Geochemistry at DSDP Legs 56-57 Holes

About 200 volcanic ash layers were recovered during DSDP Leg 57. The volcanic glass in some of these layers was investigated petrographically and chemically in this study. Volcanic glass is mainly rhyolitic and/or rhyodacitic in chemical composition, and its refractive index ranges from 1.496 to 1.529. Some volcanic ash layers consist of multiple grains of different chemical compositions. All the volcanic glass belongs to the tholeiitic and the calc-alkalic volcanic rock series, in SiO2-(Na2O + K2O) diagram and FeO*/MgO-SiO2 diagram. We correlated successfully three volcanic ash layers from the standpoint of chemical composition and biostratigraphy. Hydration of volcanic glass from Leg 57 is less intense than in other DSDP cores.

(Table 1) Mineralogical composition of sediments from DSDP Sites 69-504 and 69-505

We discuss the provenance of minerals detected by X-ray-diffraction analyses of sediments of Sites 504 and 505 of Deep Sea Drilling Project Leg 69. These are X-ray-amorphous material, opal-CT, calcite, quartz, feldspar, apatite, smectite, illite, kaolinite, magnetite, maghemite, pyrite, marcasite, barite, sepiolite, and clinoptilolite. Authigenic marcasite and clinoptilolite together with opal-CT are restricted to Site 504, indicating the special diagenetic conditions related to relatively high sediment temperatures at this site. Marcasite formation is likely dependent on the relatively low pH values of <7.1 found in interstitial waters of Site 504 sediments below 50 meters sub-bottom. Clinoptilolite evidently was formed by diagenetic alteration of rhyolitic volcanic glass or smectite plus biogenic silica within the chalk-limestone-chert sequence of Site 504, where opal-CT also reflects a high degree of silica dissolution and reprecipitation. This was a consequence of high temperatures (50-55 °C) at the base of the sediment column.

(Table 1) Sample levels of diatom and silicoflagellate datums at DSDP Holes 69-504 and 69-505

A standard biostratigraphic system, based upon diatom datum levels previously correlated to the paleomagnetic record, was applied to Deep Sea Drilling Project Sites 501/504 and 505. Sedimentation appears to have been constant at the three sites, averaging 50 m/m.y. at Sites 501/504 and 60 m/m.y. at Site 505. Calcium carbonate is rather poorly preserved at both sites, because of depth of water and, at Sites 501/504, alteration by diagenesis. Siliceous microfossils are common and moderately well preserved at the three sites; at Sites 501/504, diatoms disappear abruptly below the first occurrence of chert. The uppermost Miocene diatom assemblage occurs just above chert and is characterized by a strong dominance of Thalassionema and Thalassiothrix, which implies very high silica production during the latest Miocene; the chert probably is derived from a similar assemblage. In the earliest Pliocene, silica production appears to have decreased sharply; about 3 Ma, preservation of calcium carbonate also diminished, suggesting a shoaling of the CCD. At 2 Ma, there occurred a short interval of low production of both calcium carbonate and silica, which lasted into the earliest Pleistocene.

(Table 1) Physical properties of sediments at DSDP Holes 69-504 and 69-505

Values of physical properties measured in the upper sections of sediment cores recovered at Sites 504 and 505 exhibit a remarkable similarity. Below a depth of 145 m Site 504 sediments appear to have undergone changes which are reflected in physical property values. This alteration may have been due to high temperatures in the sediment. In most of Site 505, and in Site 504 above 145 m, seismic velocity averages 1.51 km/s, wet bulk density 1.32 g/cm**3, porosity 80%, and thermal conductivity 0.80% W/m °K. Below 145 m at Site 504 and 210 m at Site 505, mean density increases to 1.40 g/cm**3, porosity decreases to 67%, seismic velocity increases to 1.53 km/s, and thermal conductivity increases to values in excess of 1.0 W/m °K. A good correlation between independent measurements of water content and thermal resistivity supports the existence of small but regular variation in the measured parameters on the scale of 10 m and less.

(Figure 1) Silicoflagellates at DSDP Hole 69-504

Diverse and abundant late Miocene to Pleistocene silicoflagellates at DSDP Site 504 can be correlated by tropical biostratigraphic zones and relative paleotemperature values to eastern tropical Pacific reference site DSDP 503A farther to the west. Early Pliocene assemblages, which were poorly known until now, are present and can be correlated locally between DSDP Holes 504, 503A, and 495, using species events associated with the new Dictyocha pulchella Subzone and Dictyocha angulata Subzone. Silicoflagellate relative paleotemperature values show major warming at 4.7 to 5.0 Ma (Cores 45-48), 3.4 to 3.8 Ma (Cores 32-33), 1.5 to 1.7 Ma (Cores 12-16), and 0.5 to 0.8 Ma (Cores 3-6). Major coolings occurred at 5.0 to 5.1 Ma (Core 51), 3.9 to 4.4 Ma (Cores 38-44), and 1.0 to 1.3 Ma (Cores 8-10). The appearance of Dictyocha longa is proposed to replace the asperoid/fibuloid ratio reversal as the bottom of the Dictyocha fibula Zone, because the non-evolutionary ratio reverses several times in the upper Miocene of Hole 503A, and at least once in Hole 504. Three new Pliocene silicoflagellates are defined: Dictyocha concinna Bukry, n. sp., D. helix Bukry, n. sp., and D. tamarae Bukry, n. sp.