, and by September 2015, have covered more than 15300 km over ground and 3500 dive cycles in 940 glider days. Butterfly patterns have been flown in two configurations, either on the western or eastern side of the EEZ south of Cyprus. The glider endurance lines criss-cross the region in order to more accurately locate and investigate the mesoscale structures south of Cyprus, and in particular the Cyprus eddy which is often the dominant feature. Based on the near real time observations, the glider mission was sometimes altered in order to more fully sample the Cyprus eddy, or to locate its center or extent. A summary of the raw and processed data collected, and the quality control procedures are presented, in order for future users to take advantage of this unique data set.

The sapropel record of the eastern Mediterranean Sea

Research on sediments recovered during Ocean Drilling Leg 160 has concentrated on two issues: the first concerned the stratigraphy of sapropel formation, the second was oriented to clarify specific processes that explain sapropel origin. Progress has been made in the construction of stratigraphic composites out of sedimentary sequences from individual holes at each of the palaeoceanographic sites. On the composites, initial work has resulted in the establishment of high-resolution and intermediate-resolution stratigraphies for three sites (963, 964, 967); correlation of sedimentary cycles to astronomical (insolation) cycles extends the stratigraphies to Sites 969 and 966. The sapropel occurrences in the marine and land sequences over the entire Eastern Mediterranean are correlated; with the resolution that can be obtained from isotope studies, groups of sapropels occurred simultaneously over the entire basin. In detail, however, the temporal and facies patterns of sapropel sequences differ between individual sites and depositional basins. The differences may be related to effects of water depth, diagenesis, and post-depositional tectonic attenuation of sequences. Studies on the geochemistry and facies of sapropels agree that anoxic conditions favoured preservation of organic matter in sapropels, caused the enrichment of trace metals associated with sapropels, and helped to preserve primary sedimentary structures. Besides, all evidence is consistent with elevated fluxes of organic matter and associated elements during sapropel events.

Stable isotope analysis on planktic foraminifera in sediment cores from the eastern Mediterranean sapropel formation

During the late Pleistocene, sapropels (layers of organic-carbon rich sediment) formed throughout the entire Eastern Mediterranean Basin in close association with glacial/interglacial transitions. The current theory for the mechanism of sapropel formation involves a density stratification of the water column, due to the invasion of a large quantity of low-saline water, which resulted in oxygen depletion of the bottom waters. Most workers believe that this low-salinity water was glacial meltwater that entered the Mediterranean via the Black Sea and a series of interconnected glacial lakes, but the suggestion also has been made that the freshwater originated from the Nile River. In this study the oxygen isotope values of planktonic foraminifera,Globigerinoides ruber, have been examined in six gravity cores and one piston core from the southern Levantine Basin, and compared with the oxygen isotope records ofG. ruber from other areas of the Eastern Mediterranean. This study deals mainly with the latest sapropel which was deposited approximately 7000 to 9000 years ago. Results indicate that Nile discharge probably does reduce salinities somewhat in the immediate area surrounding the mouth of the Nile, but this water is rapidly mixed with the highly saline waters of the easternmost Mediterranean. Using a mixing equation and surface water salinity limitations, an approximate oxygen isotope balance of surface waters was calculated for the time of latest sapropel deposition. This calculation shows that neither Nile River discharge nor Black Sea input (nor both together) are large enough to account for the large-scale oxygen isotope depletion associated with latest sapropel deposition in the Eastern Mediterranean. This suggests that part of the isotopic change at Termination I is probably due to increased surface water salinities during the last glacial maximum. In addition, evidence from the timing of sapropel 1 deposition and the dissolved oxygen balance indicates that deposition of the latest sapropel is associated with increased surface water production of biogenic material, as much as three times higher than that of present day.

Sr- and Nd-isotopic composition of bulk lithogenic sediments from the Eastern Mediterranean Sea (Table 1)

In order to characterize the provenance of lithogenic surface sediments from the Eastern Mediterranean Sea (EMS), residual (leached) fraction of 34 surface samples have been analysed for their 143Nd/144Nd and 87Sr/86Sr isotope ratios. The sample locations bracket all important entrances of riverine suspended matter into the EMS as well as all sub-basins of the EMS. The combined analyses of these two isotope ratios provide a precise characterization of the lithogenic fraction of surface sediments and record their dilution towards the central sub-basins. We reconstruct provenance and possible pathways of riverine dispersal and current redistribution, assuming more or less homogenous isotopic signatures and flux rates of the eolian fraction over the EMS. Lithogenic sediments entering the Ionian Sea from the Calabrian Arc and the Adriatic Sea are characterized by high 87Sr/86Sr isotope ratios and low epsilon-Nd(0) values (average 87Sr/86Sr=0.718005 and epsilon-Nd(0)=-11.06, n=5). Aegean Sea terrigenous sediments show an average ratio of 87Sr/86Sr=0.713089 (n=5) and values of epsilon-Nd(0)=-7.89 (n=5). The Aegean isotopic signature is traceable up to the southwest, south, and southeast of Crete. The sediment loads entering the EMS via the Aegean Sea are low and spread out mainly through the Strait of Casos (east of Crete). Surface sediments from the eastern Levantine Basin are marked by the highest epsilon-Nd(0) values (-3.3, n=6) and lowest 87Sr/86Sr isotope ratios (average 0.709541, n=6), reflecting the predominant input of the Nile sediment. The influence of the Nile sediment is traceable up to the NE-trending, eastern flank of the Mediterranean Ridge. The characterization of the modern riverine dispersal and eolian flux, based on isotope data, may serve as a tool to reconstruct climate-coupled variations of lithogenic sediment input into the EMS.

