Interstitial water chemistry at DSDP Leg 57 Holes

Analyses of water samples taken by means of an in-hole sampler generally show good agreement with analyses of samples collected by routine shipboard squeezing techniques. At Sites 438 and 439, a decrease in salinity with depth is related to former freshwater flow from an aquifer that crops out at an anticline on a deep sea terrace between Japan and the top of the trench slope of the Japan Trench. This former subaerial recharge suggests significant late Cenozoic subsidence of the terrace, because it now lies at a water depth of 1500 meters. Samples from the trench slope at Site 440 have extremely high values of alkalinity and ammonia, presumably because of a favorable combination of high sedimentation rate and organic carbon content. Diagenetic conditions on the trench slope favor formation of the Fe-Mg carbonate mineral, ankerite; at Site 440 it first occurs at a depth below the sea floor of only 29 meters in late Pleistocene strata. Undissolved diatoms persist to relatively great depth at the sites of Leg 57 because of a low geothermal gradient caused by subduction. Secondary silica lepispheres first appear at 851 meters at the most landward and warmest site, Site 438, in strata 16 million years old with an ambient temperature of 31 °C.

Zooplankton and seston in the White Sea and its chemical composition

A technique of zooplankton net sampling at night in the Kandalaksha and Dvinskii Bays and during the full tide in the Onezhskii Bay of the White Sea allowed us to obtain "clean" samples without considerable admixtures of terrigenous particulates. Absence of elements-indicators of the terrigenous particulates (Al, Ti, and Zr) in the EDX spectra allows to conclude that ash composition of tested samples is defined by constitutional elements comprising organic matter and integument (chitin, shells) of plankton organisms. A quantitative assessment of accumulation of ca. 40 chemical elements by zooplankton based on a complex of modern physical methods of analysis is presented. Values of the coefficient of the biological accumulation of the elements (Kb) calculated for organic matter and the enrichment factors (EF) relative to Clarke concentrations in shale are in general determined by mobility of the chemical elements in aqueous solution, which is confirmed by calculated chemical speciation of the elements in the inorganic subsystem of surface waters of Onezhskii Bay.

Composition of Fe-Mn micronodules, nodules and host bottom sediments from the Northeast Pacific Basin

Authigenic ferromanganese manifestations in bottom sediments from two horizons (0-10 and 240-250 cm) located in the low/high bioproductive transitional zone of the Pacific Ocean were studied. In addition two compositionally different types of micronodules, crusts and ferromanganese nodules were detected in the surface horizon (0-1 cm). Three size fractions (50-100, 100-250, and 250-500 µm) of manganese micronodules were investigated. In terms of surface morphology, color, and shape, the micronodules are divided into dull round (MN1) and angular lustrous (MN2) varieties with different mineral and chemical compositions. MN1 are enriched in Mn and depleted in Fe as compared with MN2. Mn/Fe ratio in MN1 varies from 13 to 14. Asbolane-buserite and birnessite are the major manganese minerals in them. MN2 is mainly composed of vernadite with Mn/Fe ratio from 4.3 to 4.8. Relative to MN1, fraction 50-100 µm of MN2 is enriched in Fe (2.6 times), W (1.8), Mo (3.2), Th (2.3), Ce (5.8), and REE (from 1.2 to 1.8). Relative to counterparts from MN1, separate fractions of MN2 are characterized by greater compositional difference. For example, increase in size of micronodules leads to decrease in contents of Fe (by 10 rel. %), Ce (2 times), W (2.1 times), Mo (2.2 times), and Co (1.5 times). At the same time one can see increase in contents of other elements: Th and Cu (2.1 times), Ni (1.9 times), and REE (from 1.2 to 1.6 times). Differences in chemical and mineral compositions of MN1 and MN2 fractions can be related to alternation of oxidative and suboxidative conditions in the sediments owing to input of labile organic matter, which acts as the major reducer, and allochthonous genesis of MN2.

