(Table 2) Chemical composition of Fe-Mn nodules and volcanic glass in sediments of the Atlantic Ocean

Distribution pattern of titanium in Quaternary sediments of the Atlantic Ocean are examined on the base of 750 Ti and Fe determinations, and several dozen of complete chemical analyses. Analyses of surface sediment samples and sediment cores up to 6 m long were made. Stratigraphic levels from Middle Pleistocene to Holocene were identified from planktonic foraminifera. Distributions of Ti in recent and Pleistocene deposits were mapped. High titanium contents were found in sediments containing products of basalt vulcanism and in iron-manganese nodules. To determine origin of titanium concentrations in sediments, Ti/Fe ratios were calculated. Maximal values of this ratio were found in areas of basaltic volcanism and of intensive terrigenous sedimentation.

(Table 2) Salinity, pH, alkalinity and major ion concentrations in ANDRILL core AND-2A pore water

The compositional record of the AND-2A drillcore is examined using petrological, sedimentological, volcanological and geochemical analysis of clasts, sediments and pore waters. Preliminary investigations of basement clasts (granitoids and metasediments) indicate both local and distal sources corresponding to variable ice-volume and ice-flow directions. Low abundance of sedimentary clasts (e.g., arkose, litharenite) suggests reduced contributions from sedimentary covers while intraclasts (e.g., diamictite, conglomerate) attest to intrabasinal reworking. Volcanic material includes pyroclasts (e.g., pumice, scoria), sediments and lava. Primary and reworked tephra layers occur within the Early Miocene interval (1093 to 640 metres below sea floor mbsf). The compositions of volcanic clasts reveal a diversity of alkaline types derived from the McMurdo Volcanic Group. Finer-grained sediments (e.g., sandstone, siltstone) show increases in biogenic silica and volcanic glass from 230 to 780 mbsf and higher proportions of terrigenous material c. 350 to 750 mbsf and below 970 mbsf. Basement clast assemblages suggest a dominant provenance from the Skelton Glacier - Darwin Glacier area and from the Ferrar Glacier - Koettlitz Glacier area. Provenance of sand grains is consistent with clast sources. Thirteen Geochemical Units are established based on compositional trends derived from continuous XRF scanning. High values of Fe and Ti indicate terrigenous and volcanic sources, whereas high Ca values signify either biogenic or diagenic sources. Highly alkaline and saline pore waters were produced by chemical exchange with glass at moderately elevated temperatures.

Single non-normalized data of electron probe analyses of all glass shard samples from the Seward Peninsula and the Lipari obsidian reference standard

Permafrost degradation influences the morphology, biogeochemical cycling and hydrology of Arctic landscapes over a range of time scales. To reconstruct temporal patterns of early to late Holocene permafrost and thermokarst dynamics, site-specific palaeo-records are needed. Here we present a multi-proxy study of a 350-cm-long permafrost core from a drained lake basin on the northern Seward Peninsula, Alaska, revealing Lateglacial to Holocene thermokarst lake dynamics in a central location of Beringia. Use of radiocarbon dating, micropalaeontology (ostracods and testaceans), sedimentology (grain-size analyses, magnetic susceptibility, tephra analyses), geochemistry (total nitrogen and carbon, total organic carbon, d13Corg) and stable water isotopes (d18O, dD, d excess) of ground ice allowed the reconstruction of several distinct thermokarst lake phases. These include a pre-lacustrine environment at the base of the core characterized by the Devil Mountain Maar tephra (22 800±280 cal. a BP, Unit A), which has vertically subsided in places due to subsequent development of a deep thermokarst lake that initiated around 11 800 cal. a BP (Unit B). At about 9000 cal. a BP this lake transitioned from a stable depositional environment to a very dynamic lake system (Unit C) characterized by fluctuating lake levels, potentially intermediate wetland development, and expansion and erosion of shore deposits. Complete drainage of this lake occurred at 1060 cal. a BP, including post-drainage sediment freezing from the top down to 154 cm and gradual accumulation of terrestrial peat (Unit D), as well as uniform upward talik refreezing. This core-based reconstruction of multiple thermokarst lake generations since 11 800 cal. a BP improves our understanding of the temporal scales of thermokarst lake development from initiation to drainage, demonstrates complex landscape evolution in the ice-rich permafrost regions of Central Beringia during the Lateglacial and Holocene, and enhances our understanding of biogeochemical cycles in thermokarst-affected regions of the Arctic.

(Table 1) Interstitial water geochemistry at DSDP Leg 84 Holes

On DSDP Leg 84, drilling was conducted at three gas-hydrate-bearing sites on the Middle America Trench slope off Costa Rica (Site 565) and off Guatemala (Sites 568 and 570). At Site 569, on the mid-slope off Guatemala, hydrates may be present, according to the seismic profile (GUA-13), although the pore-water composition does not provide clear evidence. Sites 566 and 567, on the lower Guatemala Trench slope, appear to be free of hydrates, except in fractures of serpentinite at the bottom of Hole 566. Hydrate-bearing Sites 565, 568, and 570 show the effects of hydrate decomposition on pore-water chemistry that have been established during previous drilling at Sites 496 and 497 on the Guatemala Trench slope. These include a chlorinity decrease and d18O increase downsection. The new results, however, reveal more complex relationships between the chlorinity decrease and d18O increase than previously recognized. At Site 565, d18O values decrease in the middle section of the hole, whereas chlorinity continues to decrease from the top to near the bottom of the hole. Early diagenetic alteration of volcanic glass is suggested as a mechanism for the unexpected minimum in the O-isotope curve. Multiple fractionation by the pore-water/hydrate system is required to explain d18O-values greater than 2.7 per mil at the bottom of Hole 568, because with a fractionation factor of alpha = 1.0027, this is the maximum figure a single-stage fractionation could produce. In situ water samples from hydrate zones in most cases failed to display the elevated salinities expected for the residual pore waters not involved in hydrate formation. This is probably because the in situ sampling device still allows a systematic pressure drop sufficient to trigger hydrate decomposition in the immediate vicinity of the sample port.