Grain size distribution of Oligocene and Miocene sediments from the Indus Fan

The Owen Ridge south of Oman represents oceanic crust that was uplifted by compressional tectonic forces in the early Miocene. Build-out of the Indus Fan led to deposition of a thick sequence of turbidites over the site of the Ridge during the late Oligocene and early Miocene. Early Miocene uplift of the Ridge led to a pelagic cap of nannofossil chalks. Two short sequences of turbidites from the pre- and syn-uplift phases were chosen for detailed grain size analysis. The upper Oligocene section at Site 731 is composed of thin (centimeter-decimeter scale) graded mud turbidites separated by relatively thick (decimeter-meter scale) intervals of homogeneous, non-bioturbated clayey siltstones. These finer intervals are unusually silt-rich (about 60%) for ungraded material and were probably deposited as undifferentiated muds from a series of turbidity current tails. By contrast, the lower Miocene section at Site 722 is comprised of a sequence of interbedded turbidites and hemipelagic carbonates. Sharp-based silt turbidites are overlain by burrow-mottled marly nannofossil chalks. The Oligocene sequence may have accumulated in an overbank setting on the middle fan - the local topographic position favoring frequent deposition from turbidity current tails and occasional deposition from the body of a turbidity flow. Uplift of the Ridge in the early Miocene led to pelagic carbonate deposition interrupted only by turbidity currents capable of overcoming a topographic barrier. Further uplift eventually led to entirely pelagic carbonate deposition.

Grain size composition and age of ODP Hole 167-1017E sediments

Siliciclastic sedimentation at Ocean Drilling Program Site 1017 on the southern slope of the Santa Lucia Bank, central California margin, responded closely to oceanographic and climatic change over the past ~130 ka. Variation in mean grain-size and sediment sorting within the ~25-m-thick succession from Hole 1017E show Milankovitch-band to submillenial-scale variation. Mean grain size of the "sortable silt" fraction (10-63 µm) ranges from 17.6 to 33.9 µm (average 24.8 µm) and is inversely correlated with the degree of sorting. Much of the sediment has a bimodal or trimodal grain-size distribution that is composed of distinct fine silt, coarse silt to fine sand, and clay-size components. The position of the mode and the sorting of each component changes through the succession, but the primary variation is in the presence or abundance of the coarse silt fraction that controls the overall mean grain size and sorting of the sample. The occurrence of the best-sorted, finest grained sediment at high stands of sea level (Holocene, marine isotope Substages 5c and 5e) reflect the linkage between global climate and the sedimentary record at Site 1017 and suggest that the efficiency of off-shelf transport is a key control of sedimentation on the Santa Lucia Slope. It is not clear what proportion of the variation in grain size and sorting may also be caused by variations in bottom current strength and in situ hydrodynamic sorting.

(Table 1) Bulk and grain density, porosity, and p- and s-wave velocity characteristics of ODP Hole 163-990A sediments

Seismic velocities in rocks are influenced by the properties of the solid, the pore fluid, and the pore space. Cracks dramatically affect seismic velocities in rocks; their influence on the effective elastic moduli of rocks depends on their shape and concentration. Thin cracks (or fractures) substantially lower the moduli of a rock relative to the effect of spherical voids (or vesicles), and lower moduli are reflected by lower P- and S-wave velocities. The objective of this research is to determine the types and concentrations of cracks and their influence on the seismic properties of subaerially erupted basalts drilled from Hole 990A on the Southeast Greenland margin during Ocean Drilling Program Leg 163. Ellipsoidal cracks are used to model the voids in the rocks. The elastic moduli of the solid (grains) are also free parameters in the inverse modeling procedure. The apparent grain moduli reflect a weighted average of the moduli of the constituent minerals (e.g., plagioclase, augite, and clay minerals). The results indicate that (1) there is a strong relationship between P-wave velocity and porosity, suggesting a similarity of pore shape distributions, (2) the distribution of crack types within the massive, central region of aa flows from Hole 990A is independent of total porosity, (3) thin cracks are the first to be effectively sealed by alteration products, and (4) grain densities (an alteration index) and apparent grain moduli of the basalt samples are directly related.

Sediment organic matter, grain size, and results of prediction models from northern North Atlantic and Arctic Seas

Sediment samples and hydrographic conditions were studied at 28 stations around Iceland. At these sites, Conductivity-Temperature-Depth (CTD) casts were conducted to collect hydrographic data and multicorer casts were conductd to collect data on sediment characteristics including grain size distribution, carbon and nitrogen concentration, and chloroplastic pigment concentration. A total of 14 environmental predictors were used to model sediment characteristics around Iceland on regional geographic space. For these, two approaches were used: Multivariate Adaptation Regression Splines (MARS) and randomForest regression models. RandomForest outperformed MARS in predicting grain size distribution. MARS models had a greater tendency to over- and underpredict sediment values in areas outside the environmental envelope defined by the training dataset. We provide first GIS layers on sediment characteristics around Iceland, that can be used as predictors in future models. Although models performed well, more samples, especially from the shelf areas, will be needed to improve the models in future.

