Sulfur concentrations and isotope ratios in sediments from Kiel Bay, western Baltic Sea

The isotope-ratios of sulfur-components in several sedimentologically different cores of recent marine sediments from Kiel Bay (Baltic Sea) were investigated. In addition, quantitative determinations were made on total sulfur, sulfate, sulfide, chloride, organic carbon, iron and watercontent in the sediment or in the pore-water solution. The investigations gave the following results: 1. The sulfur in the sediment (about 0.3 -2 % of the dry sample) was for the most part introduced into the sediment after sedimentation. This confirms the results of Kaplan et al. (1963, doi:10.1016/0016-7037(63)90074-7). The yield of Sulfur from organic material is very small (in our samples about 5-10% of the total sulfur in the sediment). 2. The sulfur bound in the sediment is taken from the sulfate of the interstitial water. During normal sedimentation, the exchange of sulfate by diffusion significant for changes in the sulfur-content goes down to a sediment depth of 4-6 cm. In this way the sulfate consumed by reduction and formation of sulfide or pyrite is mostly replaced. The uppermost layer of the sediment is an partly open system for the sulfur. The diagenesis of the sulfur is allochemical. 3. The isotope-values of the sediment-sulfur are largely influenced by the sulfur coming into the sediment by diffusion and being bound by bacteriological reduction. Due to the prevailing reduction of 32S and reverse-diffusion of sulfate into the open sea-water, an 32S enrichment takes place in the uppermost layer of the sediment. delta34S-values in the sediment range between -15 and -35 ? while seawater-sulfate has +20 ?. No relationship could be established between sedimentological or chemical changes and isotope-ratios. In the cores, successive sandy and clayly layers showed no change in the delta-values. The sedimentation rate, however, seems to influence isotope-ratios. In one core with low sedimentationrates the delta34S-values varied between -29 and -33 ?, while cores with higher sedimentationrates showed values between -17 and -24 ?. 4. As sediment depth increases, the pore-water sulfate shows decreasing concentrations (in a depth of 30-40 cm we found between 20 and 70 % of the seawater-values), and increasing delta 34S-values (in one case reaching more than +60 ?). The concentration of sulfide in the pore-water increases with sediment-depth (reaching 80 mg S/l in one case). The (delta34S-values of the pore-water-sulfide in all cores show increases paralleling the sulfate sulfur, with a nearly constant delta-distance of 50-60 ? in all cores. This seems to confirm the genetic relationship between the two components.

Analysis of Mn-nodules from Breitgrund, Baltic Sea

The usually high concentrations of Zn, Pb, Cd, and Cu in the most recently accreted portions of ferromanganese nodules from the western Baltic Sea are thought to reflect increased metal input due to anthropogenic mobilization. If so, the point of increase represents a time horizon within the structure of the nodule. Similar trace metal distributions of radiometrically dated sediments from the same area suggest that the ferromanganese nodules have grown in thickness between 0.02 and 0.16 mm yr-1. From this growth rate anthropogenic Zn flux to the nodule surface was calculated to be 80 mg m-2 yr-1.

Mineralogy and geochemistry at DSDP Leg 80 Holes

Cenozoic sediments recovered from Sites 548, 549, and 550 were the objects of mineralogical (bulk sample and <2 - µm fraction) and geochemical (HCl extract) studies. Thin sections of rock pebbles embedded in sediments (upper levels at Site 548, particularly) were examined on a polarizing microscope. This study outlines the vertical and lateral variation and evolution of the sedimentation. In the Paleocene and lower Eocene, the clay fraction is abundant and smectite is practically the sole existing clay mineral. High Mn, Al, Fe, Mg, and K contents were measured in HCl extracts. Through the middle Eocene, carbonates become more abundant - highly dominant at Site 548. Metal contents in HCl extracts are very low. The clay fraction, although dominated at all sites by smectites, becomes richer in illite and poorly crystallized chlorite. At the middle/upper Miocene boundary, a significant decrease in the smectite/(illite + chlorite) ratio occurs at all sites, and this decrease continues into the middle Pliocene. This decrease is marked by an abrupt increase of quartz at Site 548. At the two other sites, carbonates remain highly predominant; HCl extracts reflect the relative abundance of the clay and carbonate fractions. After a brief recurrence of smectite in a high-metal-content interval, illite and chlorite become the dominant clay minerals in the upper Pliocene and the Pleistocene, where numerous variations in mineralogical composition occur in the clay fraction (Sites 548 and 549) or in non-clay components (Site 548). Several pebbles of various nature and origin, encountered in different levels of this interval at Site 548, appear to have an ice-rafting origin. This study points out three main breaks in the general evolution of the sedimentation: the first, corresponding to the lower/middle Eocene boundary, is marked by the increase of carbonates and associated elements; the second, corresponding to the middle/upper Miocene boundary, is marked by a major decrease of the smectite/(illite + chlorite) ratio at all sites and by a massive appearance of quartz at Site 548; and the third, which occurred toward the late Pliocene, is marked by the dominance of primary clay minerals and the arrival of ice-rafted pebbles. Our interpretation of results considers paleohydrological and paleoclimatic phenomena. It is suggested that the major middle/late Miocene break was associated with an increase of the deep bottom-water circulation between the Norwegian Sea and the North Atlantic Ocean, and/or a climatic evolution: humidification and cooling of climate. The changes toward the late Pliocene appear to have been the first effects of the glaciations at the end of Cenozoic.

