Calcium carbonate, isotopes and Rock-Eval pyrolysis at DSDP Holes 77-535 and 77-540

At DSDP Sites 534 (Central Atlantic) and 535 and 540 (Gulf of Mexico), and in the Vocontian Basin (France), Lower Cretaceous deposits show a very pronounced alternation of limestone and marl. This rhythm characterizes the pelagic background sedimentation and is independent of detritic intercalations related to contour and turbidity currents. Bed-scale cycles, estimated to be 6000-26,000 yr. long, comprise major and minor units. Their biological and mineralogic components, burrowing, heavy isotopes C and O, and some geochemical indicators, vary in close correlation with CaCO3 content. Vertical changes of frequency and asymmetry of the cycles are connected with fluctuations of the sedimentation rate. Plots of cycle thickness ("cyclograms") permit detailed correlations of the three areas and improve the stratigraphic subdivision of Neocomian deposits at the DSDP sites. Small-scale alternations, only observed in DSDP cores, comprise centimetric to millimetric banding and millimetric to micrometric lamination, here interpreted as varvelike alternations between laminae that are rich in calcareous plankton and others rich in clay. The laminations are estimated to correspond to cycles approximately 1,3, and 13 yr. in duration. The cyclic patterns appear to be governed by an interplay of continental and oceanic processes. Oceanic controls express themselves in variations of the biogenic carbonate flux, which depends on variations of such elements as temperature, oxygenation, salinity, and nutrient content. Continental controls modulate the influxes of terrigenous material, organic matter, and nutrients derived from cyclic erosion on land. Among the possible causes of cyclic sedimentation, episodic carbonate dissolution has been ruled out in favor of climatic fluctuations with a large range of periods. Such fluctuations are consistent with the great geographic extension shown by alternation controls and with the continuous spectrum of scales that characterizes limestone-marl cycles. The climatic variations induced by the Earth's orbital parameters (Milankovitch cycles) could be connected to bed-interbed alternations.

Sulphur geochemistry of whole-rock samples from ODP Hole 176-735B

Sulfide petrography plus whole rock contents and isotope ratios of sulfur were measured in a 1.5 km section of oceanic gabbros in order to understand the geochemistry of sulfur cycling during low-temperature seawater alteration of the lower oceanic crust, and to test whether microbial effects may be present. Most samples have low SO4/Sum S values (<= 0.15), have retained igneous globules of pyrrhotite ± chalcopyrite ± pentlandite, and host secondary aggregates of pyrrhotite and pyrite laths in smectite ± iron-oxyhydroxide ± magnetite ± calcite pseudomorphs of olivine and clinopyroxene. Compared to fresh gabbro containing 100-1800 ppm sulfur our data indicate an overall addition of sulfide to the lower crust. Selection of samples altered only at temperatures <= 110 °C constrains microbial sulfate reduction as the only viable mechanism for the observed sulfide addition, which may have been enabled by the production of H2 from oxidation of associated olivine and pyroxene. The wide range in d34Ssulfide values (-1.5 to + 16.3 per mil) and variable additions of sulfide are explained by variable epsilon sulfate-sulfide under open system pathways, with a possible progression into closed system pathways. Some samples underwent oxidation related to seawater penetration along permeable fault horizons and have lost sulfur, have high SO4/Sum S (>= 0.46) and variable d34Ssulfide (0.7 to 16.9 per mil). Negative d34Ssulfate-d34Ssulfide values for the majority of samples indicate kinetic isotope fractionation during oxidation of sulfide minerals. Depth trends in sulfide-sulfur contents and sulfide mineral assemblages indicate a late-stage downward penetration of seawater into the lower 1 km of Hole 735B. Our results show that under appropriate temperature conditions, a subsurface biosphere can persist in the lower oceanic crust and alter its geochemistry.

Composition and age of volcanic rocks from the Sinii Utes Depression, Southern Primoye

New data are reported on structure of sections, chemical composition, and age of volcano-sedimentary and volcanic rocks from the Sinii Utes Depression in the Southern Primorye region. The Sinii Utes Depression is filled with two sequences: the lower sequence composed of sedimentary-volcanogenic coaliferous rocks (the stratotype of the Sinii Utes Formation) and the upper sequence consisting of tephroid with overlying basalts. This work considers chemical composition and problems of K-Ar dating of basalts. The uppermost basaltic flow has K-Ar age 22.0±1.0 Ma. The dates obtained for the middle and upper parts of lava flows are underestimated. It is explained by their heating due to combustion of brown coals of the Sinii Utes Formation underlying the lava flow. Calculations show that argon could only partly have been removed from the basalts owing to conductive heat transfer and was lost largely due to infiltration of hot gases in heterogeneous fissured medium. Basaltic volcanism on continental margins of the southern Primorye region and the adjacent Korean and Chinese areas at the Oligocene-Miocene boundary preceded Early-Middle Miocene spreading and formation of the Sea of Japan basin. Undifferentiated moderately alkaline basalts of intraplate affinity developed in the Amba Depression and some other structures of the southern Primorye region and intraplate alkali basalts of the Phohang Graben in the Korean Peninsula serve as indicators of incipient spreading regime in the Sea of Japan. Potassic basalt-trachybasalt eruptions occurred locally in riftogenic depressions and shield volcanoes. In some structures this volcanism was terminated by eruptions of intermediate and acid lavas. Such evolution of volcanism is explained by selective contamination of basaltic melts during their interaction with crustal acid material and generation of acid anatectic melts.

Digital surface model, hillshade and Lambertian reflectance model of the rock glaciers Oelgrube and Aeusseres Hochebenkar (Oetztal Alps, Tyrol, Austria)

With full-waveform (FWF) lidar systems becoming increasingly available from different commercial manufacturers, the possibility for extracting physical parameters of the scanned surfaces in an area-wide sense, as addendum to their geometric representation, has risen as well. The mentioned FWF systems digitize the temporal profiles of the transmitted laser pulse and of its backscattered echoes, allowing for a reliable determination of the target distance to the instrument and of physical target quantities by means of radiometric calibration, one of such quantities being the diffuse Lambertian reflectance. The delineation of glaciers is a time-consuming task, commonly performed manually by experts and involving field trips as well as image interpretation of orthophotos, digital terrain models and shaded reliefs. In this study, the diffuse Lambertian reflectance was compared to the glacier outlines mapped by experts. We start the presentation with the workflow for analysis of FWF data, their direct georeferencing and the calculation of the diffuse Lambertian reflectance by radiometric calibration; this workflow is illustrated for a large FWF lidar campaign in the Ötztal Alps (Tyrol, Austria), operated with an Optech ALTM 3100 system. The geometric performance of the presented procedure was evaluated by means of a relative and an absolute accuracy assessment using strip differences and orthophotos, resp. The diffuse Lambertian reflectance was evaluated at two rock glaciers within the mentioned lidar campaign. This feature showed good performance for the delineation of the rock glacier boundaries, especially at their lower parts.