Annotated record and illustrations of Mn nodules retrieved during cruise KH-73-4 of the R/V Hakuho Maru and cruises GH76-1 and GH77-1 of the R/V Hakurei Maru

Deep sea manganese nodules from the Central Pacific Basin are mainly composed of 10Ã… manganite and d-MnO2 Two zones equivalent to the minerals are evidently distinguishable according to their optical properties. Microscopic and microprobe analyses revealed quite different chemical compositions and textnral characteristics of the two zones. These different feature of the two zones of nodules suggest the different conditions under which they were formed. Concentrations of 11 metal elements in the zones and inter-element relationships show that the 10Ã… manganite zone is a monomineralic oxide phase containing a large amount of manganese and minor amounts of useful metals, and that the d-MnO2 zone which is apparently homogeneous under the microscope is a mixture of three or more different minerals. The chemical characteristics of the two zones can explain the variation of bulk composition of deep sea manganese nodules and inter-element relationships previously reported, suggesting that the bulk compositions are attributable to the mixing of the 10Ã… manganite and d-MnO2 zones in various ratios. Characteristic morphology and surface structure of some types of nodules and their relationships to chemistry are also attribut able to the textural and chemical features of the above mentioned two phases. Synthesis of hydrated manganese oxides was carried out in terms of the formation of manganese minerals in the ocean. The primary product which is an equivalent to d-MnO2 was precipitated from Mn 2+ -bearing alkaline solution under oxigenated condition by air bubbling at one atmospheric pressure and room temperature. The primary product was converted to a l0Ã… manganite equivalent by contact with Ni 2+, Cu 2++ or CO2+ chloride solutions. This reaction caused the decrease of Ni2+, Cu2+ or CO2+ concentrations and the increase of Na+ concentration in the solution. The reaction also proceeded even in diluted solutions of nickel chloride and resulted in a complete removal of Ni2+ from the solution. Reaction products were exclusively 10Ã… manganite equivalents and their chemical compositions were very similar to those of 10Ã… manganite in manganese nodules. The maximum value of(Cu+Ni+Co)/Mn ratio of 10Ã… manganite zones in manganese nodules is 0.16, and the Ni/Mn ratio of synthetic 10Ã… manganite ranges from 0.15 to 0.18 with the average of 0.167.

Contents of metal cations exchange capacity of ore minerals in ferromanganese micronodules from the Atlantic, Indian and Pacific Oceans

Results of experimental studies of ion exchange properties of manganese and iron minerals in micronodules from diverse bioproductive zones of the World Ocean were considered. It was found that sorption behavior of these minerals was similar to that of ore minerals from ferromanganese nodules and low-temperature hydrothermal crusts. The exchange complex of minerals in the micronodules includes the major (Na**+, K**+, Ca**2+, Mg**2+, and Mn**2+) and subordinate (Ni**2+, Cu**2+, Co**2+, Pb**2+, and others) cations. Reactivity of theses cations increases from Pb**2+ and Co**2+ to Na**+ and Ca**2+. Exchange capacity of micronodule minerals increases from alkali to heavy metal cations. Capacity of iron and manganese minerals in oceanic micronodules increases in the following series: goethite < goethite + birnessite < todorokite + asbolane-buserite + birnessite < asbolane-buserite + birnessite < birnessite + asbolane-buserite < birnessite + vernadite ~= Fe-vernadite + Mn-feroxyhyte. Obtained data supplement available information on ion exchange properties of oceanic ferromanganese sediments and refine the role of sorption processes in redistribution of metal cations at the bottom water - sediment interface during micronodule formation and growth.