Geochemistry, trace elements and minerals at DSDP Holes 80-550B and 80-551

The Leg 80 basalts drilled on the Porcupine Abyssal Plain 10 km southwest of Goban Spur (Hole 550B) and on the western edge of Goban Spur (Hole 551), respectively, are typical light-rare-earth-element- (LREE-) depleted oceanic tholeiites. The basalts from the two holes are almost identical; most of their primary geochemical and mineralogical characteristics have been preserved, but they have undergone some low-temperature alteration by seawater, such as enrichment in K, Rb, and Cs and development of secondary potassic minerals of the "brownstone facies." K/Ar dating fail to give realistic emplacement ages; the apparent ages obtained become younger with alteration (causing an increase in K2O). Hole 551 basalts are clearly different from the continental tholeiites emplaced on the margins of oceanizing domains during the prerift and synrift stages.

Mg/Ca-temperature proxy in benthic foraminifera from the Florida Strait

Over the past decade, the ratio of Mg to Ca in foraminiferal tests has emerged as a valuable paleotemperature proxy. However, large uncertainties remain in the relationships between benthic foraminiferal Mg/Ca and temperature. Mg/Ca was measured in benthic foraminifera from 31 high-quality multicore tops collected in the Florida Straits, spanning a temperature range of 5.8° to 18.6°C. New calibrations are presented for Uvigerina peregrina, Planulina ariminensis, Planulina foveolata, and Hoeglundina elegans. The Mg/Ca values and temperature sensitivities vary among species, but all species exhibit a positive correlation that decreases in slope at higher temperatures. The decrease in the sensitivity of Mg/Ca to temperature may potentially be explained by Mg/Ca suppression at high carbonate ion concentrations. It is suggested that a carbonate ion influence on Mg/Ca may be adjusted for by dividing Mg/Ca by Li/Ca. The Mg/Li ratio displays stronger correlations to temperature, with up to 90% of variance explained, than Mg/Ca alone. These new calibrations are tested on several Last Glacial Maximum (LGM) samples from the Florida Straits. LGM temperatures reconstructed from Mg/Ca and Mg/Li are generally more scattered than core top measurements and may be contaminated by high-Mg overgrowths. The potential for Mg/Ca and Mg/Li as temperature proxies warrants further testing.

Age model and elemental data of DSDP Holes 48-401 and 80-549

A growing body of geologic evidence suggests that emplacement of the North Atlantic Igneous Province (NAIP) played a major role in global warming during the early Paleogene as well as in the transient Paleocene-Eocene thermal maximum (PETM) event. A ~5 million year record of major and trace element abundances spanning 56 to 51 Ma at Deep Sea Drilling Project Sites 401 and 549 confirms that the majority of NAIP volcanism occurred as subaerial flows. Thus the trace element records provide constraints on the nature and scope of the environmental impact of the NAIP during the late Paleocene-early Eocene interval. Subaerial volcanism would have injected mantle CO2 directly into the atmosphere, resulting in a more immediate increase in atmospheric greenhouse gas abundances than CO2 input through submarine volcanism. The lack of significant hydrothermalism contradicts recently proposed mechanisms for thermally destabilizing methane hydrate reservoirs during the PETM. Any connection between NAIP volcanism and PETM warming had to occur through the atmosphere.