Modes of sapropel formation in the eastern Mediterranean: some constraints based on pyrite properties

Pyrite formation within and directly below sapropels in the eastern Mediterranean was governed by the relative rates of sulphide production and Fe liberation and supply to the organic-rich layers. At times of relatively high [SO4]2- reduction, sulphide could diffuse downward from the sapropel and formed pyrite in underlying sediments. The sources of Fe for pyrite formation comprised detrital Fe and diagenetically liberated Fe(II) from sapropel-underlying sediments. In organic-rich sapropels, input of Fe from the water column via Fe sulphide formation in the water may have been important as well. Rapid pyrite formation at high saturation levels resulted in the formation of framboidal pyrite within the sapropels, whereas below the sapropels slow euhedral pyrite formation at low saturation levels occurred. d34S values of pyrite are -33 per mil to -50 per mil. Below the sapropels d34S is lower than within the sapropels, as a result of increased sulphide re-oxidation at times of relatively high sulphide production and concentration when sulphide could escape from the sediment. The percentage of initially formed sulphide that was re-oxidized was estimated from organic carbon fluxes and burial efficiencies in the sediment. It ranges from 34% to 80%, varying significantly between sapropels. Increased palaeoproductivity as well as enhanced preservation contributed to magnified accumulation of organic matter in sapropels.

Concentrations of major and minor constituents of samples from the lower end of the cores from the eastern Mediterranean Sea (Table 2)

The pore water chemistry of mud volcanoes from the Olimpi Mud Volcano Field and the Anaximander Mountains in the eastern Mediterranean Sea have been studied for three major purposes: (1) modes and velocities of fluid transport were derived to assess the role of (upward) advection, and bioirrigation for benthic fluxes. (2) Differences in the fluid chemistry at sites of Milano mud volcano (Olimpi area) were compiled in a map to illustrate the spatial heterogeneity reflecting differences in fluid origin and transport in discrete conduits in near proximity. (3) Formation water temperatures of seeping fluids were calculated from theoretical geothermometers to predict the depth of fluid origin and geochemical reactions in the deeper subsurface. No indications for downward advection as required for convection cells have been found. Instead, measured pore water profiles have been simulated successfully by accounting for upward advection and bioirrigation. Advective flow velocities are found to be generally moderate (3-50 cm/y) compared to other cold seep areas. Depth-integrated rates of bioirrigation are 1-2 orders of magnitude higher than advective flow velocities documenting the importance of bioirrigation for flux considerations in surface sediments. Calculated formation water temperatures from the Anaximander Mountains are in the range of 80 to 145 °C suggesting a fluid origin from a depth zone associated with the seismic decollement. It is proposed that at that depth clay mineral dehydration leads to the formation and advection of fluids reduced in salinity relative to sea water. This explains the ubiquitous pore water freshening observed in surface sediments of the Anaximander Mountain area. Multiple fluid sources and formation water temperatures of 55 to 80 °C were derived for expelled fluids of the Olimpi area.

Mineralogy and petrology of Black Sea Basin sediments

The origin and modes of transportation and deposition of inorganic sedimentary material of the Black Sea were studied in approximately 60 piston, gravity, and Kasten cores. The investigation showed that the sediment derived from the north and northwest (especially from the Danube) has a low calcite-dolomite ratio and a high quartz-feldspar ratio. Rock fragments are generally not abundant; garnet is the principal heavy mineral and illite is the predominant clay mineral. This sedimentary material differs markedly from that carried by Anatolian rivers, which is characterized by a high calcite-dolomite ratio and a low quartz-feldspar ratio. Rock fragments are abundant; pyroxene is the principal heavy mineral and montmorillonite is the predominant clay mineral. In generel, the clay fraction is large in all sediments (27.6-86.9 percent), and the lateral distributian indicates an increase in clay consent from the coasts toward two centers in the western and eastern Black Sea basin. Illite is the most common clay mineral in the Black Sea sediments. The lateral changes in composition of the clay mineral can easily be traced to the petrologic character of northern (rich in illite) and southern (rich in montmorillonite) source areas. In almost all cores, a rhythmic change of the montmorillonite-illite ratio with depth was observed. These changes may be related to the changing influence of the two provinces during the Holocene and late Pleistocene. Higher montmorillonite content seems to indicate climctic changes, probably stages of glaciation end permafrost in the northern area, at which time the illite supply was diminished to a large extent. The composition of the sand fraction is relatad to the different petrologic and morphologic characteristics of two major source provimces: (1) a northern province (rich in quartz, feldspars, and garnet) characterized by a low elevation, comprising the Danube basin area and the rivers draining the Russian platform; and (2) a southern province (rich in pyroxene and volcanic and metamorphic rocks) in the mountainous region of Anatolia and the Caucasus, characterized by small but extremely erosive rivers. The textural properties (graded bedding) of the deep-sea send layers clearly suggest deposition from turbidity currents. The carbonate content of the contemporary sediments ranges from 5 to 65 percent. It increases from the coast to a maximum in two centers in the western and eastern basin. This pattern reflects the distribution of the <2-µm fraction. The contemporary mud sedimentation is governed by two important factors: (1) the deposition of terrigenous allochthonous material of low carbonate content originating from the surrounding hinterland (northern and southern source areas), and (2) the autochthonous production of large quantities of biogenic calcite by coccolithophores during the last period of about 3,000-4,000 years.