Grain size distribution and clay mineralogy of upper Miocene sediments of ODP Hole 107-652A

The upper Miocene sedimentary sequence of Site 652, located on the lower continental margin of eastern Sardinia, was cored and logged during Ocean Drilling Program (ODP) Leg 107. Geophysical and geochemical logs from the interval 170-365 m below seafloor (mbsf), as well as various core measurements (CaCO3, grain size, X-ray diffraction), provide a mineralogical-geochemical picture that is interpreted in the framework of the climatic and tectonic evolution of the western Tyrrhenian. The results indicate the presence of short- and long-term mineralogical variations. Short-term variations are represented by calcium-carbonate fluctuations in which the amount of CaCO3 is correlated to the grain size of the sediments; coarser sediments are associated with high carbonate content and abundant detrital material. Long-term variation corresponds to a gross grain-size change in the upper part of the sequence, where predominantly fine-grained sediments may indicate a gradual deepening of the lacustrine basin towards the Pliocene. Regional climatic changes and rift-related tectonism are possible causes of this variability in the sedimentation patterns. The clay association is characterized by chlorite, illite, and smectite as dominant minerals, as well as mixed-layers clays, kaolinite, and palygorskite. Chlorite, mixed-layers clays, and illite increase at the expense of smectite below the pebble zone (335 mbsf). This is indicative of diagenetic processes related to the high geothermal gradient and to the chemistry of the evaporative pore waters, rather than to changes in the depositional environment.

Age model and grain size distribution of the fine fraction of ODP Site 114-704

The physical properties of sediments beneath an upwelling area in the southern part of the Atlantic Ocean (ODP Hole 704A) were investigated. Highly significant correlations characterize the relationship of carbonate content to bulk density (R = 0.85), carbonate content to porosity (R = 0.84), and carbonate content to impedance (R = 0.84). No relationship exists between carbonate content and compressional-wave velocity (R = 0.24), indicating that amplitude variations in impedance are primarily controlled by variations in bulk density, which, in turn, are controlled by climatically driven biogenic opal and carbonate deposition. In general, maxima in impedance correspond to maxima in carbonate content (minima in opal content). The impedance record exhibits its most drastic change at about 2.4 Ma, marking dramatic increases in the average content of biogenic opal and the beginning of large-amplitude fluctuations. Between 0.7 and 0.4 Ma carbonate content, bulk density, and grain density decrease while opal content drastically increases. Similar changes have been observed in sediments beneath an upwelling cell off northwest Africa, indicating an oceanwide enhancement in upwelling or in the calcite corrosiveness of bottom water that appears to be isochronous.

Grain characteristics and XRD raw data of ODP Sites 162-981 and 162-984

Multisensor track data, including magnetic susceptibility, gamma-ray attenuation porosity evaluator (GRAPE) wet bulk density, and natural gamma emission, were collected on all cores recovered during Ocean Drilling Program Leg 162. Data from the upper Pliocene and lower Pleistocene of Sites 981 and 984 are here compared to results from analyses of a limited set of discrete samples, including benthic foraminiferal isotopic composition, grain size, carbonate content, abundance of foraminifers and lithic particles, and clay mineralogy. Natural gamma emission most closely monitors the input of felsic terrigenous material to these two sites. Magnetic susceptibility also tracks felsic terrigenous input at Site 981 but appears to reflect a separate, more mafic, terrigenous component at Site 984. The GRAPE record does not correlate well with any discretely measured variable at Sites 981 or 984.

14C ages, grain size distribution and foraminifer abundance of sediments from the Barents Sea shelf

The origin of friable sediments blanketing the Barents Sea shelf is considered. It is shown that their characteristic seismoacoustic record patterns reflect low degree of diagenetic transformations and indicates continuous sedimentation. According to traditional views, this single sedimentary complex also includes diamicton, and the section is interpreted as a three-unit structure: diamicton, which is considered a till; the overlying friable sediments accumulated under different conditions of deglaciation in glaciomarine settings; and the postglacial marine sediments. It is demonstrated that such views are inconsistent with geomorphologic features (datings by physical methods included) indicating a prolonged hiatus that separates epochs of the diamicton accumulation and formation of friable sediments. The analysis revealed that the composition, vertical succession, and lateral distribution of different lithological types of friable sediments are related to the regular spatiotemporal replacements of different facies settings in the transgressing Arctic sea rather than by the glacial process. This inference is confirmed by the composition of foraminiferal assemblages.