Sediment composition of ODP Hole 130-803D

Samples obtained in Hole 803D for shipboard determination of index properties were analyzed to determine their microfossil constituents. The resulting data are compared to shipboard-measured physical properties data to assess the relationships between small-scale fluctuations in physical properties and microfossil content and preservation. The establishment of relationships involving index properties of these highly calcareous sediments is difficult because of the role of intraparticle porosity. Relationships were observed between calculated interparticle porosity and microfossil content. Impedance, calculated using bulk density based on interparticle porosity, exhibits an increase with increasing grain size. Variations in the coarse fraction constituents appear to exert more control over physical properties than variations in the fine-fraction constituents, although the fine fraction make up greater than 85% of the samples by weight.

Supplementary material: XRF core scanning data, CaCO3 values, foraminiferal carbon and oxygen isotope data, Mg/Ca data, clay mineralogy and helium isotope results

The Paleocene-Eocene Thermal Maximum (PETM; ~56 Ma) is associated with abrupt climate change, carbon cycle perturbation, ocean acidification, as well as biogeographic shifts in marine and terrestrial biota that were largely reversed as the climatic transient waned. We report a clear exception to the behavior of the PETM as a reversing climatic transient in the eastern North Atlantic (Deep-Sea Drilling Project Site 401, Bay of Biscay) where the PETM initiates a greatly prolonged environmental change compared to other places on Earth where records exist. The observed environmental perturbation extended well past the d13C recovery phase and up to 650 kyr after the PETM onset according to our extraterrestrial 3He-based age-model. We observe a strong decoupling of planktic foraminiferal d18O and Mg/Ca values during the PETM d13C recovery phase, which in combination with results from helium isotopes and clay mineralogy, suggests that the PETM triggered a hydrologic change in western Europe that increased freshwater flux and the delivery of weathering products to the eastern North Atlantic. This state change persisted long after the carbon-cycle perturbation had stopped. We hypothesize that either long-lived continental drainage patterns were altered by enhanced hydrological cycling induced by the PETM, or alternatively that the climate system in the hinterland area of Site 401 was forced into a new climate state that was not easily reversed in the aftermath of the PETM.

Grain size distribution, carbon content and wet bulk density of sediment cores in the equatorial Atlantic and the Norwegian Sea

Near-surface sediments from the equatorial east Atlantic and the Norwegian Sea exhibit pronounced shear strength maxima in profiles from the peak Holocene and Pleistocene. These semi-indurated layers start to occur at 8-102 cm below the sediment surface and can be explained neither by the modal composition nor by the effective overburden pressure of the sediments. However, scanning electron microscope and microprobe data exhibit micritic crusts and crystal carpets, which are clearly restricted to (undisturbed) samples from indurated layers and form a manifest explanation for their origin. The minerals precipitated comprise calcite, aragonite, and in samples more proximal to the African continent SiO2 needles, and needles of as yet unidentified K-Mg-Fe-Al silicates, crusts of which dominate the indurated layers in the Norwegian Sea. By their stratigraphic position in deep-sea sediments the carbonate-based shear strength maxima are tentatively ascribed to dissolved adjacent pteropod layers from the early Holocene and hence to short-lived no-analogue events of early diagenesis. Possibly, they have been controlled by a reduced organic carbon flux, leading to increased aragonite preservation in the deep sea.