Ages and two-way travel times of ODP Sites 180-1109, 180-1115 and 180-1118

Synthetic seismograms are constructed from check shot-corrected velocity and density measurements collected during Ocean Drilling Program (ODP) Leg 180 at Sites 1109, 1115, and 1118. The synthetic seismograms facilitate direct correlation of a coincident multichannel seismic (MCS) profile with borehole data collected at the three sites. The MCS data and the synthetic seismograms correlate very well, with most major reflectors successfully reproduced in the synthetics. Our results enable a direct calibration of the MCS data in terms of age, paleoenvironment, and subsidence history. Seismic reflectors are time correlative within stratigraphic resolution but are often observed to result from different lithologies across strike. Our results facilitate the extrapolation of the sedimentation history into an unsampled section of Site 1118 and enable a full correlation between the three sites using all the data collected during ODP Leg 180. This study forms the foundation for regionalizing the site data to the northern margin of the Woodlark Basin, where the transition from continental rifting to seafloor spreading is taking place.

(Table 2) Correlation of Mi zones with hiatuses in ODP Site 181-1124

Results from Ocean Drilling Program sites 1121-1124 show the Eastern New Zealand Oceanic Sedimentary System (ENZOSS) evolved in response to: (1) the inception of the circum-Antarctic circulation, (2) orbital and nonorbital regulation of the global thermohaline flow, and (3) development of the New Zealand plate boundary. ENZOSS began in the early Oligocene following opening of the Tasmanian gateway and inception of the ancestral Antarctic Circumpolar Current (ACC) and SW Pacific Deep Western Boundary Current (DWBC). Widespread erosion, marked by the Marshall Paraconformity, was followed by extensive drift formation in the late Oligocene- early Miocene. Alternating nannofossil chalk and nannofossil-rich mud deposited in response to 41-kyr orbital regulation of the abyssal circulation, with the mudstones representing times of increased inflow of corrosive southernsource waters. Drift deposition at the deepest sites was interrupted by bouts of erosion coincident with Mi 1-5 isotopic events signifying expansions of the East Antarctic Ice Sheet and enhanced bottom water formation. By late Miocene times, the basic ENZOSS was established. South of Bounty Trough, the energetic ACC instigated an erosional/low depositional regime. To the north, where the DWBC prevailed, orbitally regulated drift deposition continued. Increased convergence at the New Zealand plate boundary enhanced the terrigenous supply, but little of this sediment reached the deep ENZOSS as the three main sediment conduits - Solander, Bounty and Hikurangi channels - had not fully developed. The Plio-Pleistocene heralded a change from a carbonate- to terrigenous-dominant supply caused by interception of the DWBC by the three channels (~1.6 Ma for Bounty and Hikurangi, time of Solander interception unknown). The Solander and Bounty fans, and Hikurangi Fan-drift systems formed, and drifts downstream of those systems, received terrigenous detritus. Supply increased with accelerating uplift along the plate boundary, but delivery to the DWBC was regulated by eustatic fluctuations of sea level. Times of maximum supply to all three channels was during glacial lowstands whereas the supply either ceased (Bounty, Solander), or reduced (Hikurangi) in highstands. In glacial times, sediment was entrained by a DWBC invigorated by an increased input of Antarctic bottom water. The ACC also accelerated under strengthened glacial winds. Thus, glacials were times of optimum sediment supply to ENZOSS depocentres where depositional rates were 2-3 times more than interglacial rates.

Geological reference standards (JLK-1,JSD-1, JSD-2, JSD-3,JMS-1, JMS-2) measured by Itrax-XRF core scanner in different exposure times

X-ray fluorescence (XRF) core-scanning is a fast and nondestructive technique to assess elemental variations of unprocessed sediments. However, although the exposure time of XRF-scanning directly affects the scanning counts and total measurement time, only a few studies have considered the influence of exposure time during the scan. How to select an optimal exposure time to achieve reliable results and reduce the total measurement time is an important issue. To address this question, six geological reference materials from the Geological Survey of Japan (JLK-1, JMS-1, JMS-2, JSD-1, JSD-2, and JSD-3) were scanned by the Itrax-XRF core scanner using the Mo- and the Cr-tube with different exposure times to allow a comparison of scanning counts with absolute concentrations. The regression lines and correlation coefficients of elements that are generally used in paleoenvironmental studies were examined for the different exposure times and X-ray tubes. The results show that for those elements with relatively high concentrations or high detectability, the correlation coefficients are higher than 0.90 for all exposure times. In contrast, for the low detectability or low concentration elements, the correlation coefficients are relatively low, and improve little with increased exposure time. Therefore, we suggest that the influence of different exposure times is insignificant for the accuracy of the measurements. Thus, caution must be taken when interpreting the results of elements with low detectability, even when the exposure times are long and scanning counts are reasonably high.