(Table 2) Concentrations of dissolved Zn, Cd, Pb, and Cu in waters of the Baltic Sea

A method of determination of low concentrations of zinc, cadmium, lead, and copper dissolved in seawater and interstitial water with use of inversion voltammetry with AC solution conditions is described. The optimum conditions for measurements with accumulation on a mercury-film electrode with a silver substrate are presented. Detection limit is 0.2 ?g/l for zinc and 0.05 ?g/l for cadmium, lead, and copper. Large number of determinations can be carried out during expeditions at natural pH of seawater containing these four metals.

(Table 2) Trace element composition of seleceted clast and matrix materials from ODP Site 125-786

Shipboard examination of volcanic and sedimentary strata at Site 786 suggested that at least four types of breccias are present: flow-top breccias, associated with cooling and breakup on the upper surface of lava flows; autobreccias, formed by in-situ alteration at the base of flows; fault-gouge breccias; and true sedimentary breccias derived from weathering and erosion of underlying flows. It is virtually impossible to assess the origin of breccia matrix by textural and mineralogical analyses alone. However, it is fundamental for our understanding of breccia provenance to determine the source component of the matrix material. Whether the matrix is uniquely clastderived can be determined by geochemical fingerprinting. Trace elements that are immobile during weathering and alteration do not change their relative abundances. A contribution to the matrix from any source with an immobile trace element signature different from that of the clasts would appear as a perturbation of the trace element signature of the matrix. Trace element analysis of bulk samples from clasts and matrix material in individual breccia units was undertaken in a fashion similar to that used by Brimhall and Dietrich (1987, doi:10.1016/0016-7037(87)90070-6) in analyzing soil provenance: (1) to help distinguish between sedimentary and volcanic breccias, (2) to determine the degree of mixing and depth of erosion in sedimentary breccias, and (3) to analyze the local provenance of the individual breccia components (matrix and clasts). The following elements were analyzed by X-ray fluorescence (XRF): Rb, Sr, Ba, U, Zr, Cu, Zn, Ti, Cr, and V. Of these elements, Zr and Ti probably exhibit truly immobile behavior (Humphris and Thompson, 1978, doi:10.1016/0016-7037(78)90222-3 ). The remaining elements are useful as a reference for the extent of compositional change during the formation of matrix material (Brimhall and Dietrich, 1987, doi:10.1016/0016-7037(87)90070-6).

(Table 2) Geochemical composition of suspended matter samples from the northern Dvina River

The results of the analysis of samples of the Northern Dvina River's suspended particulate matter obtained by the sedimentation method from large water volumes in the periods of the spring high water and summer low water are presented. By the method of sequential leaching using different reagents, four fractions have been separated: the F1 is the sorbed complex and carbonates, the F2 is the amorphous hydroxides of Fe and Mn, the F3 is the form connected with the organic matter, and the F4 is the residual or silicate-detrital (inert) form. The data have shown that all ten elements determined were grouped with respect to the ratio of the distinguished forms: F4 is the predominant form for Al and Fe (73-88% of all the forms; however, the summer sample contains only 38% of this form of iron, and F2 is the predominant form for this period with 46.6%). As to Mn, the F1, F2, and F4 are nearly equally distributed in the spring high water samples, and only the F3 form is less important (5.4%). In the summer sample, the manganese sorbed complex is predominant (53.5%); for Cu, Ni, Cr, and Co, the inert F4 form is predominant (60-70%) in the sample of the spring suspended matter. The summer low water suspended matter has a lower F4 contribution (25-45%); for Zn, Pb, and Cd, the equal distribution of the forms in the spring samples is typical, while the summer suspended matter differs by the F2 form's predominance (53-61% for Zn and Pb). The main conclusion from the acquired data is that the geochemical mobility of all the studied elements, except for cadmium, in the summer low water suspended matter is higher than in the spring suspended matter. The more intensive biogeochemical processes in August, the high level of organic matter, and the higher contribution of phytoplankton lead to the intensification of the metals' geochemical activity in the Northern Dvina suspended matter in the end of the summer compared to the spring high water period when the physical processes are predominant over the biogeochemical ones due to the high speeds of the freshened waters flow.