Methanol and ethanol analysis in marine sediment pore water

Low-molecular-weight (LMW) alcohols are produced during the microbial degradation of organic matter from precursors such as lignin, pectin, and carbohydrates. The biogeochemical behavior of these alcohols in marine sediment is poorly constrained but potentially central to carbon cycling. Little is known about LMW alcohols in sediment pore waters because of their low concentrations and high water miscibility, both of which pose substantial analytical challenges. In this study, three alternative methods were adapted for the analysis of trace amounts of methanol and ethanol in small volumes of saline pore waters: direct aqueous injection (DAI), solid-phase microextraction (SPME), and purge and trap (P&T) in combination with gas chromatography (GC) coupled to either a flame ionization detector (FID) or a mass spectrometer (MS). Key modifications included the desalination of samples prior to DAI, the use of a threaded midget bubbler to purge small-volume samples under heated conditions and the addition of salt during P&T. All three methods were validated for LMW alcohol analysis, and the lowest detection limit (60 nM and 40 nM for methanol and ethanol, respectively) was achieved with the P&T technique. With these methods, ambient concentrations of volatile alcohols were determined for the first time in marine sediment pore waters of the Black Sea and the Gulf of Mexico. A strong correlation between the two compounds was observed and tentatively interpreted as being controlled by similar sources and sinks at the examined stations.

Hydrous and anhydrous pyrolysis of DSDP Leg 75 kerogens

The aliphatic hydrocarbon distributions obtained from the natural bitumens of three Leg 75 sediments were compared using computerised gas chromatography-mass spectrometry (C-GC-MS). The kerogens isolated from these sediments were heated in sealed tubes at 330°C using the techniques of hydrous (i.e. heating kerogen in the presence of water) and anhydrous pyrolysis (i.e. heating dry kerogen alone). These experiments were then repeated at a lower temperature (280°C). At 330°C, under anhydrous conditions, considerable destruction of biomarkers in the ancient kerogens (i.e. pre-Tertiary) occurred, whereas with water present significant amounts of hopanes were obtained. However, with more recent kerogens (which contain larger amounts of chemically bound water), both anhydrous and hydrous pyrolysis gave a similar suite of biological markers, in which long chain acyclic isoprenoids (C40) are significant components. Lowering the temperature of pyrolysis to 280°C yielded biological markers under both hydrous and anhydrous conditions for all kerogens. n-Alkenes were not detected in any of the pyrolysates; however, a single unknown triterpene was discovered in several of the hydrous and anhydrous pyrolysates. The results tentatively indicate that the chief value to petroleum research of kerogen hydrous pyrolysis lies in its ability to increase the yield of pyrolysate. High temperature hydrous pyrolysis (280-330°C), under high pressure (2000 psi), does not appear to mimic natural conditions of oil generation. However, this study does not take into account whole rock pyrolysis.