Geochemistry at DSDP Leg 92 Holes

The major-element and most of the trace-element data from the different laboratories that contributed to the study of samples recovered during Leg 82 are presented in the following tables. The different basalt groups, identified on the basis of their chemical properties (major and trace elements), were defined from the data available on board the Glomar Challenger as the cruise progressed (see site chapters, all sites, this volume). Most of the data obtained since the end of the cruise and presented in these tables confirm the classification that was proposed by the shipboard party (see site chapters, all sites, this volume). Nevertheless, special mention should be made about Site 564. The shipboard party proposed a single chemical group at this site but noticed significant variations down the hole, mainly in trace-element data. However, the range of variation was small compared to the precision of the measurements. These variations were confirmed by the onshore studies (see papers in Part IV of this volume, especially Brannon's paper, partly devoted to this topic).

Mineralogy and geochemistry of altered ash, pelagic clay, and a clay vein in basalt from DSDP Leg 62 Holes

Volcanic ash was recovered from lower Aptian to Albian deposits from DSDP Sites 463, 465, and 466; pelagic clay of the upper Pleistocene to Upper Cretaceous was recovered mainly from Site 464, with minor amounts at Sites 465 and 466. We present X-ray-mineralogy data on pelagic clay and altered volcanic ash recovered from the four Leg 62 sites. In addition, two ash samples from Sites 463 and 465, a pelagic clay from Site 464, and a clay vein from the basaltic basement at Site 464 each were analyzed for major, minor, and trace elements. Our purpose is to describe the mineralogy and chemistry of altered ash and pelagic clays, to determine the sources of their parent material, and to delineate the diagenetic history of these clay-rich deposits. Correlation of chemistry and mineralogy of ash and pelagic clay with volcanic rocks suspected to be their parent material is not always straightforward, because weathering and diagenetic alteration caused depletion or enrichment of many elements.

Grain-size and carbon/carbonate analyses at DSDP Site 61-462

Sand-silt-clay distribution was determined on 10-cm**3 sediment samples collected at the time the cores were split and described. The sediment classification used here is that of Shepard (1954), with the sand, silt, and clay boundaries based on the Wentworth (1922) scale. Thus, the sand, silt, and clay fractions are composed of particles whose diameters range from 2000 to 62.5 µm, 62.5 to 3.91 µm, and less than 3.91 µm, respectively. This classification is applied regardless of sediment type and origin; therefore, the sediment names used in this table may differ from those used elsewhere in this volume, e.g., a silt composed of nannofossils in this table may be called a nannofossil ooze in a site-summary chapter.

Major- and trace-element chemistry of DSDP Leg 70 Holes basalts and their alteration products

Major and trace element compositions of basalts from the lower part of Hole 504B indicate their cogenetic nature. The cored sequence of interlayered pillow lavas and massive lava flows was produced by eruption of lavas, slightly variable in composition. Plagioclase and olivine crystallization in a shallow magma chamber, followed by small-scale fractionation at higher levels, is responsible for these variations. Except in highly fractured zones within the basement, there are systematic variations in the style and degree of rock alteration with depth. Trace element characteristics of altered rocks and secondary minerals indicate that progressive changes in sea water composition occurred as it reacted with basaltic crust.

Physical properties and geochemistry at DSDP Leg 70 Holes

Ashes occurring both as distinct layers and mixed with pelagic sediments of the hydrothermal mounds lying south of the Galapagos Rift are mainly rhyolitic and basaltic. The ashes, of rhyolitic to intermediate composition, appear to belong to a calc-alkalic series and were probably derived from Plinian eruptions in Ecuador or Colombia. Basaltic ashes are made of nonvesicular sideromelane spalling shards and are of tholeiitic composition. They probably were derived locally from fault scarps. Most rhyolitic and basaltic glass shards studied are fresh except for hydration of the rhyolitic shards. Some shards are severely altered, however. Basaltic ash may be more common in pelagic sediments deposited near accretion zones and may be a source of silica and other elements released during diagenesis

Magnetic properties and incompatible element geochemistry of some igneous rocks at DSDP Leg 64 Holes

I received five unoriented samples of igneous rocks from four Sites of Leg 64 of the Deep Sea Drilling Project (DSDP). I have measured several magnetic properties, alkalis (K, Rb, and Cs), alkaline-earth (Ba and Sr) element concentrations, and 87Sr/86Sr ratios of these samples. This study reports the results.

