Age and chemical composition of apatites from five DSDP and ODP Sites in the Pacific, Atlantic and Indian Oceans

Since studies on deep-sea cores were carried out in the early 1990s it has been known that ambient temperature may have a marked affect on apatite fission track annealing. Due to sluggish annealing kinetics, this effect cannot be quantified by laboratory annealing experiments. The unknown amount of low-temperature annealing remains one of the main uncertainties for extracting thermal histories from fission track data, particularly for samples which experienced slow cooling in shallow crustal levels. To further elucidate these uncertainties, we studied volcanogenic sediments from five deep-sea drill cores, that were exposed to maximum temperatures between ~10° and 70°C over geological time scales of ~15-120 Ma. Mean track lengths (MTL) and etch pit diameters (Dpar) of all samples were measured, and the chemical composition of each grain analyzed for age and track length measurements was determined by electron microprobe analysis. Thermal histories of the sampled sites were independently reconstructed, based on vitrinite reflectance measurements and/or 1D numerical modelling. These reconstructions were used to test the most widely used annealing models for their ability to predict low-temperature annealing. Our results show that long-term exposure to temperatures below the temperature range of the nominal apatite fission track partial annealing zone results in track shortening ranging between 4 and 11%. Both chlorine content and Dpar values explain the downhole annealing patterns equally well. Low chlorine apatite from one drill core revealed a systematic relation between Si-content and Dpar value. The question whether Si-substitution in apatite has direct and systematic effects on annealing properties however, cannot be addressed by our data. For samples, which remained at temperatures <30°C, and which are low in chlorine, the Laslett et al. [Laslett G., Green P., Duddy I. and Gleadow A. (1987) Thermal annealing of fission tracks in apatite. Chem. Geol. 65, 1-13] annealing model predicts MTL up to 0.6 µm longer than those actually measured, whereas for apatites with intermediate to high chlorine content, which experienced temperatures >30°C, the predictions of the Laslett et al. (1987) model agree with the measured MTL data within error levels. With few exceptions, predictions by the Ketcham et al. [Ketcham R., Donelick R. and Carlson W. (1999) Variability of apatite fission-track annealing kinetics. III: Extrapolation to geological time scales. Am. Mineral. 84/9, 1235-1255] annealing model are consistent with the measured data for samples which remained at temperatures below ~30°C. For samples which experienced maximum temperatures between ~30 and 70°C, and which are rich in chlorine, the Ketcham et al. (1999) model overestimates track annealing.

Major ion concentrations and chlorine isotope composition of water-soluble chloride and structurally bound chloride in DSDP/ODP serpentinized ultramafic rocks

Eight DSDP/ODP cores were analyzed for major ion concentrations and d37Cl values of water-soluble chloride (d37Clwsc) and structurally bound chloride (d37Clsbc) in serpentinized ultramafic rocks. This diverse set of cores spans a wide range in age, temperature of serpentinization, tectonic setting, and geographic location of drilled serpentinized oceanic crust. Three of the cores were sampled at closely spaced intervals to investigate downhole variation in Cl concentration and chlorine isotope composition. The average total Cl content of all 86 samples is 0.26±0.16 wt.% (0.19±0.10 wt.% as water-soluble Cl (Xwsc) and 0.09±0.09 wt.% as structurally bound Cl (Xsbc)). Structurally bound Cl concentration nearly doubles with depth in all cores; there is no consistent trend in water-soluble Cl content among the cores. Chlorine isotope fractionation between the structurally bound Cl**- site and the water-soluble Cl**- site varies from -1.08? to +1.16?, averaging to +0.21?. Samples with negative fractionations may be related to reequilibration of the water-soluble chloride with seawater post-serpentinite formation. Six of the cores have positive bulk d37Cl values (+0.05? to +0.36?); the other two cores (173-1068A (Leg-Hole) and 84-570) have negative bulk d37Cl values (-1.26? and -0.54?). The cores with negative d37Cl values also have variable Cl**-/SO4**2- ratios, in contrast to all other cores. The isotopically positive cores (153-920D and 147-895E) show no isotopic variation with depth; the isotopically negative core (173-1068A) decreases by ~1? with depth for both the water-soluble and structurally bound Cl fractions. Non-zero bulk d37Cl values indicate Cl in serpentinites was incorporated during original hydration and is not an artifact of seawater infiltration during drilling. Cores with positive d37Cl values are most likely explained by open system fractionation during hydrothermal alteration, with preferential incorporation of 37Cl from seawater into the serpentinite and loss of residual light Cl back to the ocean. Fluid / rock ratios were probably low as evidenced by the presence of water-soluble salts. The two isotopically negative cores are characterized by a thick overlying sedimentary package that was in place prior to serpentinization. We believe the low d37Cl values of these cores are a result of hydration of ultramafic rock by infiltrating aqueous pore fluids from the overlying sediments. The resulting serpentinites inherit the characteristic negative d37Cl values of the pore waters. Chlorine stable isotopes can be used to identify the source of the serpentinizing fluid and ultimately discern chemical and tectonic processes involved in serpentinization.

