Low-molecular-weight hydrocarbons in sediments of Broken Ridge and Ninetyeast Ridge

Core samples taken during Leg 121 drilling aboard the JOIDES Resolution in the central Indian Ocean were analyzed for their low-molecular-weight hydrocarbon contents. Forty-three samples from the Broken Ridge and 39 samples from the Ninetyeast Ridge drill sites, deep-frozen on board immediately after recovery, were studied by a dynamic headspace technique (hydrogen-stripping/thermovaporization). Light hydrocarbons (saturated and olefinic) with two to four carbon atoms, and toluene as a selected aromatic compound, were identified. Total C2-C4 saturated hydrocarbon yields vary considerably from virtually zero in a Paleogene calcareous ooze from Hole 757B to nearly 600 nanogram/gram of dry-weight sediment (parts per billion) in a Cretaceous claystone from Hole 758A. An increase of light-hydrocarbon yields with depth, and hence with sediment temperature, was observed from Hole 758A samples down to a depth of about 500 meters below seafloor. Despite extreme data scatter due to lithological changes over this depth interval, this increased yield indicates the onset of temperature-controlled hydrocarbon formation reactions. Toluene contents are also extremely variable (generally between 10 and 100 ppb) and reach more than 300 ppb in two samples of tuffaceous lithology (Sections 121-755A-17R-4 and 121-758A-48R-4). As for the saturated hydrocarbons, there was also an increase of toluene yields with increasing depth in Hole 758A.

(Table 1) Organic carbon, hydrogen and oxygen index and hydrocarbons at DSDP Hole 93-603B

C2-C8 hydrocarbon concentrations (about 35 compounds identified, including saturated, aromatic, and olefinic compounds) from 27 shipboard-sealed, deep-frozen core samples of DSDP Hole 603B off the east coast of North America were determined by a gas-stripping/thermovaporization method. Total yields representing the hydrocarbons dissolved in the pore water and adsorbed on the mineral surfaces of the sediments vary from 22 to 2400 ng/g of dryweight sediment. Highest yields are measured in the two black shale samples of Core 603B-34 (hydrogen index of 360 and 320 mg/g Corg, respectively). In organic-carbon-normalized units these samples have hydrocarbon contents of 12,700 and 21,500 ng/g Corg, respectively, indicating the immaturity of their kerogens. Unusually high organic-carbonnormalized yields are associated with samples that are extremely lean in organic carbon. It is most likely that they are enriched by small amounts of migrated light hydrocarbons. This applies even to those samples with high organic-carbon contents (1.3-2.2%) of Sections 603B-28-4, 603B-29-1, 603B-49-2, and 603B-49-3, because they have an extremely low hydrocarbon potential (hydrogen index between 40 and 60 mg/g Corg). Nearly all samples were found to be contaminated by varying amounts of acetone that is used routinely in large quantities on board ship during core-cutting procedures. Therefore, 48 samples from the original set of 75 collected had to be excluded from the present study.

Molecular and isotopic compositions of hydrocarbons at DSDP Site 76-533

In an investigation of gas hydrates in deep ocean sediments, gas samples from Deep Sea Drilling Project Site 533 on the Blake Outer Ridge in the northwest Atlantic were obtained for molecular and isotopic analyses. Gas samples were collected from the first successful deployment of a pressure core barrel (PCB) in a hydrate region. The pressure decline curves from two of the four PCB retrievals at in situ pressures suggested the presence of small amounts of gas hydrates. Compositional and isotopic measurements of gases from several points along the pressure decline curve indicated that (1) biogenic methane (d13C = -68 per mil; C1/C2 = 5000) was the dominant gas (>90%); (2) little fractionation in the C1/C2 ratio or the C carbon isotopic composition occurred as gas hydrates decomposed during pressure decline experiments; (3) the percent of C3, i-C4, and CO2 degassed increased as the pressure declined, indicating that these molecules may help stabilize the hydrate structure; (4) excess nitrogen was present during initial degassing; and (5) C1/C2 ratios and isotopic ratios of C gases were similar to those obtained from conventional core sampling. The PCB gas also contained trace amounts of saturated, acyclic, cyclic, and aromatic C5-C14 hydrocarbons, as well as alkenes and tetrahydrothiophenes. Gas from a decomposed specimen of gas hydrate had similar molecular and isotopic ratios to the PCB gas (d13C of -68 per mil for methane and a C1/C2 ratio of about 6000). Regular trends in the d13C of methane (about -95 to -60 per mil) and C1/C2 ratios (about 25000 to 2000) were observed with depth. Capillary gas chromatography (GC) and total scanning fluorescence measurements of extracted organic material were characteristic of hydrocarbons dominated by a marine source, though significant amounts of perylene were also present.

(Table 1) Composition of paraffin hydrocarbons at DSDP Site 56-434

Geochemical investigation of 18 samples of sediments from Site 434 involved determining the content of organic carbon, of bitumoid A (The chloroform A-chl and alcohol-benzene A-alb extracts) and its various fractions, and of individual hydrocarbons as well as the structural group composition of resins. We identified certain samples that differed sharply from the rest by their increased bitumen content and relatively low molecular hydrocarbons and by the fact that their resinous components were more neutral and aliphatic in composition. The distribution of bitumoid and its components seems to reflect migration processes in operation during the early stages of the transformation of organic matter.

Organic petrography and extractable hydrocarbons of sediments at DSDP Leg 58 Holes

The quantity, type, and maturity of organic matter of Quaternary and Tertiary sediments from the Philippine Sea (DSDP Leg 58; Sites 442-446) were determined. Hydrocarbons in lipid extracts were analyzed by capillary-column gas chromatography. Kerogen concentrates were investigated by microscopy for vitrinite reflectance values and maceral composition. In the Shikoku Basin sediments (Sites 442, 443, and 444), organic carbon values range between 0.03 and 0.44 per cent. The higher values in the younger sediments are interpreted as an indication of increasing deposition of eroded organic particles during the past 4 m.y. Microscopic analyses revealed a dominance of reworked organic matter. Primary material could not be distinguished readily; thus, no maturation trend could be established. Extract yields were low. TV-alkane distributions mostly show maxima at n-C29 and n-C31 and high odd-over-even predominances, typical of material which originated in terrigenous higher plants. The organic-carbon values of sediments of the Daito Ridge and Basin region (Sites 444 and 445) range from less than 0.01 to 0.05 per cent. TV-alkanes exhibit varying marine and terrigenous influences. Some carbonate-rich samples show a pronounced even-over-odd predominance. At least the older sediments contained less recycled organic matter than the Shikoku Basin samples. The maturity, where measurable, was low. None of the Philippine Sea samples indicates a significant hydrocarbon-generation potential.