Clay minerals in Mesozoic and Cenozoic sediments at DSDP Leg 62 Holes

The main tasks of this study were (1) identification of minerals of the clay fraction, (2) identification of clay-mineral associations in relation to stratigraphic intervals, and (3) elucidation of genetic relations of clay minerals with types of sediments and factors of sedimentation. Identification of clay minerals was carried out mainly with an X-ray diffractometer (DRON-I). X-ray diffractograms were prepared by means of CuKalpha radiation, at 35 kW and a current of 20 ma. The scanning rate was 2°/min. Oriented specimens were prepared for the <1-µm fraction (and partly for the <10-µm fraction because of insufficient core material) in three states: air-dried, saturated with glycerine, and heated at 550°C.

Geochemistry and ages at DSDP Hole 19-192A

Conventional K-Ar and 40Ar/39Ar age data on altered basalts from DSDP Hole 192A on Meiji Guyot, Emperor Seamount chain, indicate a minimum age for the volcano of 61.9 ± 5.0 m.y. The K-Ar data are consistent with the early Maestrichtian date of the overlying sediments, but do not provide either a positive or negative test of the hypothesis that Meiji is older than Emperor volcanoes to the south. The most prominent alteration affecting the age measurements is potassium metasomatism, particularly of feldspar phenocrysts. The K-Ar apparent ages of feldspar separates from the Meiji basalts show that more than half of the potassium metasomatism occurred within the last 25 m.y. or so, and that if the potassium replacement rate has been constant, then the alteration of the Meiji basalts did not begin for 10 to 20 m.y. after the volcano formed.

Sandstone and siltstone beds overlying conglomerate at DSDP Hole 59-439

Massive sandstone and siltstone beds with many shallow-water megafossils overlie acidic volcanic conglomerates at DSDP Site 439. Smear-slides, thin sections from coarse fractions, and heavy minerals of the sandstone and siltstone beds were analyzed. The sandstones and siltstones are very rich in lithic fragments and are classified as lithic arenite and (or) lithic wacke. Hornblende and clinopyroxene are abundant, and zircon is present in most of the examined samples. The proportions of sandstone, chert, and volcanic rock in the coarse fraction are variable, but fragments of clastic rocks and cherts are predominant. Plagioclase crystals of volcanic-rock origin, such as highly zoned plagioclase and very fine, euhedral, lath-shaped plagioclase, are frequently observed. Metamorphic-rock fragments and metamorphic minerals are also observed. Thus, the provenance of the sandstone and siltstone beds appears to have been a slightly mature island arc, the Oyashio ancient landmass, consisting of clastic sediments and metamorphic and volcanic rocks.

Reflection microscopy and geochemistry at DSDP Leg 55 Holes

Magnetic properties of volcanic rocks are controlled mainly by the physical and chemical state of their constituent ferromagnetic minerals. The most important parameters determining magnetic properties are concentration, composition, grain size, and oxidation state. In sea floor basalts, the main ferromagnetic minerals are titanomagnetites which are either unoxidized or, more commonly, have undergone various degrees of posteruptive low-temperature oxidation to become cationdeficient titanomagnetites, or titanomaghemites. The effects of this low-temperature alteration are seen in the increase of Curie temperature and decrease of saturation magnetization and lattice parameter of ferromagnetic minerals (Readman and O'Reilly, 1972). It is now believed that titanomaghemitization of newly formed mid-ocean ridge crust proceeds with a time constant of about 1 m.y., accompanying drastic decrease of the intensity of the natural remanent magnetization (NRM) (Johnson and Atwater, 1977).