Ash layer characteristics and major element oxide content of glasses from ODP Sites 162-982 and 162-985

The Cenozoic volcanic activity on Iceland has been recorded in North Atlantic sediments drilled during several Ocean Drilling Program (ODP)/Deep Sea Drilling Project legs (Legs 104, 151, 152, 162, and 163). Leg 162 (North Atlantic-Arctic Gateways II) recovered ash layers at Sites 982, 985, and 907 (Jansen, Raymo, Blum, et al., 1996, doi:10.2973/odp.proc.ir.162.1996). The revisited Site 907 was first drilled during Leg 151, and the ash from this site has been described in detail by Lacasse et al. (1996, doi:10.2973/odp.proc.sr.151.122.1996) and Werner et al. (1996, doi:10.2973/odp.proc.sr.151.123.1996). Site 982 is located within the Hatton-Rockall Basin on the Rockall Plateau, which is situated west of the British Isles. Site 985 is located northeast of Iceland at the foot of the eastern slope of the Iceland Plateau, adjacent to the Norwegian Basin. Here we report chemical analyses of Neogene tephra layers from Holes 982A, 983B, 982C, 985A, and 985B. The sedimentary sequence at Site 982 spans the lower Miocene-Holocene; Site 985 recovered sediments spanning the upper Oligocene-Holocene. Twenty-two distinct ash layers and ash-bearing sediments were sampled in Holes 982A-982C (Cores 162-982A-16H through 24H, 162-982B-14H through 56X, and 162-982C-15H through 27H), and 59 ash layers were sampled in Holes 985A and 985B (Cores 162-985A-11H through 59X, and 162-985B-11H through 14H). Almost 50% of the sampled ash is strongly altered (predominantly from Site 985). A cluster of altered thin layers in the lower Pliocene of Site 985 (top of Unit III) is remarkable.

Geochemistry, microbiology and phospholipid fatty acid content of ODP Site 169-1036 sediments

Phospholipid fatty acids were measured in samples of 60°-130°C sediment taken from three holes at Site 1036 (Ocean Drilling Program Leg 169) to determine microbial community structure and possible community replacement at high temperatures. Five of six samples had similar concentrations of phospholipid fatty acids (2-6 pmol/g dry weight of sediment), and biomass estimates from these measurements compare favorably with direct microscopic counts, lending support to previous microscopic measures of deep sedimentary biomass. Very long-chain phospholipid fatty acids (21 to 30 carbons) were detected in the sediment and were up to half the total phospholipid fatty acid measured; they appear to increase in abundance with temperature, but their significance is not known. Community composition from lipid analysis showed that samples contained standard eubacterial membrane lipids but no detectable archaeal lipids, though archaea would be expected to dominate the samples at high temperatures. Cluster analysis of Middle Valley phospholipid fatty acid compositions shows that lipids in Middle Valley sediment samples are similar to each other at all temperatures, with the exception of very long-chain fatty acids. The data neither support nor deny a shift to a high-temperature microbial community in hot cores, so at the present time we cannot draw conclusions about whether the microbes observed in these hot sediments are active.

(Table 1) Granulometry, soil pH, carbonate content and color description of soil profiles obtained in Xinghai, Tibet

Large parts of the eastern half of the Tibetan Plateau are covered between (3,500) 4,000 and nearly 6,000 m a.s.l. by alpine sedge mats (key species Kobresia pygmea), which attain an extension of ca. 450,000 km**2. It is considered to be the world's largest alpine ecosystem. Moreover, there exist isolated (relic) forests in the same area up to an altitude of 4,700 m a.s.l. mainly consisting of juniper (Juniperus) and spruce (Picea). Large parts of the Kobresia ecosystem are expected to be a grazing-resistant replacement formation, replacing forests and grass-dominated plant communities due to human and/or climatic impact. Recently, a research project was launched to increase knowledge about the properties and genesis of these forests and sedge mats (Present-day dynamics and Holocene landscape history of fragmented forest biocoenoses in Tibet; headed by G. Miehe, Marburg).

