Concentrations of suspended matter and heavy metals in melted ice- and snow water from the Barents Sea

In September-October 1998, during Cruise 14 of R/V Akademik Fedorov to the Barents Sea, in the region of 82° N between the Spitsbergen and Novaya Zemlya archipelagos samples of snow and ice were collected within four polygons. By means of atomic absorption with an electothermal atomizer (onboard the ship) in filtered (dissolved form) and unfiltered (sum of dissolved and particulate forms) samples of snow melt and ice melt concentrations of Fe, Mn, Cu, Cr, Ni, Co, Pb, and Cd were determined in order to estimate level of potential contamination of snow and ice with these metals. Excluding data on Ni, Cd (and probably Cu) in ice that were regarded to be unsatisfactory because of probable contamination of the ice samples during drilling concentrations of all the elements in snow and ice of the northern part of the Barents Sea appeared to be close to their background values or below. An attempt to identify the main sources of metal supply to snow from the atmosphere by comparison of ratios of metal particulate form to total content in snow of the Barents Sea and the same ratios in snow samples from clean regions of Finland and from contaminated areas of the Kola Peninsula showed that aerosols in the area of the expedition were supplied into the Barents Sea atmosphere from different sources, both natural and anthropogenic.

(Table 3, page 280) Chemical composition of micronodules from a series of stations and sediment depths from Areas C, F, G and K in the Pacific Ocean from R/V Sonne Cruise SO06

Compositional data for coexisting manganese nodules, micronodules, sediments and pore waters from five areas in the equatorial and S.W. Pacific have been obtained. This represents the largest study of its type ever undertaken to establish the distribution of elements between the various phases within the sediment column. The composition of manganese nodules, micronodules and sediments (on a carbonate-free basis) shows marked differences between the equatorial high productivity zone and the low productivity region of the S.W. Pacific. In the case of the nodules, th is reflects an increased supply of transition elements (notably Ni, Cu and Zn) to the nodules as a result of the in situ dissolution of siliceous tests within the sediment column in the equatorial Pacific high productivity zone. Micronodules display similar, but somewhat different, compositions to those of the associated nodules in each area. Micronodule composition is therefore influenced by the same basic factors that control nodule composition, but is modified by dissolution of the micronodules in situ within the sediment column. Locally, as in the area immediately south of the Marquesas Fracture Zone, the micronodule population is contaminated by small, angular volcanic rock fragments; this leads to apparently anomalous micronodule compositions. Micronodules appear to be a transient feature in the sediment column, especially in the equatorial Pacific. Dissolution of micronodules in the sediment column therefore represents an important source of elements for the growth of manganese nodules in the equatorial Pacific. Sediment composition is markedly influenced by the carbonate content. On a carbonate-free basis, the sediments from the equatorial high productivity zone are quite distinct in composition from those in the S.W. Pacific. This reflects differences in the lithology of the sediments. In the Aitutaki Passage, the local influence of volcanoclastic material in sediment composition has been established. The major cations and anions in pore waters measured here show no major differences between equatorial and S.W. Pacific sediments. Silica is, however, higher in equatorial Pacific pore waters reflecting the dissolution of siliceous tests in these sediments.