Minerals, geochemistry and x-ray power characteristics at DSDP Sites 54-424, 60-458 and 60-459

Secondary minerals filling veins and vesicles in volcanic basement at Deep Sea Drilling Project Sites 458 and 459 indicate that there were two stages of alteration at each site: an early oxidative, probably hydrothermal, stage and a later, low-temperature, less oxidative stage, probably contemporaneous with faulting in the tectonically active Mariana forearc region. The initial stage is most evident in Hole 459B, where low-Al, high Fe smectites and iron hydroxides formed in vesicles in pillow basalts and low-Al palygorskite formed in fractures. Iron hydroxides and celadonite formed in massive basalts next to quartz-oligoclase micrographic intergrowths. Palygorskite was found in only one sample near the top of basement in Hole 458, but it too is associated with iron hydroxides. Palygorskite has previously been reported only in marine sediments in DSDP and other occurrences. It evidently formed here as a precipitate from fluids in which Si, Mg, Fe, and even some Al were concentrated. Experimental data suggest that the solutions probably had high pH and somewhat elevated temperatures. The compositions of associated smectites resemble those in hydrothermal sediments and in basalts at the Galapagos mounds geothermal field. The second stage of alteration was large-scale replacement of basalt by dioctahedral, trioctahedral, or mixed-layer clays and phillipsite along zones of intense fracturing, especially near the bottom of Holes 458 and 459B. The basalts are commonly slickensided, and there are recemented microfault offsets in overlying sediments. Native copper occurs in one core of Hole 458, but associated smectites are dominantly dioctahedral, unlike Hole 459B, where they are mainly trioctahedral, indicating nonoxidative alteration. The alteration in both holes is more intense than at most DSDP ocean crust sites and may have been augmented by water derived from subducting ocean crust beneath the fore-arc region.

Isotopic survey of diagenetic carbonates, at DSDP Leg 63 Holes

Authigenic carbonates, principally calcium-rich dolomites, with extremely variable isotopic compositions were recovered in organic-rich marine sediments during Leg 63 drilling off southern California and Baja California. These carbonates occur as thin layers in fine-grained, diatomaceous sediments and siliceous rocks, mostly deposited during the Neogene. A combination of textural, geochemical, and isotopic evidence indicates these dolomites formed as cements and precipitates in shallow subsurface zones of high alkalinity spawned by abundant CO2 and methane production during progressive microbial decay of organic matter. Depths and approximate temperatures of formation estimated from oxygen isotopes are 87 to 658 meters and 10°C to 50°C, respectively. Within any sedimentary section, dolomites may form simultaneously at several depths or at different times within the same interval. Highly variable carbon isotopes (-30 to +16 per mil) reflect the isotopic reservoir in which the carbonates formed. Oxidation of organic matter through microbial reduction of sulfate at shallow depths favors light-carbon carbonates such as those at Sites 468 and 471; heavy-carbon carbonates at Site 467 most likely formed below this zone where HC**12O3**- is preferentially removed by reduction of CO2 to methane during methanogenesis. An important controlling factor is the sedimentation rate, which dictates both the preservation of organic matter on the sea floor and depth distribution of subsurface zones of organic-matter decay.

Minerals of bulk samples and the fine-grained (<2-µm) fractions from DSDP Leg 67 Holes

Leg 67 sample sediments are mainly composed of biogenic carbonate and biogenic siliceous materials. Apart from calcite, crystallized minerals are scarce; however, they are better represented in sites near the continent and in all Quaternary sediments. These minerals are: quartz, feldspars, smectite, and, rarely, chlorite, dolomite, and zeolite.

Total organic carbon content and maceral composition of sediment at DSDP Holes 72-515B and 72-516F

The amount, type, and thermal maturation of organic matter in sediments from two DSDP holes in the South Atlantic (Leg 72) were investigated. Isolated kerogens were studied by microscopy, and nonaromatic hydrocarbons were characterized by capillary gas chromatography. Organic carbon values are low in all samples and range between 0.05 and 0.21% in Hole 515B (Brazil Basin) and only between 0.02 and 0.10% in Hole 516F (Rio Grande Rise). The organic matter is predominantly terrigenous, mixed with some unicellular marine algae; it is severely oxidized in most samples. N-alkane distributions are usually dominated by long-chain wax alkanes with odd-over-even carbon number predominance; when the marine organic matter is relatively more abundant, however, significant amounts of n-alkanes are centered upon n-C17. The organic matter is not mature enough in any sample to generate appreciable amounts of hydrocarbons.