(Table 3) Boron and chlorine in atmospheric moisture and rain water collected on the shore of the Golubaya Bay in 1970

Boron and chlorine were determined in rain water and in atmospheric moisture condensed in a "Saratov" refrigerator. Ocean is the main source of boron on the earth surface. Boron evaporates from the ocean and enriches atmospheric precipitation: B/Cl ratio of ocean water (0.00024) increases by factor of 10-15. Assuming that the average Cl content in global river runoff is 7.8 mg/l and boron content 0.013 mgl, B/Cl ratio in this runoff is 0.0017. The average B/Cl ratio in rain water of the Golubaya (Blue) Bay (Gelendzhik, Black Sea region) is 0.0026 and in condensates of atmospheric moisture during onshore and offshore winds in the same region it averages from 0.0029 to 0.0033. The maximum boron content in the condensates of this region during onshore winds was 0.032 mg/l and the minimum during offshore winds, 0.004 mg/l. /Cl ratio in sea water over the Atlantic Ocean and in the Gelendzhik area of the Black Sea varied within narrow range, mostly from 0.0025 to 0.0035. Similar B/Cl ratio (0.0024) was found for atmospheric precipitation on the slope of the Terskei Ala-Tau near the Issyk-Kul Lake in 1969. Thus, although chemistries of boron and chlorine (in chlorides) are very different, the B/Cl ratio in the atmosphere is fairly constant. This can be taken as a confirmation of an assumption that salt composition of sea water passes into the atmosphere in molecularly dispersed state. Supposing that the ocean-atmosphere system is in equilibrium as regards to the boron budget, it can be assumed that the same amount of boron passes from the ocean into bottom sediments and from lithosphere rocks and soils into the hydrosphere.

Table 2. The element content of manganese crust

The terrains in the South China Sea were apart of the Southeast China continent, and their rift-departing process dominated the formation and evolution of the South China Sea. The survey results of topography and paleoenvironment of the northern South China Sea during SO-49 cruise demonstrate that the terrains rift-departed from the South China continent before early Eocene.

(Table 1) Results of pore water analyses, including boron content and boron isotope ratios

Drilling a transect of holes across the Costa Rica forearc during ODP Leg 170 demonstrated the margin wedge to be of continental, non accretionary origin, which is intersected by permeable thrust faults. Pore waters from four drillholes, two of which penetrated the décollement zone and reached the underthrust lower plate sedimentary sequence of the Cocos Plate, were examined for boron contents and boron isotopic signatures. The combined results show dilution of the uppermost sedimentary cover of the forearc, with boron contents lower than half of the present-day seawater values. Pore fluid "refreshening" suggests that gas hydrate water has been mixed with the sediment interstitial water, without profoundly affecting the d11B values. Fault-related flux of a deeply generated fluid is inferred from high B concentration in the interval beneath the décollement, being released from the underthrust sequence with incipient burial. First-order fluid budget calculations over a cross-section across the Costa Rica forearc indicate that no significant fluid transfer from the lower to the upper plate is inferred from boron fluid profiles, at least within the frontal 40 km studied. Expulsed lower plate pore water, which is estimated to be 0.26-0.44 km3 per km trench, is conducted efficiently along and just beneath the décollement zone, indicating effective shear-enhanced compaction. In the upper plate forearc wedge, dewatering occurs as diffuse transport as well as channelled flow. A volume of approximately 2 km3 per km trench is expulsed due to compaction and, to a lesser extent, lateral shortening. Pore water chemistry is influenced by gas hydrate instability, so that it remains unknown whether deep processes like mineral dehydration or hydrocarbon formation may play a considerable role towards the hinterland.

(Table 2) Chlorine geochemistry and mineralogy of altered oceanic crust samples

Bulk chlorine concentrations and chlorine stable isotope compositions were determined for hydrothermally altered basalt (extrusive lavas and sheeted dikes) and gabbro samples (n = 50) from seven DSDP/ODP/IODP drill sites. These altered oceanic crust (AOC) samples span a range of crustal ages, tectonic settings, alteration type, and crustal depth. Bulk chlorine concentrations range from < 0.01 wt.% to 0.09 wt.%. In general, higher chlorine concentrations coincide with an increase in temperature of alteration and amphibole content. d37Cl values of whole rock AOC samples range from -1.4 to +1.8 per mil. High d37Cl values (>=~0.5 per mil) are associated with areas of higher amphibole content. This observation is consistent with theoretical calculations that estimate amphibole should be enriched in 37Cl compared to co-existing fluid. Negative to near zero d37Cl values are found in areas dominated by clay minerals. Chlorine geochemistry is a rough indicator of metamorphic grade and mineralogy. AOC is a major Cl host in the subducting oceanic lithospheric slab. Here we show that bulk chlorine concentrations are ~3 times higher than previous estimates resulting in a greater contribution of Cl to the mantle.