G-force measurements at Mount Nyiragongo

To evaluate the mechanical stress on the volcanic edifice that results from lava lake level variations, we deployed a self-recording, differential capacitance (MEMS Inertial Sensor STMicroelectronics LIS3LV02DQ), 3-axis X6-1A accelerometer (Gulf Coast Data Concepts, LLC) at a distance of ~100m from the center of the Nyiragongo lava lake on freshly erupted lava flows. The device range was used in high (12-bit) resolution mode, which corresponds to a sensitivity of about 1 mg. The device was set to high-sensitivity mode with four additional bits to improve resolution, yet with a much lower signal-noise ratio. Once in position, the accelerometer continuously recorded data for three-day periods in June 2010. The system was oriented so that the X- and Y-axes form a plain parallel to the lava lake. During data collection, we did not attempt to calibrate the precision of the angle because relative G-force measurements were required instead of absolute G-force measurements. To distinguish the tiny accelerations caused by temperature differentials of the atmosphere, from the forces caused by magma movements, the temperature of the X6-1A device was continuously recorded. Temperature variations were corrected for by applying a de-correlation method to the recorded signal. Data was collected at 20 Hz, regrouped into batches that cover 1 hour per observation and associated with one averaged temperature measurement. This method was reproducible because diurnal temperature variations were the main cause for heating and cooling.

Temperature observation of CORK installation during ODP Leg 168

Four boreholes, drilled a few tens of meters into igneous basement on the eastern flank of the Juan de Fuca Ridge during ODP Leg 168, were sealed and instrumented for long-term monitoring to observe the hydrologic state of young sediment-sealed oceanic crust. The thermal regime is dominated by the effects of rapid fluid circulation in uppermost igneous basement driven by very small non-hydrostatic pressure gradients. Upper basement temperatures are uniform laterally between pairs of holes over distances of hundreds of meters to kilometers. In the case of two holes drilled into a sediment-buried basement ridge and adjacent valley, basement temperatures differ by less than 2 K despite the 2.2 km lateral separation of the sites and the 2.5:1 contrast in sediment cover thickness. Under conductive conditions, upper basement temperatures would differ by roughly 50 K. By comparison with modeling results, the observed degree of isothermality suggests a fluid flux of at least 10**-6 m/s (30 m/yr), and an effective permeability in the range of 10**-10 to 10**-9 m**2 in the uppermost igneous crust. The pressure difference available to drive this rapid flux between the ridge and valley, estimated by comparing the observed pressures via the isothermal upper basement hydrostat that is inferred to connect the two sites, is small (~2 kPa) and also suggests high permeability. Relative to the hydrostats defined by the local conductive sediment geotherms, substantial super-hydrostatic pressure (+18 kPa) is present within the buried basement ridge, and sub-hydrostatic pressure is present in the adjacent valley (-26 kPa). Such pressure differentials are the direct consequence of the advection-dominated thermal regime and small pressure losses in high-permeability basement, and are available to drive fluid seepage through sediment sections vertically up above and horizontally away from buried ridges, and down above valleys. No constraints are provided by any of the observations on the depth in the crust to which thermally or chemically significant flow might extend, although just as in the overlying sediments, the pattern of deep flow may be affected by the near-isothermal and near-hydrostatic conditions present in the permeable uppermost crustal section.