Seismic properties of serpentinized peridotites from the Mariana Forearc

Compressional and shear velocities, density, and porosity were measured for 22 serpentinized peridotites recovered during ODP Leg 125. The densities of the samples vary from 2.40 to 2.86 g/cm**3, whereas the compressional velocities at 200 MPa are between 4.60 and 6.47 km/s. A positive linear trend exists between both compressional and shear velocities and density. The high porosity in serpentinized peridotites decreases the density and seismic velocity.

Paleomagnetic properties of igneous rocks from several DSDP and ODP sites, western Pacific

Oceanic basalts and other related igneous rocks are considered excellent recorders of the Earth's paleomagnetic field. Consequently, basalt core paleomagnetic data are valuable for the constraints they provide on plate tectonic motions, especially for oceanic plates such as the Pacific. Unfortunately, few Deep Sea Drilling Project (DSDP) and Ocean Drilling Program (ODP) boreholes have been cored very deeply into the ocean crust. The result is that there are only a few sites at which a large enough number of basalt flows have been cored to properly average secular variation (e.g., Kono, 1980, doi:10.2973/dsdp.proc.55.135.1980; Cox and Gordon, 1984, doi:10.1029/RG022i001p00047). Furthermore, there are a number of sites where basaltic core samples were retrieved but the cores were not measured. Often this occurs because leg scientists had more important sections to work on, or the section was ignored because it was too short to record enough time to average secular variation and obtain a reliable paleolatitude. Even though it may not be possible to determine a precise paleolatitude from such short sections, measurements from a small number of flows are important because they can be combined with other coeval paleomagnetic data from the same plate to calculate a paleomagnetic pole (Gordon and Cox, 1980, doi:10.1111/j.1365-246X.1980.tb02642.x; Cox and Gordon, 1984, doi:10.1029/RG022i001p00047). For this reason, I obtained samples for paleomagnetic measurements from eight Pacific sites (169, 170, 171, 581, 597, 800, 803, and 865), most of which have not been previously measured for paleomagnetism.

Pore-water chemistry of abyssal Arabian Sea surface sediments

Benthic fluxes and pore-water compositions of silicic acid, nitrate and phosphate were investigated for surface sediments of the abyssal Arabian Sea during four cruises (1995-1998). Five sites located in the northern (NAST), western (WAST), central (CAST), eastern (EAST), and southern (SAST) Arabian Sea were revisited during intermonsoonal periods after the NE- and SW-Monsoon. At these sites, benthic fluxes of remineralized nutrients from the sediment to the bottom water of 36-106, 102-350 and 4-16 mmol/m**2/yr were measured for nitrate, silicic acid and phosphate, respectively. The benthic fluxes and pore-water compositions showed a distinct regional pattern. Highest fluxes were observed in the western and northern region of the Arabian Sea, whereas decreasing fluxes were derived towards the southeast. At WAST, the general temporal pattern of primary production, related to the NE- and SW-Monsoon, is reflected by benthic fluxes. In contrast, at sites NAST, SAST, CAST, and EAST a temporal pattern of fluxes in response to the monsoon is not obvious. Our results reveal a clear coupling between the general regional pattern of production in surface waters and the response of the benthic environment, as indicated by the flux of remineralized nutrients, though a spatially differing degree of decoupling during transport and remineralization of particulate organic matter and biogenic opal was observed. This has to be taken into account regarding budget calculations and paleoceanographic topics.

Mineralogy and diagenesis: Their effect on acoustic and electrical properties of pelagic clays at DSDP Leg 86 Holes

Analysis of pelagic clay samples from Sites 576, 578, and 581 shows that physical, acoustic, and electrical trends with increasing burial depth are related to mineralogical and diagenetic changes. The properties of interest are bulk density (roo), porosity (phi), compressional-wave velocity (Vp) and velocity anisotropy (Ap), and electrical resistivity (Ro) and resistivity anisotropy (Ar). In general, as demonstrated in particular for the brown pelagic clay, the increase in roo, Vp, Ro, and to a lesser extent Ap and Ar with increasing depth is primarily caused by decreasing phi (and water content) as a result of compaction. The mineralogy and chemistry of the pelagic clays vary as a function of burial depth at all three sites. These variations are interpreted to reflect changes in the relative importance of detrital and diagenetic components. Mineralogical and chemical variations, however, play minor roles in determining variations in acoustic and electrical properties of the clays with increasing burial depth.