Oil viscosity from experiments and model calculations

Five frequently-used models were chosen and evaluated to calculate the viscosity of the mixed oil. Totally twenty mixed oil samples were prepared with different ratios of light to crude oil from different oil wells but the same oil field. The viscosities of the mixtures under the same shear rates of 10 s**-1 were measured using a rotation viscometer at the temperatures ranging from 30°C to 120°C. After comparing all of the experimental data with the corresponding model values, the best one of the five models for this oil field was determined. Using the experimental data, one model with a better accuracy than the existing models was developed to calculate the viscosity of mixed oils. Another model was derived to predict the viscosity of mixed oils at different temperatures and different values of mixing ratio of light to heavy oil.

Table 1. Mean geochemical values for Baseline (pre-injection) and Monitor-1 (post-injection) samples, and the percent change between the two weighted means

The Weyburn Oil Field, Saskatchewan is the site of a large (5000 tonnes/day of CO2) CO2-EOR injection project By EnCana Corporation. Pre- and post-injection samples (Baseline and Monitor-1, respectively) of produced fluids from approximately 45 vertical wells were taken and chemically analyzed to determine changes in the fluid chemistry and isotope composition between August 2000 and March 2001. After 6 months of CO2 injection, geochemical parameters including pH, [HCO3], [Ca], [Mg], and ?13CO2(g) point to areas in which injected CO2 dissolution and reservoir carbonate mineral dissolution have occurred. Pre-injection fluid compositions suggest that the reservoir brine in the injection area may be capable of storing as much as 100 million tonnes of dissolved CO2. Modeling of water-rock reactions show that clay minerals and feldspar, although volumetrically insignificant, may be capable of acting as pH buffers, allowing injected CO2 to be stored as bicarbonate in the formation water or as newly precipitated carbonate minerals, given favorable reaction kinetics.

Composition of organic matter in suspended matter and bottom sediments of the southeastern Baltic Sea

Data on contents and compositions of hydrocarbons (HCs)-aliphatic (AHCs) and polycyclic aromatic (PAHs) are provided in comparison with contents of total organic carbon (Corg), lipids in suspended matter, and Corg in bottom sediments. Particular attention is paid to distribution of HCs in the area of the Kravtsov oil field. It is established that concentrations of AHCs in water are governed by concentrations of suspended matter and elevated AHC concentrations are confined to coastal areas. In the area of D-6 platform sandy bottom sediments are notable for great variability of HC concentrations, both laterally and from year to year. In summer of 2010 average content of AHCs was 40 ppm (19% of Corg) and that of PAHs was 0.023 ppm. Natural seepage from sediment mass is considered to be a source of HCs along with oil contamination.

Stable and radiogenic isotope ratios in pore waters from ODP Leg 127 sites

Interstitial waters from four sites of the Japan Sea (794 to 797) have been analyzed for stable isotopes (delta D, delta11B, delta18O, and delta34S) and 87Sr/86Sr, besides major and minor ions. The isotopic composition is dominated by organic matter degradation, alteration of ash layers and volcaniclastic sands, silica transformation (opal A/CT), and basement alteration. Organic matter degradation and corresponding sulfate reduction leads to 32S depletion and is dependent upon sedimentation rate. The remaining sulfate reservoir is characterized by very "heavy" delta34S ratios, up to +93 ? (rel. CDT = Canyon Diabolo Troilite). "Barite fronts," which may develop in such sediments, should also be characterized by very "heavy" sulfur isotopes. The alteration of volcaniclastic material in the Quaternary sections influences the delta18O (-1.5 ? shift) and delta11B (desorption and later adsorption of "labile"11B). A pronounced positive delta11B anomaly at Site 795 represents the depth range of preferential 10B uptake by alteration products of the ash layers. At Site 796 delta D, delta11B, and 87Sr/86Sr are severely affected by alteration processes of volcaniclastic sands. The opal A/CT transformation may influence the oxygen isotopes and serves as a potential source for B, which is liberated at this interval at Site 795. This positive B anomaly is not reflected in the delta11B profile. Basement alteration processes dominate the sedimentary sequence below the opal A/CT transition, which serves as a chemical and physical boundary. The decreases in delta D and delta18O are probably related to a "paleo ocean water reservoir" situated in the permeable Layer II of the oceanic crust, as is indicated by the positive correlation between these two parameters. Besides Mg, alkalies and delta18O basement rocks also serve as a sink for 11 B (Site 795) and are the source for the Ca and Sr increases, as is documented by the less radiogenic 87Sr/86Sr ratio. 87Sr/86Sr ratios for the lowermost pore waters from Site 795 (0.70529) are comparable to those from volcaniclastic rocks from the "Green Tuff' region (0.704 to 0.706) and oil field brines from the Niigata Oil Field.

Chemical composition of bottom waters and interstitial waters from sediments and deposits within and outside the Haakon Mosby submarine mud volcano in the Norwegian Sea

On the base of data of Cruise 40 of R/V Akademik Keldysh features of formation of saline composition of interstitial waters from sediments containing free hydrocarbons (methane) and gas hydrates (CH4 x 6H2O) were considered. Chemical composition of the interstitial waters is presented for three zones of sediments from the Haakon Mosby submarine mud volcano: (1) zone of kettles containing free hydrocarbons, (2) gas hydrate sediments, and (3) periphery of the volcano. Abnormally high concentrations of bromine and especially iodine characteristic of the interstitial and particularly of the oil-field waters were found. Because of a great interest in natural gas hydrates found in marine sediments, we obtained a possibility to supplement scarce of available published data with some new information.

Anaerobic methanotrophic archaea-2 and Desulfosarcina/Desulfococcus group in sediments at different stations

The anaerobic oxidation of methane (AOM) with sulfate as terminal electron acceptor is mediated by consortia of methanotrophic archaea (ANME) and sulfate-reducing bacteria (SRB). In sediment samples from Hydrate Ridge, the Isis Mud Volcano and the Gulf of Mexico, DSS cells accounted for 3-6% of all DAPI-stained single cells. Out of these, 8-17% were labelled with probe SEEP1a-1441. This translated into relative abundances of single SEEP-SRB1a cells of 0.3% to 0.7%. Contrastingly, in a sediment sample from the Gullfaks oil field, DSS cells accounted for 18% and SEEP-SRB1a for 9% of all single cells. This sediment sample also featured an unusually high abundance of single ANME-2 cells and only very few ANME-2/DSS aggregates in comparison with other AOM habitats. Considering also the nature of the sample, it is likely that the high number of single ANME-2 and SEEP-SRB1a cells were an artifact of sample preparation. Here, harsher sonication was required to remove the microorganisms from coarse sand prior to CARD-FISH analysis.